迭加公理 的英文怎麼說

中文拼音 [diějiāgōng]
迭加公理 英文
axiom of superposition
  • : Ⅰ動詞(輪流; 替換) alternate; change Ⅱ副詞1 (屢次) repeatedly; again and again 2 (及) in tim...
  • : Ⅰ形容詞1 (屬于國家或集體的) state owned; collective; public 2 (共同的;大家承認的) common; gen...
  • : Ⅰ名詞1 (物質組織的條紋) texture; grain (in wood skin etc ) 2 (道理;事理) reason; logic; tru...
  1. Based on the analysis of mechanism for joint region, the " frame - wall " and " aslope compression stub column " mechanical models and yielding patterns of core zone of the joints are set up. the shear load - carrying formulation for joint core zone is also given in terms of plastic ultimate analysis. and then, the comparisons between the formulas given in this paper and that of chinese design code ( draft ) and nonlinear fem as well are presented

    對節點核心區的抗剪,通過受力機的分析,建立了鋼「框架剪力墻」混凝土「斜壓短受力體系及其屈服機制,根據塑性極限分析,給出了節點核心區抗剪承載力計算的式, 《規程》式和非線性有限元近似模擬分析結果進行了比較。
  2. In the process of solving, poles are obtained from recurrent formula, modal vector are obtained from superposition formula not residuary. decoupled equation is derived when vibration source is part correlation, severely coupling appears in the process of input and output then frequency response function cannot directly get according to method mentioned above, decoupling is first problem

    當輸入完全相關時,頻響函數無解,可繞過頻響函數,直接運用線性系統的來求響應,極點由遞歸式得出,模態矢量由疊式求出,而不是由留數求得的相應的式。
  3. Based on the linear creep superposition principle, admiting average loading age coefficient and average time - lasting coefficient, adopting creep and shrinkage calcultion in aci code, a simplified method of creep and shrinkage analysis in reinforced concrete member bearing multi - times axial forces is presented

    摘要根據線性徐變的,引入平均齡期影響系數和平均持荷影響系數,利用aci規范中的徐變和收縮計算式,推導了鋼筋混凝土軸壓構件分批載時收縮徐變分析的簡化計算方法。
  4. The main results and creative points in the dissertation were as follows : a ) by means of studying on the fiber - optic hydrophones ’ tdm array based on phase generated carrier ( pgc ) demodulation with laser frequency modulation, the mathematic models were set up, used for theoretical analyses of noncoherent crosstalks in the system using low coherent laser and coherent crosstalks in the system using high coherent laser. the formulas calculating crosstalks were given, and the method measuring crosstalks was shown definitely

    本論文的主要研究結果和創新在於: 1 、通過對基於光頻調制pgc (相位生成載波)解調光纖水聽器時分復用系統的研究,針對低相干光源的串擾強度和高相干光源串擾的相干,建立了論分析的數學模型,得出了計算串擾的式,明確了測試系統串擾的方法。
  5. In the thesis a new count expression of mesh fractal dimension is introduced, on the basis of it the storage and operation counts of directs solution methods, assembly global stiffness iterative methods and ebe iterative methods have been analyzed and compared, a conclusion has been obtained that the storage and operation counts of direct solution methods is the most, the storage counts of the ebe iterative methods is the least. estimating compute scale for ebe iterative methods at shuguang 2000 parallel computer, it is make out that compute scale is large in the extreme if make the most of the memory of every processor. by analyzing the parallel compute performance of 2d upend - step flow calculation, it is proved that ebe iterative methods can achieve upper speedup rations

    本文還提出了一種網格分維新的計算式,並基於網格分維對直接解法,組集總剛矩陣的代解法和基於ebe的代解法等三種方法的存儲量和計算量進行了分析和比較,得出了直接解法無論存儲量和計算量均最大,基於ebe代解法存儲量最小的結論;在曙光2000并行機上估計了基於ebe代解法的計算規模,說明只要充分利用各處機的內存,可解問題的規模是非常巨大的;對二維倒臺階流并行計算進行了性能分析,表明基於ebe策略的代解法能獲得較高的速比。
分享友人