輸入反射系數 的英文怎麼說

中文拼音 [shūrùfǎnshèxìshǔ]
輸入反射系數 英文
input reflection coefficient
  • 輸 : Ⅰ動詞1 （運輸; 運送） transport; convey 2 [書面語] （捐獻） contribute money; donate 3 （失敗） l...
  • 入 : Ⅰ動詞1 （進來或進去） enter 2 （參加） join; be admitted into; become a member of 3 （合乎） conf...
  • 反 : Ⅰ名詞1 （方向相背） reverse side 2 （造反） rebellion 3 （指反革命、反動派） counterrevolutionari...
  • 射 : Ⅰ動詞1 （用推力或彈力送出） shoot; fire 2 （液體受到壓力迅速擠出） discharge in a jet 3 （放出） ...
  • 系 : 系動詞（打結; 扣） tie; fasten; do up; button up
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 輸入 : 1 （從外部送到內部） import 2 [電學] input; entry; entering; in fan; fan in; 輸入變壓器 input tra...
  • 系數 : [數學] coefficient; ratio; modulus; quotient; factor
  1. The equation of the radiation transfer between two surfaces indicates that there are three factors that have influence on radiation transfer : brdf, projected solid angle ( psa ), and incident radiation flux. thereafter, a new baffle system design idea is put forward

    本文首先介紹了光學系統雜光的抑制措施，從光輻射在兩個表面傳遞的基本能量傳輸方程出發，指出影響輻射能量傳輸的三個因子：雙向反射分佈系數brdf 、投影立體角psa和入射輻射通量。
  2. In the study of directional spectrum and reflection coefficient of multidirectional wave, firstly the wave elevation trains overlapped by the incident wave and the reflected wave of multidirectional wave are simulated in the method of a frequency corresponding to a direction. then the composed wave trains are analyzed respectively by the mbdm and the mmlm. during the numerical study, the input factors include the various wave parameters, the different measuring wave system and the various reflect characteristic

    在多向不規則波入射波方向譜和反射系數的分析研究中，利用方向頻率對應法模擬了多向不規則波入射波與反射波疊加的波面序列，將此合成波列分別應用mbdm和mmlm進行分析，通過輸入各種波浪參量、不同波浪測量系統和各種反射特性等因子，檢驗了mbdm和mmlm方法的適用條件，對兩種分析方法的性能進行了比較分析。
  3. The antenna gain, directivity and reflection coefficient are calculated via finite element method in hfss. spline interpolation and polynomial curve fitting are applied to construct diagrams illustrating the capsulation characteristics. some general conclusions of interest are obtained

    探討了各個封裝參數對輸入端反射系數、方向性系數、效率和增益等性能指標的影響，得到一些規律性結論，為射頻振子天線的封裝應用提供了參考性的建議，並指出了進一步研究的方向。
  4. In the section 2, firstly based on the diffusion approximation theory, the temporal characteristics of the reflectance and the transmittance were theoretically analyzed in turbid tissues ; secondly, the curves were simulated that the intensity and the pulse shape of the time resolved reflectance and transmittance versus the absorption a, the scattering s and the anisotropy coefficient g in two different boundary conditions : semi - infinite turbid media and homogeneous slab ; at last, the optical properties can be derived from the curves ; in the section 3, the conditions of ultra short laser pulses of different pulse - width and shapes has been theoretical analyzed and calculated, besides, the simulated the curves of the intensity and pulse shapes of the reflectance and transmittance in a homogeneous slab are obtained for use and future studying

    第二章中首先根據漫射近似理論對超短脈沖在以生物組織為典型的混濁介質中傳輸進行了理論分析，然後對兩種邊界條件下產生的漫反射、漫透射光脈沖強度和形狀隨各光學特性參數的變化情況進行了數值模擬，最後得到了混濁介質的光學特性參數與漫反射、透射脈沖強度與形狀的關系曲線。第三章對不同形狀和脈寬的脈沖光源入射到混濁介質中產生的漫反射、漫透射脈沖的強度和形狀進行了理論分析和數值模擬，並將高斯脈沖與方波脈沖情況進行了對比，得到了各種情況的漫反射、漫透射脈沖強度、形狀與各光學特性參數的關系曲線，這對從分析脈沖形狀中提取介質的光學特性參數的信息有重要的意義。
  5. The various medium parameters have different influence on the reflection of the laser pulse. based on the diffusion approximation theory, the boundary condition of semi - infinite homogeneous media, the influence of the absorption a, the scattering s and the anisotropy coefficient g on the ultra short laser pulse of different pulse - width and shapes has been researched

    論文對超短脈沖在混濁介質中的傳輸進行了理論分析和數值模擬，並在不同脈寬的高斯脈沖和方波脈沖入射到混濁介質的漫反射、漫透射脈沖強度和形狀進行了理論分析和數值模擬，得到了它們與各光學特性參數的關系曲線。
  6. 2 ) radar incidence angle and surface roughness correction : to make radar incidence correction and eliminate the surface roughness effects, a wide range of surface parameters ( soil moisture, surface rms height, correlation length, incidence angle ) was input to the ibm model to simulate the effect of surface roughness and radar incidence angle on the sensitivity of soil moisture to the radar backscattering coefficient. a simple model was established to simulate the effects of incidence angle and surface roughness. 3 ) establishment of soil moisture change inversion model : according to a modified ibm model simulation results, the bare surface backscattering coefficients can be expressed as a funtion of the dielectric component for a given surface roughness when the surface slope greater than 2. 0, which is valid for most nature surface : in above equation, r0 is the surface reflectivity at normal incidence

    本研究中，首先利用基於微波輻射傳輸方程的微波植被模型和積分方程（ iem ）模型模擬了各種地表土壤水分含量情況下，植被覆蓋、地表粗糙度（包括地表均方根高度和相關長度） 、雷達入射角對c波段（頻率4 . 7ghz ）水平極化（ hh ）雷達後向散射系數的影響，在此基礎上，建立模型消除了植被覆蓋、地表粗糙度、及雷達入射角對雷達後向散射的影響，利用多時相50m解析度radarsatscansar雷達後向散射系數圖像反演得到了地表土壤水分變化模式信息。
  7. Compared with the similar research results, the weighted control ic here has the following characteristics : ( 1 ) the circuit structure is simpler ; ( 2 ) the chip ' s fabrication is compatible with standard cmos process ; ( 3 ) n - mosfets with high w / l ratio and short channels are used for weighting and output to reduce the insertion loss ; ( 4 ) the weighting factor varies in a relatively wide range with the controlling signals ; ( 5 ) input and output impedance approach 50 in low frequency ( e. g. 50mhz ), while in higher frequency they slightly deviate from 50, hence the energy reflection lower than 0. 1 ; ( 6 ) it completes the functions of sampling, weighting, controlling and summing of high frequency analog signals

    它的加權控制電路與已報道的相關電路相比具有如下特點：電路結構簡單；製造工藝與普通cmos工藝兼容：短溝道，高寬長比的nmos晶體管具有低的通導電阻，將其作為加權、輸出器件可降低由電路引起的插入損耗；改變加權信號，可實現權值在較大范圍內的連續變化；輸入、輸出阻抗在低頻（如50mhz ）下接近50 ，而在高頻下略有偏離50 ，但反射系數均低於0 . 1 ；實現了對高頻信號的取樣、加權、控制、疊加功能的迭加。
  8. The mirrors with different multilayers, their characteristics and influence with incidence, have been studied to improve the transmission in the system in which transmission efficiency of the system was calculated

    研究了多層膜的帶寬匹配問題及不同入射角度對反射率的影響，計算出eut在不同波段的傳輸效率和傳輸系數。
  9. Secondly, a non - linear mapping function from multiple inputs ( design variables ) to output ( maximum dynamic stress ) is constructed within bp neural networks, in order to obtain the constraint function values that are necessary in optimum design of structures using genetic algorithms and get the optimum solutions. the generation ability of the bp network after training can be used to replace the calculation of fem, which makes the constrained optimization to be possible

    其次，由於動應力的有限元法計算過程復雜，計算量巨大，在應用優化演算法時，需要反復計算，為了使優化過程可行，設計了bp神經網路，利用有限元計算的樣本數據建立起結構設計參數（輸入）與動應力（輸出）的非線性映射關系，從而代替有限元法，快速計算結構動應力。
  10. The method has been used to separate the frequent spectra of incident waves and reflected waves of the composed wave that are simulated by a numerical method. the results shown that the frequent spectra of incident waves and reflected waves being computed are consistent with the target spectrum and the bulk reflection coefficient is too. the frequent spectrum of reflection coefficient is same as the input round the peak frequency

    將此方法用模擬合成波波列的分離計算，結果表明，分離的入、反射波頻譜與輸入的靶譜符合良好，且計算的總體反射系數與輸入的總體反射系數一致，計算得到的反射系數頻率譜在峰頻附近與輸入值符合良好，說明該分析方法是可靠的。
  11. 5. in order to keep gain smooth, enhance output power and efficiency, and reduce reflect factor and attenuation, inner matching networks are needed

    5 、採用內匹配網路技術，設置輸入輸出匹配網路，以保持增益和傳輸特性的平坦性，提高輸出功率和效率，降低反射系數，減少損耗。
分享友人
分享到 Line

分享到臉書