超始溫度 的英文怎麼說

中文拼音 [chāoshǐwēndù]
超始溫度 英文
initial temperature
  • 超 : Ⅰ動詞1 （越過; 高出） exceed; surpass; overtake 2 （在某個范圍以外; 不受限制） transcend; go beyo...
  • 始 : Ⅰ名詞1 （最初; 起頭） beginning; start 2 （姓氏） a surname Ⅱ動詞（開始） start; begin Ⅲ副詞[書面...
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 溫度 : [物理學] temperature
  1. But the temperature difference at the vertical direction in combustion chamber in lead column, that is said by operator, is over 60 ?. ( 2 ) according to the experiences in the practice, the second layer air and the second layer gas had a little effect of support burning, and the third air has little effect for combustion, and the power to drawing exhaust gas can only be adjusted in limited range. the problems, it is said above, restricted more advance of some kinds of technology and economy target in spelter refining in new jersey furnace

    由於鋅精餾爐產量提高，一些問題開始暴露出來： （ 1 ）燃燒室?舶要求溫度差不超過10 ，而從現場反映的情況來看，燃燒室上、中、下部溫度差已超過60 ； （ 2 ）在生產實踐中，發現燃燒室第二層空氣、第二層煤氣作用甚小，第三層空氣失去助燃作用，廢氣出口的抽力可調范圍有限；以上這些問題在客觀上制約了精餾塔在鋅精煉中各項技術經濟指標的進一步提高。
  2. That means the controlled temperature al1ow waving in a range in a period. when the change of the temperature indoor is out of the range we enacted, the system begin to regulatc. compensate the windage last time leave behind } before decide the heatsupply parameter for the next time

    即允許被控室內溫度在一段時間內存在一定幅度的波動，當室溫變化幅度超過設定值時系統開始調節，在確定下一時間段的供熱參數之前對上一時間段的遺留偏差在短時間內給予補償。
  3. Through research, the organic matter of source rocks in carboniferous - permian coal measure strata began first hydrocarbon - generating in mesozoic, and the first hydrocarbon - filling took place. but, because of yanshan movement later, the carboniferous - permian strata rose, as a result, the first hydrocarbon - generating and reservoir - forming paused ; in early tertiary period, because carboniferous - permian strata dipping forward east originally turned into dipping forward west, the prototype of faulted block began to form gradually ; by the end of sha - 3 period of early tertiary, the paleogeotherm of carboniferous - permian strata exceed the mesozoic ' s temperature again, and accordingly, abundant hydrocarbon was generated and expulsed secondly. the trap continued to develop ; from the end of late tertiary to quaternary, the second hydrocarbon - generating and expulsing got to its peak, and the second reservoir - forming was over

    研究表明，本區石炭?二疊紀烴源巖在中生代發生一次生烴和排烴，並有油氣充注，后因燕山運動導致地層抬升，一次生烴和成藏過程中止；在早第三紀，原來東傾的地層變為西傾，斷塊圈閉開始具雛形；至早第三紀沙二末期，石炭?二疊系的大部分地層古地溫再次超過中生代一次生烴的溫度，開始二次生烴和排烴，圈閉持續發育；晚第三紀末?第四紀，二次生烴、排烴達到高峰，二次成藏完成。
  4. Good alkali resistance, dissolved only in hot strong acid, good thermal endurance ; it begins to decompose into red pigment when losses water of crystalliza - tion under temperature higher than 150

    耐堿性、耐于熱熱的強酸，耐熱度較高，溫度超過150以上失去結晶水開始分解為紅色顏料。
  5. The superplastic behavior of tc6 titanium on the condition of different temperature and different strain rate was explored

    本文對不同初始應變速率和變形溫度條件下tc6鈦合金的超塑性變形行為進行了系統研究。
  6. The effects of temperature and strain rate were analyzed too. furthermore, the tensile fracture surface of tc6 titanium was analyzed by sem

    分析了tc6鈦合金在變形過程中不同變形溫度、初始應變速率對流變應力的影響規律，並且對變形溫度、初始應變速率在tc6鈦合金超塑性變形中的顯著性進行了探討。
  7. Secondary radiator : when the temperature does not exceed the set temperature, the secondary radiator operates at low speed, and the fan icon on the lcd panel will rotate

    次要散熱裝置:當溫度超越實質溫度時，次要散熱裝置開始以低速運做，風扇標志出現在液晶面板上
  8. Results show that the levitation force is generated between the high temperature superconductor and the magnetic field under the critical temperature. the value of the levitation force is determined by the temperature and the gradient of magnetic field. that is the smaller of the gap, the larger of the levitation force when the temperature is fixed, and the value of the levitation force is an exponential function of the gap

    研究表明，當高溫超導體的溫度低於其臨界溫度時，在磁場中開始受到力的作用；受到的懸浮力大小由溫度和磁場梯度共同決定；即溫度一定時，懸浮間距越小，對應的磁場梯度越大，懸浮力就越大，力的大小與懸浮間距成指數關系；而當懸浮間距一定時，溫度越低，對應的懸浮力也越大，且超導體剛進入超導態的一段溫度區間懸浮力增大最快。
  9. The starting oxidation temperature of copper powders prepared by hydrothermal method is about 210 and average particle size is about 0. 7 m

    採用此參數可得到平均粒度為0 . 7 m ，分佈狹窄，開始氧化溫度約為210的超細銅粉。
  10. Both hydrogen plasma and sinx thin film can effectively enhance the short circuit current density of mono and poly silicon solar cells, which cause the improvement of the absolute transfer efficiency about 0. 5 % ~ 2. 9 %. depositing sinx thin film followed by hydrogen plasma treatment will result in better passivation effect. the thickness of sinx thin film will decrease and the refractive index will increase after annealing

    經過薄膜後退火處理發現，氮化硅薄膜經熱處理后厚度降低，折射率升高，但溫度達到1000oc時折射率急劇降低；沉積氨化硅薄膜后400oc退火可以促進氫擴散，提高鈍化效果；超過400oc后氫開始逸失，晶體硅材料中的少子壽命急劇下降； rtp （快速熱處理）處理所導致氫的逸失比常規退火處理顯著。
  11. Finally, eels and aes were combined to study initial oxidation processes of uranium, niobium and uranium - niobium alloys in an ultra - high vacuum chamber at the temperature of 373k, 473k, 573k and 673k

    最後，還利用eels和aes研究了超高真空下不同溫度（ 373k 、 473k 、 573k和673k ）時鈾、鈮及鈾鈮合金的初始氧化過程。
  12. The relaxation resistance of the nitinb alloy affects the strength of the nitinb pipe coupling at high temperature, so that the relaxation experiment at various temperatures and various initial stresses was preformed to investigate the relaxation resistance of the nitinb alloy. the results show that nitinb alloy has good relaxation resistance in the temperature range 300 ~ 400c and the initial stress range 260 ~ 360 mpa, therefore the nitinb pipe coupling can work safely under the condition of temperature above 300c and initial stress no more than 360mpa

    Nitinb合金的抗鬆弛性能必將影響nitinb管接頭的高溫強度，於是首先對nitinb合金在不同溫度不同初始應力下的抗鬆弛性能進行了研究，結果表明：溫度在300 400 ，初始應力在260 360mpa時， nitinb合金抗應力鬆弛性能良好，用其制備的管接頭能在溫度不超過300 、應力不超過360mpa的條件下安全地工作。
  13. Polymer - network gel process was used to synthesize nanometer oxide such as zro2 ( 3. 5mol % cao ), co3o4 and nio. dta / tg, xrd and tem were used to characterize the gel and products, and determine the lowest temperature and time for calcining the gel. the effect of the concentration of starting solution, temperature and time for calcining the gel on the size of the products were also discussed

    本文採用高分子網路凝膠法進行納米zro _ 2 （ 3 . 5mol cao ） 、 co _ 3o _ 4 、 nio等納米氧化物超細粉的軟化學合成，利用dta tg 、 xrd和tem等分析手段對凝膠和產物超細粉進行表徵，確定凝膠的最低煅燒溫度和煅燒時間，並探討起始無機鹽溶液濃度、凝膠的煅燒溫度和煅燒時間對產物超細粉粒徑的影響。
  14. Xrd and tem patterns showed that superfine powders of namometer oxide, 15 ~ 98nm ca., even and without hard agglomeration, can be synthesized by this method, what ' s more, the size of the powders will be increased as the increasing of the concentration of starting solution, temperature and time for calcining. so products with needed size can be synthesized by choosing the appropriate conditions

    產物超細粉的xrd和tem圖譜表明，該方法可以合成粒徑為15 98nm左右、分佈較為均勻、沒有明顯硬團聚的納米氧化物超細粉，而且其粒徑會隨起始溶液濃度的增加、凝膠煅燒溫度的升高和煅燒時間的增加而增大。
分享友人
分享到 Line

分享到臉書