質壁分離 的英文怎麼說

中文拼音 [zhíbìfēnlí]
質壁分離 英文
plasmolysis
  • 質 : Ⅰ名詞1 （性質; 本質） nature; character; essence 2 （質量） quality 3 （物質） matter; substance;...
  • 壁 : 名詞1 （墻） wall （of a house etc ） : 銅墻鐵壁 bastion of iron2 （作用像圍墻的部分） wall of st...
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 離 : Ⅰ動詞1 （離開） leave; part from; be away from; separate 2 （背離） go against 3 （缺少） dispens...
  1. An increase in hydrogen ions within cell walls would decrease ionization of carboxyl groupings of the cellulosic fraction.

    細胞壁內部氫離子濃度的增高，能夠降低部分纖維質羧基的離子化作用。
  2. According to medical research, when vitamin b12 enters the body, it forms a compound with an intrinsic factor secreted by the parietal cells large cells of the peptic glands on the gastric mucosa mucous membrane of the stomach, before being absorbed by receptors in the ileum lower part of the small intestine in the presence of calcium ions

    在維他命b12的吸收方面，根據醫學報導，維他命b12在吃進人體后，首先會在胃部，和胃壁細胞parietal cells分泌的一種蛋白質內因子intrinsic factor結合，形成復合物后，再由小腸段中的回腸ileum吸收。在回腸之接受體receptors吸收時，需要有鈣離子之存在。
  3. As water continues to diffuse from the cytoplasm into the sea water, the cells gradually shrink. this condition is known as plasmolysis.

    隨著水不斷地從細胞質擴散到海水中去，細胞逐漸皺縮，這種情況稱為質壁分離。
  4. The basic concept of siw is that it use the top and bottom layers of metal together with two row of vias is very small compared with wavelength, the dissipation loss of radiation is very small. it acts like a rectangular waveguide filled with some dielectrics, so components which can be composed by rectangular waveguide can also composed by siw such as antenna, filter, power divider, coupler, resonator

    基片集成波導的基本概念是利用基片的上下金屬板和兩排間隔一定距離的金屬孔構成波導的金屬壁，由於每排金屬孔孔間距遠小於波長，因此由縫隙泄漏的能量很小，這相當于內部填充了介質的矩形波導，所以能夠用矩形普通波導實現的結構也都可以用基片集成波導來實現，比如功分器、濾波器、天線、耦合器、振蕩器等。
  5. This article aims at the boiler ' s problems in operation : 1 ) under nominal load, the smoke temperature at the outlet of hearth reaches 1200, far more exceeds 1050 the original designed temperature. this will always result in slag inside boiler and the temperature of overheater ' s pipe superheat, so that boiler cannot take nominal load and all these influence boiler ' s nomal operation heavily, 2 ) this article also studied the reason why the assistant oil becoming necessary when coal changes. during the nomal operation, many factors ( makeup of combustor and its disposal, smirch and encrust of water wall, excessive air coefficient, temperature of primary air, coal type and density of coal dust ) can deviate the designed working conditions, then affect the boiler ' s nomal operation

    本文針對該鍋爐在實際運行中存在的問題：在額定負荷下，爐膛出口超溫、低溫段過熱器前煙溫高達936 ，遠遠超過815的設計值；噴燃器四周水冷壁結焦嚴重，過熱器管壁溫度超標，無法帶上額定負荷；甚至有時因燃煤質量的變化，必須投油助燃的嚴重情況進行了分析研究。在實際生產過程中，燃燒器的結構、布置，水冷壁的粘污、結垢，過剩空氣系數、一次風溫、煤種及其濃度變化等許多因素都會偏離鍋爐的設計工況，從而影響爐內的傳熱和燃燒，造成爐膛出口超溫、水冷壁結渣等問題。
  6. Shrinkage or contraction of the protoplasm away from the wall of a living plant or bacterial cell, caused by loss of water through osmosis

    胞質皺縮通過滲透作用由於缺水引起的活植細胞或細菌的細胞質的皺縮或收縮，並與細胞壁分離
  7. Thin sections of host leaf cells infected by bbwv - 2 isolate b935, which were gold - labeled by antibodies of bbwv - 2 coat protein ( cp ) and vp37, respectively, were prepared to elucidate the locations of vp37 in cell and possible function of vp37 and cp in cell to cell movement. observation in electron microscope showed that virus particles were presented not only in cytoplasma but also in chloroplast, while vp37 was existed only in cytoplasma and associated with tubular structure through the cell wall

    為研究vp37在寄主細胞中的作用機制及其在細胞中的分佈，通過膠體金間接標記6his - vp37兔抗血清，同時還標記了病毒的外殼蛋白單克隆抗體，對bbwv - 2分離物b935感染的病葉超薄切片的電子顯微鏡觀察發現：病毒粒子除了聚集在胞質中，還存在於寄主的葉綠體內； vp37蛋白能在細胞壁上形成管狀結構，在胞質中亦有分佈。
  8. Based on these observations, we isolated protoplasts from female germ unit and performed extracellular ca2 + influx experiment in order to check whether the cytological event similar to what happens during fertilization will be induced by extracellular ca2 + influx

    表明細胞壁的合成是受精后早期發生的細胞學事件。在此基礎上，我們分離了胚囊細胞的原生質體。通過外源導入鈣離子檢查鈣能否引發類似受精過程發生的細胞學事件。
  9. Owing to its thin wallow resistance, high void and capacity, metallic packings have a high separation efficiency, and applied to handle the thermal sensitive, hard to sepoaration and easy carbonized materials in the vacuum rectify9ing tower

    金屬填料材質主要包括碳、鋼、鋁合金及不銹鋼等.由於其壁、空隙率大、通量大、阻力小、分離效果好.特別適用於真空精餾塔，處理熱敏性，易分解、易結碳的物料
  10. By means of similar simulation, lateral abutment pressure distribution and concentration degree which at the face of the upper coal, the distance between peak stress and coal surface, the influence circle of abutment pressure, and the transfer and weakening of concentrated pressure at the bottom side are analyzed on actual geology data in pingdingshan 8th mine f15 and f ( subscript 16 - 17 )

    摘要採用相似模擬的方法，以平頂山八礦己二采區己15和己（下標16 - 17 ）煤層實際地質資料為基礎，分析了近距離煤層上煤層開采時，在上煤層采場兩側向的支承壓力分佈及集中程度、峰值距煤壁的距離、支承壓力的影響范圍；一定范圍內底板中集中應力的傳遞及漸衰減特徵。
  11. The current obstacles to the " 3 - cross " mode consist of regional barriers, industry barriers, capital barriers and ownership barriers, which can only be overcome by starting a series of breakthroughs in theory, policy and mechanisms, including such system reforms as re - consideration of media ' s dual attributes, division of ownership, classified management of media and separatio

    目前制約媒介「三跨」的主要是區域壁壘、行業壁壘、資本壁壘和產權壁壘，而要突破這層層壁壘，必須依靠從理論、政策到機制的一系列突破，包括重新認定傳媒的雙重性質、明晰產權、對傳媒實行分類管理、編營分離的機制改革等。
  12. The effects of the two methods of " sucking - spouting " water and flow - deflection on the horizontal circulation were tested experimentally in a 50cm - width flume with a spur dike placed as a barrier

    可以把主流的一部分能量傳給邊界層內靠近壁面的流體質點，使之加速，從而達到防止邊界層分離的目的。
  13. Methods : isolated rabbit bmsc by adhesion method and cultured it at 37c, 5 % co2 incubator. graphic the growth curve after observed the growth of primary cells and passage cells. cultured bmsc in calcified solution and observe its potential of osteogenic

    方法：貼壁法分離第四軍醫大學碩士學位論文兔骨髓基質幹細胞， 37 ， 5 % co :培養箱培養，觀察原代及傳代細胞的生長發育情況，並繪制生長曲線;在礦化液中連續培養，觀察其骨形成能力。
  14. The first task in separation of subcellular components is always the rupturing of the cell wall and the protoplasmic membranes.

    分離亞細胞組成的第一步總是使細胞壁和原生質膜破碎。
  15. At the preliminary stage of burning the gas flows along the back surface of the submerged nozzle and no recirculation forms in the aft - end cavity. at the medium stage of burning a weak recirculation forms in the rear of aft - end cavity by the force of injection flow. at the end stage of burning the flow separates at the c ombustion channel and a strong vortex forms in the aft - end cavity

    實驗結果表明，在發動機工作過程中隨著燃面的退移，燃燒室尾部的流動會發生很大變化，初始時刻背壁區加質流沿噴管背壁進入噴管，背壁區沒有迴流形成；中間時刻在加質流的驅動下背壁區後部形成較弱的迴流；結束時刻氣流在燃燒室壁面分離，背壁區形成強烈的迴流。
  16. On the other hand, the influence of the solid wall on the saturation thermodynamic parameter of argon under microscale condition was studied. a potential function was introduced and the problem of collision between molecules of argon and molecules in solid wall were dealed with. it is concluded that : when the scale of fluid argon is only one or two om larger than the effective distance between the solid wall and the molecules of argon, the scale of fluid argon and the molecules of solid wall have remarkable effect on the thermodynamic saturated properties of argon

    同時，本文還研究了在微尺度下固壁面對氬的飽和熱力學性質的影響，本文應用了一種氬分子與固壁面分子相互作用的勢函數，並研究了氬分子和固壁面分子相互碰撞的問題，研究表明：當氬流體的空間尺度只比固壁面對流體分子的有效作用距離大1 ~ 2個數量級時，尺度效應和固壁面分子的作用會影響氬的飽和熱力學性質。
  17. Results from this investigation show that the loss generation within the coolant holes is substantial and that ejection into regions of low static pressure increases the loss per unit coolant mass flow. the results also reveal strong interactions between endwall coolant ejection and secondary flow in the blade passage. the secondary flow has a strong influence on coolant trajectories and coolant ejection delays the three - dimensional separation of the inlet boundary layer on the endwall, chang the secondary flow and reduces its associated losses

    本文的研究成果顯示，冷卻孔內產生的損失是主要的，並且低靜壓區域的冷空氣噴射會增加單位冷空氣質量流的消耗；噴射的冷空氣與葉柵端壁流場之間有強烈的相互作用；二次流對冷卻空氣的流動軌跡有較強的影響；冷空氣噴射能延緩端壁入口邊界層的三維分離、改變二次流從而減少其相關損耗。
分享友人
分享到 Line

分享到臉書