輸出單元 的英文怎麼說

中文拼音 [shūchūdānyuán]
輸出單元 英文
output unit
  • 輸 : Ⅰ動詞1 （運輸; 運送） transport; convey 2 [書面語] （捐獻） contribute money; donate 3 （失敗） l...
  • 輸出 : 1 （從內部送到外部） export 2 [電學] output; outcome; outlet; out fan; fanout; 輸出變壓器 output ...
  1. This paper discusses the designing and making of the dynamic testing systems of engine electronic control system. base on the construction and operation principle of santana 2000gsi m3. 8. 2 engine electronic control systems, design and manufacture led circuit of dynamic testing and fault imitating electronic control unit. on the inspect board, design and equip with motronic 3. 8. 2 ecu i / o measuring joints, design and set up obd - ii diagnostic communication link, design and install fuel pressure inspecting meter. depend on the obd - ii diagnostic communication link and ecu i / o measuring joints, this dynamic testing system can inspect engine electronic fuel injection system, distributorless ignition system, idle speed control system and evaporative emission control system, and can inspect m3. 8. 2 sensors, ecu and actuators, and can interrogate fault memory and erase fault memory ; and can analyse data stream ; and can carry out fault imitating. besides, this paper analyses sensors and actuators typical fault w aves

    2電控單元電路連接器設計製成輸入輸出電子控制檢測端子，並在檢測面板上布置了obd -診斷插座和燃油壓力表。使該動態測試系統能實現對電噴發動機的燃油系統、直接點火系統、怠速控制系統和燃油蒸氣排放控制系統的動態檢測；並通過obd -診斷座、 ecu輸入輸出檢測端子和故障模擬處理單元實現對電噴發動機電控系統各傳感器、電控單元、執行器進行故障碼讀取與清除；動態數據讀取和波形測試和故障模擬等。此外，本論文還分析了傳感器和執行器典型故障波形。
  2. The size of the output data blocks in bytes

    輸出數據塊的大小（以位元組為單位） 。
  3. To realize better performance of share current, a method is present to restrain the circumfluence

    採用有功和無功的並聯控制理論，對各並聯單元輸出有功、無功功率進行分別控制。
  4. First, it is compressible and cushiony ; second, it can be transported to a long distance with a little power loss ; the last, its flux and velocity of flow are quite high, so the reaction time of the operators can been considerably shortened. aiming to solve the problems of vibrating machinery such as short life - span, poor cushion and high energy consumption, the writer, on the basis of characteristic of pneumatic mentioned, contrives a set of valve controlled pneumatic vibrator, which has larger output vibrating force and longer life - span with simple structure. then, it is applied to drive a vibrating screen and the result is fairly well

    文中針對氣動技術本身的特性及優點，如：可壓縮，具有緩沖性；能耗損失小，便於遠距離輸送；流量大、流速高，執行元件響應速度快等，以解決振動機械在應用過程中的緩沖、能耗以及使用壽命等問題為目的，設計出一套輸出激振力大、結構簡單、使用可靠的閥控氣動激振器，並將其成功地運用到振動篩上，取得了較好的效果。
  5. The thesis is based on income question, forest coverage rate and grop production. to beging with, date envelopment analysis is proved that it can be applicated into grain for green in shan - bei district, and then in view of the fact, seven esential factors which have influence on the project are found out : expense of dam, expense of crop, expense of cash tree, expense of defense tree, other economic crop, expense of grass and graziery ; and the output factors include : income of gdp, pure income per captia, the area of decreasing land loss, graziery income, crop production, income of tree, the totle income of economic crop. after the date of each facts are puted into dea model, unefficiencial decision making units ( dmu ) found. the data that are got through adjusting unefficiencial dmus dy dea can offer guide in shanbei district upgrading of an industrial structure. at the same time, taking into account some possible problems in or after grain for green in shan - bei district, the thesis bring out some propesal to improve the circ umstance, enhance the life level and put the relation of population, resource and circumstance into a healthy orbit

    因此，加快退耕還林還草，調整土地利用結構和產業結構，已成為實現山川秀美工程和可持續發展戰略的必經之路。論文以解決陜北地區的收入問題，植被問題以及糧食產量問題為出發點，首先從理論上分析了包絡分析方法在陜北地區退耕還林（草）中運用的可行性，然後結合陜北地區目前的實際情況，綜合分析出影響陜北地區退耕還林（草）的關鍵的七個因素作為輸入指標：水利水保設施投入，農作物投入，經濟林種支出，防護林支出，其它經濟作物，草類支出，畜牧業投入；以退耕還林所要解決的最終問題作為輸出指標： gdp收入、農民人均純收入、水土流失減少量、牧業總產值、糧食產量、林業總產值、其他經濟作物總產值。將各指標所對應的數據代入模型后，通過分析求解得出非有效的決策單元，再運用包絡分析方法的一些基本原理對非有效的決策單元進行調整，由此所得的數據對陜北地區的實際投入具有很好的指導意義。
  6. The theories and design principles of each circuit of the spwm three - phase frequency inverter experiment unit are in detail introduced in this thesis. at the same time some experiment results are shown that include the output voltage and current waves when the load is in resistivity, inductivity or asynchronous motor

    文中詳細介紹了spwm三相變頻實驗單元所包含的各電路環節的理論基礎及設計過程，並給出了調試結果，如負載為阻性、感性和異步電動機時，實驗單元輸出的電壓和電流波形。
  7. The pendulum output is divided, part going directly to the tilt-axis torques and another portion feeding the torques via a thermal integrator.

    擺錘單元輸出有訊號分成兩部分，一部分直接輸入傾斜軸力矩受感器，而另一部分通過熱積分器后再送到力矩受感器。
  8. Mtu maximum transfer unit

    最大輸出單元
  9. According to this idea, this paper first introduces the basic technology to design the instrument. it includes the theory of the laser, measures to survey distance with laser, the theory of the step - motor, subsection technology of the step - motor, the working theory of the single - chip, expansion of the single - chip orderly. the following are the design of the control system of the planimeter according to the principle of the context. it consists of two parts

    最後根據前文介紹的知識先對單片機控制系統進行了硬體電路框圖設計，依據夠用原則對元器件、設備的選擇進行計算、說明、選定，使系統成為擁有完整的包括a d採集、數據存儲器、 8155擴展的鍵盤顯示、 p1口及8155的pa口輸出控制的單片機硬體控制系統電路。
  10. Standard logic cells, memory design and io layout design

    標準邏輯單元，存儲電路設計及輸入輸出單元版圖設計。
  11. The tapped line input output block with compact structures and flexible design method, was studied by many designers in the sixties and seventies of last century. but it is because the weak precision, hard tuning and long design period of traditional equivalent circuit method influences the development and wide use of this block

    抽頭式輸入輸出單元，以其緊湊的結構形式，靈活的設計方法，早在上世紀六七十年代就被許多人員研究，但是由於等效電路法分析該單元的精度較差、調試難度大、研製周期長等原因，影響了抽頭式微波濾波器的廣泛應用。
  12. Train operation safety monitoring and control module can be divided into data acquisition cell, data receiving cell and data disposal / output cell

    行車安全信息監測控制模塊分為數據採集單元、數據接收單元、數據處理輸出單元。
  13. The vd is composed of four functional units : 1 ) the branch metrics unit ( bmu ) ; 2 ) the add - compare - select unit ( acs ) ; 3 ) the path metrics unit ( pmu ) ; 4 ) the survivor memory unit ( smu ) ; regarding the power dissipation of the viterbi decoder, the smu is the hottest spot in the viterbi decoder due to the frequent memory accesses. there are two traditional techniques for the realization of survivor memory unit in viterbi decoder - - register exchange ( re ) and trace back ( tb ) method

    這是當前開展低功耗邏輯優化的重要方面，也是本課題採用的方法。 viterbi譯碼器主要由四個功能單元組成:分支度量單元（ bmu ） ，加比選單元（ acs ） ，路徑度量存儲單元（ pmu ） ，倖存路徑存儲和輸出單元（ smu ） 。本文所做的viterbi譯碼器設計採用模塊化的設計方法，先對各個功能單元進行優化設計，然後將各個功能單元組合在一起，形成最終的譯碼器。
  14. First, the basic concept of nerve net has been introduced. and then the detail structure of the bp nerve net and the detail design precept of input and output layer have been given

    首先介紹了神經網路的基本概念，接著給出了神經網路的具體結構和輸入輸出單元的設計方案。
  15. Low power design for survivor memory unit

    倖存路徑存儲和輸出單元的低功耗設計
  16. Naod maximum transfer unit

    最大輸出單元
  17. From the result of experiments, we discover that different orders bring different classification rate of each sort

    在試驗中發現，輸出單元對應的缺陷類別的不同順序，系統的整體識別率的變化不大。
  18. A rule of thumb is that for each character in the input string, allow 12 bytes in the output string

    簡單的規則是，對于輸入字元串中的每個字元，在輸出字元串中允許有12位元組。
  19. Neural network with linear - nonlinear combined output nodes

    線性與非線性輸出單元相結合的神經網路
  20. The controlling principles of the stepper motor, the design of hardware and software by using the hso in 8098 mcu are introduced

    摘要給出了利用8098單片機的高速輸出單元hso實現對步進電機的控制原理、硬體、軟體設計。
分享友人
分享到 Line

分享到臉書