載荷屈服曲線 的英文怎麼說

中文拼音 [zǎihéqūbìqūxiàn]
載荷屈服曲線 英文
load-yield curve
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 荷 : 荷名詞（蓮） lotus
  • 服 : 服量詞（用於中藥; 劑） dose
  • 曲 : 曲名詞1 （一種韻文形式） qu a type of verse for singing which emerged in the southern song and ji...
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 載荷 : load; loading載荷變化 load fluctuation; variation in load; 載荷裝置 load device
  • 曲線 : [數學] curve; bight; bought; profile; net曲線板 french curve; irregular curve; curve board; splin...
  1. Through comparing and analyzing of bearing capacity, development of crack and strain of reinforced, the results show that the load - deflection plots f or specimens from the finite element analysis agree well with the experimental data, and choosing the rightful stress - strain relationship, utilizing ansys program, the test process can be well simulated. at the same time, making used of the program, the traditional shear wall is analyzed. it shows that comparing with the traditional shear wall, the hollow shear wall ' s cracking load drop 16 %, yield load and failure load drop 13 %, stiffness drop 13 % ~ 22 %

    其次在試驗的基礎上，將試驗手段、有限元數值模擬方法和理論分析結合起來，利用有限元程序ansys對其中的兩片墻板進行非線性有限元分析，並對前後的承載性能，裂縫發展、鋼筋應變進行了比較和分析，結果表明有限元節點模型分析的荷載-位移曲線和試驗測得數據符合良好，選用合理的材料本構模型，利用ansys可以較好的模擬試驗過程；同時利用有限元模型對比分析了普通剪力墻和空心剪力墻，空心剪力墻與普通剪力墻對比，其開裂荷載下降16 ，屈服荷載、極限荷載下降13 ，剛度下降13 22 ，開裂至屈服、屈服至極限荷載階段的剛度衰減規律與普通剪力墻基本一致，空心剪力墻的後期剛度比較穩定。
  2. Nonlinear constitutive relations are discussed for analyzing the stress distribution, the appearance and development of the cracks, as well as the behavior of the boundary conditions of the two way slabs respectively. in the light of the experimental research on r. c. two way slabs under static loading, the behavior of yield line, the load deformation curves and the crack yield, plastic limit loads of slabs with different supporting conditions are studied

    根據反映雙向板混凝土材料非勻質性的本構關系，分析了雙向板在荷載作用下的變形、屈服、裂縫和破壞的形態特性，並對鋼筋混凝土雙向板在不同支承條件下的塑性極限荷載、正常使用撓度（曲線）和截面設計作了進一步研究。
  3. At first, the experiment carried out by tianjin university has been analysed according to the " nonlinear balance trying calculation " method, and the values of yield load and ultimate load agree with the test result better, and the curve of bending moment - curvature, bending moment - deflection can agree with the results. the second, the simplified formula for evaluation the ultimate flexural capacity of cfrp strengthened rc members is presented according to the three probable failure modes ( compression failure ; cfrp rupture ; crushing of the concrete in compression before yielding of the reinforcing steel ). it is applicable to both singly and doubly reinforced rectangular sections, as well as flanged sections

    首先利用鋼筋混凝土非線性平衡試演算法對天津大學試驗進行了理論分析，所得分析值與試驗結果相比，加固梁的屈服荷載、極限荷載能夠很好地吻合，彎矩曲率關系曲線及彎矩撓度關系曲線較為吻合；其次，為了滿足實際工程的需要，根據碳纖維布加固構件可能發生的三種破壞形態（壓區混凝土壓碎破壞、碳纖維布拉斷破壞以及受拉鋼筋尚未屈服時壓區混凝土已壓碎破壞） ，區別三種鋼筋混凝土構件截面形式（單筋矩形截面、雙筋矩形截面、 t形截面） ，分別給出了碳纖維布加固混凝土構件抗彎承載力的簡化計算公式和適用條件，並進一步探討了這三種截面形式下進行加固設計和復核的步驟。
  4. Speaking in detail, for every specimen, we study the for of the cracking load, yield load and failure load ; the ductility property ; the property of hystersis curvs and keleton - frame curves ; the degree of initial stiffess and stiffness degadation. secondly, the two different suo nlgn use ltslaences ， wmcn are ootll shear wsll sttllctlllt ， are tab6n as instanop the shear ’ wsi is oin 卜 hot8qopo inww 田 l ！ s ot 以 j 口 willo 地 勸 憂 地 epo o odod sqo8qopt solidndls ofr c l w means or0 卜 0nm elemem ana 吹 lsptwtodd ’ mlmwe m 加 柏 mm are d an 邑 以 胡 a ann compcomparen in severm es 叮 wsllcll as scu 一 陽 i 朗 l p 一 ndnd mdede so ess d laterm seimic e anu so on ’ inatty ， tiep 訓 頒 oility of hollow shear wal of rc in d suo ra use reslaences s ant l

    首先研究在低周反復水平加載試驗下試驗對象的強度、變形和能量的特性：開裂荷載、屈服荷載、破壞荷載；各試件的滯回曲線和骨架曲線；延性情況；初始剛度和剛度退化等參數：進而用satwe有限元程序分析對比了某一小高層剪力墻結構在採用空心剪力墻板和採用普通實心剪力墻作為墻體的結構受力異同點，在質量、主振型、剛度、水平地震效應等方面做了對比。
  5. In the test, two frames with the same size which is one - half of the reality frame ' s size and the same reinforcement were designed and made firstly. one frame is made of schsc named sf ; the other is made of nhsc named nf. secondly, the mts loading system was used to put the two frames under low - cyclic loading

    實驗結果表明：自密實混凝土框架正向屈服荷載、極限荷載和破壞荷載均較普通混凝土的大而其相應的位移卻相當；兩榀框架的破壞形式都是彎曲破壞，且兩者荷載-位移的滯回曲線與骨架曲線非常相似；自密實混凝土框架的延性系數略高於普通混凝土框架，兩者的耗能能力基本相當。
  6. On the other hand, they have been put into use in practical engineering in large scale. in this paper, beam - column joints strengthened with cfs have been study systematically. based on the experiments of five full - scale beam - column joints ( two non - seismic joints, one seismic joints and two non - seismic joints strengthened with cfs ) subjected to lateral cyclic load, the failure mode, ultimate capacity, hysteretic behavior, ductility factor etc. are compared and analyzed

    試驗中對5個足尺樑柱中節點試件（ 2個非加固試件、 1個抗震試件、 2個加固試件）施加了低周反復荷載的試驗，分析比較了非抗震節點、抗震節點和cfs加固節點在滯回曲線、屈服荷載、極限荷載、延性系數、耗能系數等抗震性能上的差異。
  7. ( 3 ) using yielding line theory, we educed ultimate capacity of slab - column connection which was bend destroy under vertical load, vertical load and unbalanced bend in the text

    （ 3 ）利用屈服線理論，推導出豎向荷載作用下、豎向荷載和不平衡彎矩共同作用下板柱節點發生彎曲破壞時的極限承載力。
  8. ( 3 ) reinforced concrete frame columns modeled by using three - dimensional solid element to concrete and three - dimensional bar to reinforcing steel bar, and at the same time consideration the adhesive bond between reinforcing steel bar and concrete, the fem is used. by choosing reasonable element, determining mesh division and load steps, simulation of load - displacement, cracking, yielding and ultimate load, crack development history, and calculating fail crack diagram of reinforcement concrete frame columns under laterally monotonic load are conducted. the analyses are compared with the experimental results

    （ 3 ）混凝土用三維實體單元、鋼筋用空間桿單元對鋼筋混凝土框架柱進行三維建摸，而且同時考慮了鋼筋和混凝土的粘結性能，通過合理的單元選取、網格劃分及荷載步的確定，模擬了單調荷載作用下鋼筋混凝土框架柱的荷載啦移曲線、開裂荷載、屈服荷載及最大荷載、裂縫發展規律、計算破壞裂縫圖，並與相應的試驗結果進行了比較分析。
  9. Eventually, the rehabilitated specimens were retested under low cyclic loading. the loads and displacements of the beam end as well as the steel or plate strain were measured in detail ; and furthermore, crack patterns and failure model of the specimens were also observed during the test

    在對試驗結果的整理分析后，本文對比研究了加固前後以及用不同加固方法加固的試件的開裂荷載、屈服荷載和極限承載力、梁端荷載?轉角滯回曲線及其包絡線特徵、延性和耗能性能。
分享友人
分享到 Line

分享到臉書