輻射傳熱系數 的英文怎麼說

中文拼音 [fúshèzhuànrèxìshǔ]
輻射傳熱系數 英文
radiant heat transfer coefficient
  • 輻 : 名詞（車輪中車轂和輪圈的連接物） spoke
  • 射 : Ⅰ動詞1 （用推力或彈力送出） shoot; fire 2 （液體受到壓力迅速擠出） discharge in a jet 3 （放出） ...
  • 傳 : 傳名詞1 （解釋經文的著作） commentaries on classics 2 （傳記） biography 3 （敘述歷史故事的作品）...
  • 系 : 系動詞（打結; 扣） tie; fasten; do up; button up
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 輻射 : radiation; exposure; radio; beaming
  • 系數 : [數學] coefficient; ratio; modulus; quotient; factor
  1. It has issued residential buildings energy design standard for heating zone hot summer and cool winter zone and hot summer and warm winter zone. for heating zone, the method of effective thermal transmittance based steady heat transfer is used for the energy consume calculation, for hot summer and cool winter zone and hot summer and warm winter zone, the method based dynamic heat transfer must be used for the energy consume calculation

    對居住建築，我國已頒布了包括採暖地區、夏熱冬冷地區、夏熱冬暖地區三個節能設計標準，對北方寒冷地區，用建立在穩態傳熱基礎上的有效傳熱系數法進行能耗計算；對夏熱冬冷地區、夏熱冬暖地區，圍護結構受室外動態溫度和太陽輻射熱的綜合作用，明確應採用動態方法計算圍護結構傳熱。
  2. After thermodynamic calculation on several operation conditions of the furnace, cold - state flow and resistance mensuration, the combustion of the tubular - furnace hearth was changed into swirl and addition of radiate cylinder and oxygen content detection minish 1. 25 surplus air to less than 1. 15, improving the combustion condition and convection and radiate heat transfer efficacy, resuling in reducing the waste - gas temperature 45, decreasing exhaust gas loss, and saving fuel by 6 %

    摘要通過對加熱爐幾種工況進行熱力計算、冷態試驗的流場分佈及阻力測定和熱態試驗的爐膛溫度場分佈及管壁溫度等參數的測定，確定將管式加熱爐爐膛內直流燃燒改為旋流場燃燒和增加輻射筒，增設煙氣含氧量分析，可以將燃燒的過剩空氣系數從1 . 35減小到1 . 15以下，極好地改善爐膛內的燃燒狀況和對流輻射傳熱效果，從而降低排煙溫度45 ，減少加熱爐排煙損失，節約了煤氣量6 %以上。
  3. It is very difficult to analyze flame radiation in the cylinder of a diesel engine by theoretical method since flame radiation is a function of many parameters, such as the combustion process, the geometrical description of the chamber, the soot formation and oxidation processes, the soot radiant temperature and soot absorption coefficient. the radiant property of the flame in a cylinder is dependent on the combustion process. but the thermodynamic state of real engine cycles can be analyzed from the pressure - volume diagrams in the cylinder. thus a new thermodynamic computational model is set up for the flame radiation in the cylinder of a diesel engine based on the indirect relationship between the flame radiation and the pressure - volume diagram of the combustion process in this paper. the flame radiant heat flux in the cylinder of a di diesel engine is calculated with the variation of crank angle by this model. compared with measured values, the result of the computational values shows the model is available to represent the effects of flame radiation

    柴油機缸內的火焰輻射受諸多因素的影響，用理論分析法來確定它是相當困難的，由於柴油機缸內火焰輻射特性依賴于缸內的燃燒過程，而燃燒過程中的實際熱力狀態又可用示功圖來分析，因此藉助於火焰輻射與缸內熱力參數之間的這種間接關系，建立了一種計算柴油機缸內火焰輻射傳熱的新模型，利用該模型對一臺直噴柴油機缸內火焰輻射熱流量隨曲軸轉角的變化情況進行了計算，將計算結果與實測結果進行了比較，表明該模型能較好預測缸內火焰輻射傳熱量。
  4. Abstract : the in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    文摘:針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況，提出了若干技術改造措施包括，增大對流管表面積以增大對流段的熱負荷；增加輻射管的換熱面積；修正煙囪高度；換用新型燃燒器，變自然通風為強制供風，以增大燃燒器的發熱量，減小過剩空氣系數，節省燃料2 % 3 % ；在對流段和煙囪之間增設空氣預熱器以提高空氣入爐溫度；採用高溫輻射塗料增強輻射換熱效果，從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。
  5. The in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況，提出了若干技術改造措施包括，增大對流管表面積以增大對流段的熱負荷；增加輻射管的換熱面積；修正煙囪高度；換用新型燃燒器，變自然通風為強制供風，以增大燃燒器的發熱量，減小過剩空氣系數，節省燃料2 % 3 % ；在對流段和煙囪之間增設空氣預熱器以提高空氣入爐溫度；採用高溫輻射塗料增強輻射換熱效果，從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。
  6. Inverse problem of reconstructing the heat - conduction equation ' s initial value and the radiative coefficient

    熱傳導方程輻射系數及初始條件反問題的數值求解
  7. Taking erectophile type continuous vegetation as a example, authors had done many monte carlo simulations, and established empirical analytic expressions of radiances with component temperature, soil emissivity and leaf area index. empirical analytic expressions were used to construct objective function and genetic algorithm was employed to synchronously retrieve 5 parameters, such as component temperature, soil emissivity and lai, from thermal infrared 2 channels and 2 angles data. many experiments of genetic algorithm inversion from simulated data were conducted, results show that it is very robust to retrieve component temperature using genetic algorithm ; genetic algorithm can cope with uncertainty inversion problem pretty well if full advantage of priori knowledge was taken. comparison between inversion results and ground - truth data has been done. this paper offers a new example to retrieve component temperature from multi - channel, multi - angle thermal infrared data based on the model of directionality of thermal radiance

    在熱輻射方向性規律的基礎上，以喜直型連續植被為例，進行了大量的monte carlo模擬，建立了輻射亮度和組分溫度植被葉面積指數及土壤比輻射率之間的經驗函數關系。採用遺傳演算法，從熱紅外2個波段2個角度數據中，同時反演混合像元組分溫度土壤比輻射率和葉面積指數等5個參數。通過對模擬的觀測數據進行大量的遺傳演算法反演試驗，結果表明，遺傳演算法反演組分溫度非常穩健，在寬松的先驗知識條件下，遺傳演算法可以解決不確定性反演問題。
  8. Compared with traditional air - conditioning, its advantages lie in thermal comfort energy efficiency free use of spacing and etc. this paper introduces the procedure and the result of the experiment of gas - heater radiant floor system and gshp radiant floor system and compares them with traditional air - conditioner. based on the analysis of the heat transfer of radiant floor, this paper uses the theory of heat transfer to establish a mathematical model and computes it with difference equation. the important factors inferred from the model such as floor surface temperature heat intensity composite heat transfer coefficient deviate from the experiment result in a small range of 20 % and fit the need of the practical use

    在分析了輻射地板傳熱機理的基礎上，文中利用熱傳導、大空間的自然對流換熱等傳熱學理論建立了輻射地板的傳熱模型，再採用有限差分方法對模型求解，所得有關輻射地板供冷熱性能的重要參數如地板表面平均溫度、熱流密度、地板表面復合換熱系數等與實測值相差在20以內，滿足工程使用要求；同時得出輻射地板盤管供水溫度是影響地板供冷熱性能的重要因素的結論。
  9. Automatic radiation heat transfer view factor calculations

    自動輻射傳熱系數的計算。
  10. The theoretical analysis of large cryocondensation pump for nbi was mainly concerned. this paper emphasized on analyzing and calculating the heat load of cryocondensation pump, simulating thermal transmission coefficient and molecule transmission coefficient of radiation baffle according to monte carlo method, analyzing the process on cryo - surface and the factor of affecting pumping speed and hydrogen layer thickness of influencing cryo - parameter, etc. finally by verifying the pumping speed on large cryocondensation pump for neutral beam injection system, the pumping speed of 4. 0x105l / s ( for h2 ) was proven to be reasonable

    本文首先介紹了中性束注入系統的國內外發展狀況，闡述了中科院等離子體所ht - 7中性束注入系統的構成，主要對用於中性束注入系統的大型低溫冷凝泵的特性進行了理論分析；對冷凝抽氣面的熱負載進行了分析計算；用蒙特卡羅法對輻射擋板的分子傳輸幾率與熱傳輸幾率進行了模擬計算；研究了低溫表面的處理方法對抽速的影響以及氫層厚度對各低溫參數的影響；最後對用於中性束注入系統的大型低溫冷凝泵的抽速進行了驗證，得出的結論是：選取40萬升秒的抽速是合理的。
  11. With the operation conditions, the adsorber, the evaporator, the condenser, the receiver and the throttle are disigned. the adsorber is of the most importance in the adsorption system, so we provide the non - dynamic equilibrium model of active carbon fibre ( acf ) - methanol adsorption refrigeration pair. the numerical simulation is carried out based on the recorded solar radiation data measured in nanjing and daily ambient temperature for the typical clear days. the temperature field, the pressure field, the methanol concentration and the temperature of evacuted tube, and water tube are caculated

    吸附床是吸附製冷系統的核心，本文以活性炭纖維?甲醇為工質對，建立了吸附床非動態平衡吸附傳熱傳質數學模型，以南京夏季典型一天中的輻射強度和環境溫度為條件，模擬計算了吸附床在通水冷卻和自然冷卻兩種狀態下，吸附床內各點壓力、溫度、吸附率、吸附總量及真空管和冷卻水管壁溫隨時間變化關系。
分享友人
分享到 Line

分享到臉書