逐步試驗 的英文怎麼說

中文拼音 [zhúshìyàn]
逐步試驗 英文
point-by-point test
  • : 動詞1. (追趕) pursue; chase; run after 2. (驅逐) drive out; expel; banish 3. (挨著次序) one by one
  • : Ⅰ名詞1 (步度; 腳步) pace; step 2 (階段) stage; step 3 (地步; 境地) condition; situation; st...
  • : 名詞(古代占卜用的器具) astrolabe
  • : 動詞1. (察看; 查考) examine; check; test 2. (產生預期的效果) prove effective; produce the expected result
  • 逐步 : 1 (一步一步地) step by step; progressively; gradually; proceed orderly 2 [數學] successive step...
  • 試驗 : trial; experiment; test
  1. The dissertation is mainly including four section : the first is the experiments done in the tank, which will supply the reliable information of imaging data ; the second is image edge detection by the use of the art of the zernkie moments, which is used to detect the liner and threaded edge of the object, the third is the underwater camera calibration technique, the forth is automatic positioning the location of the camera by used of the art of cross - ratio, the result of which is satisfied

    本文工作分為四個部分:第一部分是水槽實部分,它為后續的工作提供了可靠的圖像數據信息;第二部分是基於zom距的直線、曲線邊緣提取技術及相關的與處理技術;第三部分,水下攝像機標定技術研究,基於改進的tsai演算法,採用分解的標定策略。並探討了一種相對簡單的、靈活的標定技術;第四部分是攝像機定位技術研究,採用具有平移不變性的交比進行攝像機定位,模擬的最大誤差不超過2 ,效果還是令人滿意的。
  2. Because a conventional quantum well is needed to add in the novel structure, many experiments were made on conventional gaas / algaas qwips. the experiment results based on various test methods were well analyzed. the detectivity of conventional gaas / algaas qwips can be comparable to the current level gradually

    由於改進結構中需要加入一常規量子阱,因此針對常規結構做了部分實,由多種測方法得到大量實數據,並對其進行了全面的分析,常規gaas algaas量子阱紅外探測器的研製已經趨向正常化。
  3. Through developing the comprehensive experiment device with large - scale drum strength and stability, the stress - measuring experiments of various wall thickness of the normal drums of the cranes were performed. the law that the stress of the drums along the circumference and along the axis changes with the load increase of the wire ropes was studies for the first time

    通過研製全比尺大型捲筒強度、穩定性綜合裝置,對起重機常用規格的捲筒進行了各種壁厚條件下的應力測量,首次對捲筒體周向和軸向應力隨鋼絲繩加載過程變化的規律進行了研究,發現最大應力產生在鋼絲繩繞過后3 ~ 5圈截面處,該現象與理論分析結果也是符合的。
  4. On the basis of mode experiment of the drums, the paper analyzes the impacts of the drum end and the gradual wind of the wire ropes on the drum strength. and also on the basis of the analysis of the data of the drum mode experiment, the paper presents the research conclusion that unstability mostly occurs where drums are fully wound with wire ropes

    在進行捲筒模態的基礎上,分析了捲筒端板和鋼絲繩卷繞過程對捲筒剛度的影響關系,在對大量的捲筒模態數據分析歸納的基礎上,給出了鋼絲繩全部繞滿捲筒是最容易發生失穩的研究結論。
  5. The experiments indicate that a reasonable choice of spinning apparatus can improve the evenness and hairiness value of the yarn

    通過表明合理選用紡紗器材可改善成紗的條干值和毛羽值。
  6. Abstract : this paper introduced the resources and developing situation s of pineapple leaf fiber, and the experimental research on the fiber extractio n mechanism, the production technology and the complete set of processing equipm ent were conducted

    文摘:介紹了菠蘿葉纖維的資源和開發利用情況,進行了刮麻機理、生產工藝和配套設備的研究,提出了將菠蘿葉在打擊和振動的雙重作用下使纖維和麻渣分離的原理。
  7. According to the request of the standard in electric industry in china named " on line check and test rules of analog and digital control system of power station ", every system is tested, and according to technological guides and operation rules, static and dynamic trial are required to be done, the quality of adjust, and response time also adapt to the requirement

    機組整套運以後,各控制系統投入。依據中華人民共和國電力行業標準《火力發電廠模擬量、開關量控制系統在線收測規程》的要求進行測,並按照技術指標及運行導則要求均做過靜態、動態特性,調節品質、響應時間均符合要求。
  8. Saturated sand are testes in the laboratory under the undrained cyclic loading condition with static - dynamic dual purpose triaxial compression test apparatus, which is designed under the cooperation of hohai university and marui co. ltd japan. the results indicate that the stress path approaches from a initial stress point to the failure lines as cyclic loading goes on, and eventually converges on a certain limiting stress path in the vicinity of the failure lines. the stress - strain curve, however, does not converge on a closed hystersis loop ; the shear strain rapidly increases in looser sand or gradually and continually increases in denser sand

    利用河海大學與日本圓井株式會社共同研製的新型的多功能靜動三軸儀進行了飽和砂土循環扭剪不排水,研究表明,對于松砂,剪應變幅度快速地由微小增加到百分之幾甚至百分之十幾,對于緊砂,剪應變幅度漸地由微小增加到百分之幾甚至百分之十幾;經研究表明用初始有效平均正應力歸一化的有效應力路徑很好的一致性。
  9. In the second year of this pilot programme, we will, on the basis of experience gained, extend it in phases to other communities in hong kong

    這個計劃行的第二年,將根據取得的經,在全港其他社區推廣實行。
  10. The uniform design of experiment is used and the stepwise technique is adopted to analyze the result, so that the sensitivity and compatibility among bas oil and additives are studied

    本文應用均勻設計方法,用回歸對結果進行處理,分析了基礎油對添加劑的感受性及添加劑之間的配伍性。
  11. The results of numerical simulations and analytical solution show good accordance, except in the region near the fiber ends, where the shear - lag approach causes considerable discrepancy. next, to overcome the unrealistic assumption of perfect bonding, augmented - lagrange contact algorithm, element " birth - death " and fem are combined in the study of the partial debonding between fiber and matrix under pull out forces

    然而完全粘結的假設過于理想,與實際應用相差較大,因此,本論文將有限元法,接觸演算法和單元生死法結合起來,研究較大抽拔力作用下,纖維與基體之間發生的脫粘的過程,所得到的抽拔力的變化結果,與數據比較,較為一致。
  12. Lewis relationship has been suggested to evaluate the surface mass transfer coefficient using the average surface convective transfer coefficient. in addition, a practical analytic technique for testing the surface mass transfer coefficient is proposed and the values of he surface mass transfer coefficient have been given for the particular desorption and absorption test and validated against lewis relationship results. indoor temperature and humidity evaluation equations of adobe buildings considering the moisture absorption and desorption by interior materials have been proposed based on the analysis of the indoor dynamic thermal and moisture process

    通過理論解析和實定量地研究了生土建築圍護結構表面吸放濕效應,首次提出了以空氣濕度( kg / kg )為驅動勢差的圍護結構表面吸放濕量計算公式,該公式較適用於工程計算,從而為使建築濕環境研究成果應用到建築工程實踐中奠定了理論基礎和提供了簡便演算法;通過對國內外關于表面質交換系數確定方法的研究成果的分析,提出用lewis關系計算生土建築圍護結構表面質交換系數;在實室環境下,對生土建築圍護結構表面質交換系數進行了測方法研究,測結果和利用lewis關系得到的數值較接近。
  13. In this paper, based on the soil water infiltration multifactorial influence tests with three species of soil texture and different husbandry condition and monofactorial influence tests with four species of soil texture in indoor, the basic infiltration characteristics, reduction infiltration mechanism and various factors are studied systematically. major factors influencing soil infiltration characteristics, resilience between influence factors and soil water infiltration parameter and influence priority are analyzed by mathematics statistics method, stepwise regression models with multiple units of soil water infiltration parameters are build up and verified

    本文基於大田三種質地、不同耕作條件下土壤水分入滲的多因素影響和室內四種質地土壤條件下的單因素影響,系統地研究了土壤水分入滲特性的變化過程,阻滲機理和影響土壤水分入滲特性的各種因素,藉助數理統計方法分析影響土壤水分入滲特性的主要因素,各影響因素與土壤水分入滲參數間的相關性及其影響的先後次序。建立、證了土壤水分入滲參數的多元回歸模型。
  14. Although the rfc of mts systems corporation is a general methods to process road simulation test all over the world, it contains two disadvantages as follows : 1. before the fatigue test, it will take a long period to carry through the off - line iteration to acquire a series control values

    雖然美國mts系統公司的rpc方法是目前國際上進行道路模擬普遍採用的方法,但它存在如下問題: 1系統進入正式的之前,要用較長的時間進行離線迭代運算獲得控制量序列,逼近給定的隨機波形。
  15. On the base the damage models of concrete and analysis methods of horizontal loading capacity of pile are introduced. using the method mentioned above thin - wall cylinder piles of the out - gate the engineering in east punan shanghai are analyzed, and comparing with testing results it is prove that calculation results are reasonable

    在此基礎上引入了混凝土的損傷模型,提出了樁的水平承載力的分析方法,並利用該方法對上海浦南東片出海閘導流堤採用的薄壁筒樁進行了水平變力加載分析,並與結果進行比較,證了分析結果的合理性。
  16. Therefore, it is urgent to study an advanced and convenient method obtaining maximum dry density in - situ. by means of data from kai - luo expressway, this paper established a mathematical model of compaction function by analyzing the characteristic of compaction curve

    因此,迫切需要用快速、準確、方便的由現場干密度推算最大幹密度的先進方法來代替傳統的標準擊實
  17. For chip design, verification must be an integral part of the design process from the start, along with synthesis, system software, bring up, and debug strategies

    從設計開始到設計綜合、系統軟體、求精和調等階段,證是貫穿晶元設計全流程的重要組成部分,而不是只在設計完成後才考慮的事情。
  18. For reducing cost and accelerating construction speed sparingly, at present in irrigation works construct in producing testing progressively and antiabrasion layer that popularize excavating method competent to split law in advance, flexible cushion layer etc. accumulative charge to vertical hole has been tested in three gorege project only

    為了節省施工成本、加快施工進度,目前在水利工程施工生產中逐步試驗並推廣的保護層開挖方法有水平預裂法,柔性墊層法等。對於垂直孔水平聚能藥包爆破用於生產僅在三峽進行過。
  19. To destroy the rc structure until the whole system ruin is so called structure test

    鋼筋混凝土結構是使結構破壞直至整體坍塌的研究過程。
  20. It can be a speedy and effective assistant tool for students and engineers to study and apply creep experiments, used to forecast the creep traits of new material in order to reduce the blindness during the real experiment and compared with the later experiment results. especially, with the improving of vmces ’ s function, it will be deeply and widely used in the field of scientific research

    它為理工科大學生、研究生和一般工程技術人員學習、研究和應用蠕變提供了快速、高效的輔助工具;在新材料研究與開發領域,通過虛擬系統可對新材料的蠕變特性進行早期預測,以減少實際的盲目性並可與後期結果相互映證;隨著該虛擬系統的完善,它在科學研究領域的應用必將愈來愈深入和廣泛。
分享友人