連通孔隙度 的英文怎麼說

中文拼音 [liántōngkǒngxìdù]
連通孔隙度 英文
continuous porosity
  • 連 : Ⅰ動詞1 （連接） link; join; connect 2 （連累） involve （in trouble）; implicate 3 [方言] （縫） ...
  • 通 : 通量詞（用於動作）
  • 隙 : 名詞1 （縫隙; 裂縫） crack; chink; crevice 2 （空閑） gap; interval 3 （漏洞; 機會） loophole; op...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 連通 : feed through; connection; connected; intercommunication
  • 孔隙度 : amount of porosity
  1. The studies of plane heterogeneity are as follows : the text counts the parameters of the sandlayers " geometric shape of different sedimentous microfacies ; speculates the conditions of lateral communication by sandstone density according to the method brought forward by j. r. l. allen ; gets a group of parameters including the reservoir thickness, porosity and coefficient of permeability by using kriging method according to the data of logging results ; makes certain the direction of coefficient of permeability with variation function by modeling globosity function ; divides the sandlayers into five types by using the method of flowing cell based on three parameters, that is x h, kxh and h / h, and accounts the favorable region. on the base of above - mentioned studies, the text evaluates the heterogeneity of sandlayers and gives the resolutions to these problems to serve the development of the field

    Allen ）等人提出的統計方法，用垂向上砂體密度的界限來推測砂體側向連通情況；根據每口井的測井解釋資料，利用克里金插值法對外間進行插值，得到了一組反映儲層特徵在平面上變化的參數，包括儲層厚度分佈、孔隙度以及滲透率，並且成圖；利用變差函數法，通過球狀函數模擬，確定儲層優勢滲透率方向：根據流動單元法，以儲能系數、容積系數以及凈毛厚度比三個參數為依據，通過聚類分析方法進行流動單元劃分，並且按照參數特徵將其分為五類，統計各砂層有利流動單元區塊。
  2. For the soft rock, the shrink of material and reconstruction of particle is dominant, and density of rock is large

    至於孔隙率較高且連通性較高的軟砂巖則以顆粒重組和收縮佔主導地位，巖石密度增大。
  3. The results show that transformation of transmission mechanism and much higher birefringence can be achieved after nlc - filling. farther, we firstly demonstrate the realization of modulating pbg and modes of pbg - pcfs by changing refractive index filled of filled nlc by virtue of temperature or electric field, and finally tunable

    在此研究的基礎上，首次提出並設計出通過用溫度或者電磁場來調節空氣孔中液晶的折射率來連續調節這種高雙折射光子帶隙光纖中的傳輸帶隙和傳導模式，最終實現的高雙折射可調的光子帶隙光纖。
  4. The joining method improved the wettability between the interlinker and the composites and the interlinker could infiltrated into the composites, which increased the contact area and improved the properties of the joints. 2

    這種方法通過改善連接劑與復合材料的潤濕性，使連接劑滲入復合材料孔隙中，大幅度增大了連接劑與復合材料的接觸面，提高了連接性能。
  5. 3 ) the sandbody distribution, physical properties, pore structure and heterogeneities are affected by the microfacies. at the center part of underwater distributive river course, the petrophysics and physical properties are both better than that at the edge of the microface. 4 ) the chang 61 2 - 3 substrata and the substrata of chang 62 " member which show the better porosity, permeability, and better pore structure ; display lower permeability variation coefficient, dart - coefficient and contrast - coefficient and good connecting sandbody so the horizontal heterogeneities is weaker ; whereas manifest stronger inner - heterogeneities due to the numerous intermediates ; present stronger inter - heterogeneities caused by the greater frequency of sandbody

    長6儲層中長6 _ 2 ~ （ 1 - 3 ）和長6 _ 2 ~ 1砂層中的各個小層的孔隙度、滲透率值、含油性較好；平面非均質性較弱，表現為級差、突進系數、變異系數較低且砂體的連片程度高，鉆遇率和連通系數較高；與此同時，層內非均質性較強，表現為垂向上夾層的數目較多，厚度較大；層間非均質性也較強表現為分層系數較高。
  6. According to thorough research on mechanical mechanism of 3 - d tensional micro - fracture producing, this point is put forward the first time that : there is more stress concentration in the circumference of micro - cracks. and the cracks are easier to expand and to link with each other when the fissures contained saturated pore fluid than dry state. therefore, it is necessary to modify the griffith criteria

    4深入研究了三維張性微裂縫形成的力學機理，首次指出：在裂隙內飽含孔隙水的情況下，微裂縫周邊的應力集中程度更高，裂縫更容易擴展乃至連通，因此，在張裂縫發育的研究中應該對格里菲斯準則進行修正。
  7. Accumulating model of steel balls was used to simulate the pore distribution in the coating the pore distribution in the direction of coating thickness was self - existent and could not join to intercommunicating pore

    分析結果表明有兩個主要的原因致使鍍層不會產生水溶液介質的孔隙腐蝕：一是在鍍層厚度方向上孔隙是獨立的，不會相互連接形成通孔。
分享友人
分享到 Line

分享到臉書