通風煙道 的英文怎麼說
中文拼音 [tōngfēngyāndào]
通風煙道
英文
vent stack- 通 : 通量詞(用於動作)
- 風 : Ⅰ名詞1 (空氣流動) wind 2 (風氣; 風俗) practice; atmosphere; custom 3 (景象) scene; view 4 ...
- 煙 : Ⅰ名詞1 (物質燃燒時產生的氣體) smoke 2 (像煙的東西) mist; vapour 3 (煙草) tobacco 4 (紙煙、...
- 道 : Ⅰ名詞(道路) road; way; route; path 2 (水流通過的途徑) channel; course 3 (方向; 方法; 道理) ...
- 通風 : 1 (使空氣流通) ventilate; air 2 (透氣) be well ventilated 3 (透露消息) divulge information;...
-
Fanned by a constant updraught of ventilation between the kitchen and the chimneyflue, ignition was communicated from the faggots of precombustible fuel to polyhedral masses of bituminous coal, containing in compressed mineral form the foliated fossilised decidua of primeval forests which had in turn derived their vegetative existence from the sun, primal source of heat radiant, transmitted through omnipresent luminiferous diathermanous ether
自廚房至煙囪的孔道,不斷地向上通風,灼熱的火被它煽得從成束的易燃柴禾延燒到多面體煙煤堆上。這種煤炭含有原始森林的落葉堆積后凝縮而成的礦物狀化石森林之發育生長靠的是熱輻射性源-太陽,而熱又是由那普遍存在傳光並透熱的能媒33傳導的。The flue should draw better once it ' s been swept
煙道一經清掃,通風情況應好些。The top - firing air and gas self - preheating hot blast stove adopts a patented burner and high blast temperature bypass flue
摘要頂燃式空氣、煤氣自身雙預熱熱風爐採用了頂燃式燃燒器熱風爐專利的燃燒器技術和高溫旁通煙道技術。Analysis of exhaust ventilation mode of subway tunnel fire
地鐵區間隧道火災排煙通風模式分析In doing so, it prevents the smoke cause by fire channels to the lift shaft when any fire breaks out
這樣做,可預防當火災爆發時因火勢引道而造成煙霧進入電梯通風孔。The uk building regulations permit ventilation fans to be eliminated if trickle ventilators and passive stack extract vents are provided
英國建築規范允許在設有細流通風設備和被動式的煙囪排煙道的情況下,通風機可以不設。Fume extractor and dedulfurizing installation : wet and dry ventilation duct
排煙脫硫裝置:溫式乾式通風道The consumption of electrical energy of electrically calcined furnace during calcining anthracite is studied by adjusting the length of the top electrode, the flue damper and changing the release direction of removed dust produced from charging system of electrically calcined furnace
摘要根據電?爐?燒無煙煤的工藝原理,通過調整上部電極長度、煙道閘板及改變電?無煙煤前上料系統通風除塵灰的排放方向等工藝控制方法,對電?無煙煤電耗進行研究。Comprehensive arrangement the location of kitchen & toilet in the house, rational division of the space of the kitchen & toilet ( eg. it is necessary to separate the dry from humid space in toilet, the clean from contaminated space in kitchen ), it is emphasized that decent space for kitchen & toilet and some flexible space is advocated in the design, the appurtenances arrangement should be coped with the human engineer, it is better to design pipe well and equipment layer to accommodate the various meters, wires and pipes. in order to save energy and water, it is recommend to use solar energy and the different quality water
本著「以人為本」的設計思想,提出適宜經濟適用住宅的整體廚衛設計思路和方法,即:綜合協調廚衛在住宅中的位置;對廚衛空間進行合理分隔(衛生間干濕分離,廚房潔污分離) ;廚衛各空間必須具有適宜的空間尺度和面積保障,並提倡具備一定的面積彈性設計;依據人體工效學原理進行廚衛部分設備的綜合布局;利用管道井、設備層綜合布局各種管線儀表;採用分質供水設計系統和太陽能供能系統,達到節水節能;注重廚衛的排煙通風設計,提高室內環境質量;考慮廚衛的適應能力,注重通用設計。Secondly, the paper simplified the calculating model of fume in the high tunnel. took the fume restriction into account, the paper provided some equations to calculate the longitudinal fire ventilation. finally, the paper calculated three examples : the zhongliangshan tunnel and the left route of the yanmenguan tunnel
最後,本文將公路隧道火災的通風模型進行簡化,考慮火災煙流阻力(節流阻力,摩擦阻力,火風壓)的影響,提出了縱向式火災通風計算的方程式,並對中梁山隧道的左右線、雁門關隧道的右線進行了實例計算。The tunnel would be well - ventilated if tall chimneys were built above sea level
如果再建些伸出海面的高大的煙囪狀通風管,隧道就具備了良好的通風條件。Numerical simulation by cfd was carried out to understand the hot current behavior in a tunnel with longitudinal ventilation. it becomes clear that fire source modeling is very important because the hot current behavior is strongly affected by the fire source position and is sensitive to methods in the modeling of the fire source. the flame area which has developed from the fire source is an area of chemical reaction caused by combustion. even if grids in the vicinity of the fire source are made fine, it was difficult to simulate the heat generation area with consideration to this chemical reaction through using a method for setting the heat release rate simply on the fire source surface. therefore, we proposed a method adopting the knowledge on flame shape under the longitudinal ventilation and incorporating it into numerical simulation and it showed a good agreement with the experimental results. it was shown through experiments in a tunnel with longitudinal ventilation that the hot current developed toward the tunnel center downwind from the fire source near a wall. the cause was investigated by numerical simulation and it became clear from the results that the spiral air by the fire plume created a vortex in the crevice between the wall and the plume
運用cfd進行數字模擬,以了解縱向通風隧道內熱煙氣流的特性.通過模擬發現對火源進行模擬非常重要,熱煙氣流特性受火源位置的影響很大,並且對火源模擬方法很敏感.火源生成的火焰區是燃燒引起的化學反應區域.即使火源附近的木垛排列完好,也很難在考慮這些化學反應條件下模擬熱生成區域.建議考慮縱向通風隧道內火焰形狀並對它進行數字模擬.模擬結果與試驗結果非常吻合.試驗證明,在縱向通風隧道內,熱煙氣流從靠近墻體火源處順風向隧道中心蔓延.數字模擬結果發現,火災羽流造成的螺旋上升空氣會在墻體和羽流之間形成一個渦流區Abstract : numerical simulation by cfd was carried out to understand the hot current behavior in a tunnel with longitudinal ventilation. it becomes clear that fire source modeling is very important because the hot current behavior is strongly affected by the fire source position and is sensitive to methods in the modeling of the fire source. the flame area which has developed from the fire source is an area of chemical reaction caused by combustion. even if grids in the vicinity of the fire source are made fine, it was difficult to simulate the heat generation area with consideration to this chemical reaction through using a method for setting the heat release rate simply on the fire source surface. therefore, we proposed a method adopting the knowledge on flame shape under the longitudinal ventilation and incorporating it into numerical simulation and it showed a good agreement with the experimental results. it was shown through experiments in a tunnel with longitudinal ventilation that the hot current developed toward the tunnel center downwind from the fire source near a wall. the cause was investigated by numerical simulation and it became clear from the results that the spiral air by the fire plume created a vortex in the crevice between the wall and the plume
文摘:運用cfd進行數字模擬,以了解縱向通風隧道內熱煙氣流的特性.通過模擬發現對火源進行模擬非常重要,熱煙氣流特性受火源位置的影響很大,並且對火源模擬方法很敏感.火源生成的火焰區是燃燒引起的化學反應區域.即使火源附近的木垛排列完好,也很難在考慮這些化學反應條件下模擬熱生成區域.建議考慮縱向通風隧道內火焰形狀並對它進行數字模擬.模擬結果與試驗結果非常吻合.試驗證明,在縱向通風隧道內,熱煙氣流從靠近墻體火源處順風向隧道中心蔓延.數字模擬結果發現,火災羽流造成的螺旋上升空氣會在墻體和羽流之間形成一個渦流區Leong, j. c., heat transfer and fluid flow in rotating cylinders with a porous sleeve, ph. d. dissertation, school of aerospace and mechanical engineering, university of oklahoma, usa, 2002, 321 pp
梁智創、蔡建雄,國道五號北宜高速公路坪林頭城段雪山隧道通風及火災煙流電腦模擬軟體,領航資訊系統股份有限公司,技術報告, 2005 。This valve is widely used in the pipe system such as venting , environment protection, cont - rolling smoke and collecting waste heat in building material, glass, mining, power, light industry and papermaking departments
電動高溫蝶閥,普遍適用於建材、玻璃、礦山、電力、輕工、造紙等行業的通風、環保工程、煙氣治理、熱能回收等管道系統中。Aiming at the problems of smoke control and hvac fire protection in civil building design, analyses some provisions in the current national standards and codes for smoke extraction in inner passages, setting of fire dampers in hvac systems and setting of pressurising air supply systems in upright evacuation passages for underground and semi - underground spaces, and gives the author ' s personal opinions
摘要針對民用建築工程設計中遇到的防排煙及通風空調系統防火問題,分析了現行國家標準關于內走道排煙、通風空調系統防火閥設置、地下室及半地下室豎向疏散通道正壓送風系統設置等的相關規定,並提出了個人見解。Optimum design for construction management by limiting the period of survey, drilling, loading and exploding, ventilating and transporting is intensively studied and the applicability of boosting the speed of construction by well organization of space, manpower and machine is fully illustrated
論文重點闡述了通過縮短測量劃線、鉆眼、裝藥爆破、通風排煙、裝碴運輸作業時間,達到快速施工組織設計優化的目的,說明了採用鉆爆法施工充分利用隧道空間,合理配備人力、機械,隧道開挖施工進度得到提高的可行性。Concrete and reinforced concrete ducts ; hoods and bases for ducts, dimensions, requirements, testing
混凝土和鋼筋混凝土製煙道.煙道通風罩和煙道底座.尺Fire proof valve refers installed in the ventilation, air - conditioning systems to send, and the road back to the wind, opened in a state of fire when the temperature reached 70 degrees, the gas automatically closed in a certain period of time to meet the fire resistance requirements of the stability and integrity of fire resistance, a possible role of the fire fight valves
防火閥是指安裝在通風、空調系統的送、回風管路上,平時呈開啟狀態,火災時當管道內氣體溫度達到70時自動關閉,在一定時間內能滿足耐火穩定性和耐火完整性要求,起隔煙阻火作用的閥門。Study of fire smoke flow characteristics of horizontal tunnel using longitudinal ventilation
縱向通風水平隧道火災煙氣流動特性研究分享友人