運動方程 的英文怎麼說

中文拼音 [yùndòngfāngchéng]
運動方程 英文
direction of motion
  • 運 : Ⅰ動詞1 （物體位置不斷變化） move; revolve 2 （搬運; 運輸） carry; transport 3 （運用） use; wield...
  • 方 : Ⅰ名詞1 （方形; 方體） square 2 [數學] （乘方） involution; power 3 （方向） direction 4 （方面） ...
  • 程 : 名詞1 （規章; 法式） rule; regulation 2 （進度; 程序） order; procedure 3 （路途; 一段路） journe...
  • 運動 : 運動[舊時用語] arrange things or get things done through pull
  1. A new numerical procedure for analyzing the coupled vibration of a framed arch bridge with a single moving vehicle is presented to solve the equations of motion of a bridge with many degrees of freedom. the procedure consists in dividing the bridge - vehicle systems, which are solved separately, into 2 subsystems at the interface of the bridge and vehicle. the compatibility at the interface is obtained by an iterative procedure with aitken acceleration

    本文提出新的計算橋梁車激振動反應的方法，車?橋系統被分成兩個相互作用的子系統，這兩個子系統通過接觸點的協調條件耦合在一起，從而應用aiken動態加速法對橋梁運動方程、車輛運動方程和車?橋耦合方程進行高效迭代求解。
  2. 2. dynamic meteorology : equations of motion ; geostrophic, ageostrophic and gradient winds ; thickness and thermal wind ; continuity equation ; stream function ; vorticity equation ; divergence equation ; omega equation ; rossby wave ; ekman layer ; numerical weather prediction

    2 .動力氣象學：運動方程地轉風非地轉風及梯度風厚度及熱成風連續方程流函數渦度方程輻散方程奧米茄方程羅斯貝波埃克曼層數值天氣預報。
  3. By analysing the relationship among the parameters such as substrate, speed, tension, rotational speed, shape distortion of paper etc, this article put forward a control law to control the drive transmission roller in emery cloth and sand paper production line, the principle is based on hooke ' s law

    摘要本文根據彈性力學中的虎克定律，結合砂布砂紙生產特點，分析計算了生產線中基體、應變、速度、張力、轉速等參數之間的關系，建立了砂布砂紙生產線中傳動輥轉速（頻率）運動方程。
  4. For obtaining the numeral solutions of round elastic plates in axisymmetrical deformation with varying - thickness in nonlinear deformation in the unsteady electromagnetic field and mechanical field, by establishing the equations of motion, the equations of distortion, the equations of lorentz force, the equations of electronic dynamic mechenical, and adopting iterative method, we gained the nonlinear magneto - elastic calculation method and outcome of current - carrying shell, and gained the influencing degree toward mechanical parameter of varying thickness round ferreous plates in the electromagnetic field and mechanical field

    摘要為了獲得內邊界固定的環形導電薄板在均布力與橫向磁場作用下的變形問題的數值解，通過建立運動方程、變形方程、電動力學方程和洛侖茲力方程，運用迭代法得出了載流板殼的非線性磁彈性的計算方法和結果，以及機械場、電磁場對鐵質變厚度圓板各力學參量的影響程度。
  5. This method applies the extended strip theory to establish the nonlinear ship motion equations in regular head seas, obtains stable time course by resolving in time domain, and then pressure vectors will be available. the pressure includes static pressure, incident waves pressure, diffraction pressure, radiation pressure, and wave impact pressure, and changed with instantaneous draft of each intersection

    該方法應用擴展的切片理論建立迎浪規則波中船舶非線性運動方程，通過時域步進求解獲得船舶剛體運動的穩定時歷，進而給出與船體各橫剖面瞬時吃水相對應的靜水壓力變化、入射波壓力、繞射壓力、輻射壓力和波浪沖擊壓力諸分量。
  6. The last part of this paper designed a simple three - dimensional proportion homing rule according to three - dimensional opposite equation of motion of missile - target. and the simulation of the big - loop of terminal guide, control and motion was given

    最後根據導彈?目標的三維相對運動方程設計了一種簡單的末端三維比例制導律，並對導彈的末制導、控制以及運動大迴路進行了綜合模擬。
  7. Euler equations of hydrokinetics

    歐拉鈴運動方程
  8. The physical phenomena of underwater explosion are analyzed, and the initial velocity equations and dynamics equations of water particles, which compose the water columns, are set up

    從分析水中爆炸的物理現象入手，建立了構成水柱的各水粒子的初始速度計算模型，結合水粒子的受力情況，給出了水粒子的運動方程。
  9. Using fluent software, calculate the aerodynamic parameter of projectile and sabot. 3 ). according to motion equations of sabot and parameter obtained above, calculate and analysis flying motion variety of sabot

    3 ）利用fluent軟體計算得出的彈托氣動力參數，運用彈托的運動方程，計算並分析30mm脫殼穿甲彈的彈托飛行運動變化規徘。
  10. In addition, the second part of text adopts mmg segregative math model and correlative series test result and built ship manoeuvre movement equation of one propeller and one rudder ocean transport ship in still deep water. besides, the text used math model to workout calculated program that was modeled on ship ' s turning trajectory and zigzag manoeuvre

    另外，論文後半部基於mmg分離式數學模型及相關的系列化試驗結果，建立了單槳單舵海洋運輸船舶在靜水中的船舶操縱運動方程，利用數學模型，編制了計算程序，對船舶回轉運動、 z形操縱運動進行了數學模擬。
  11. By means of the analysis on motion equation of simple pendulum, a method for testing the moment of inertia of a complex shaped rigid - body moving around a fixed axle under the condition of not knowing the barycentric position of the object was obtained

    摘要通過對單擺運動方程的分析，得到了未知物體質心位置條件下測試復雜形狀剛體繞定軸轉動慣量的方法。
  12. Based on the basic relations of mechanics, electrics and magnetics, the governing equations which are expressed in term of displacements of ux, uy and uz, electric potential and magnetic potential are derived for transversely isotropic magnetoelectroelastic medium

    從橫觀各向同性磁電彈性力學運動方程、本構關系、電學和磁學方程出發，導出了用位移u _ x ， u _ y ， u _ z ，電勢和磁勢表示的磁電彈性介質的控制方程組。
  13. Then fourier transformation is employed to solve equations of motion of the rings, bulkheads, stringers and fluid respectively, with their reactions ( moments ) expanded by the shell ' s in - vacuo modes. by means of continuity conditions on the interfaces between the shell and the stiffeners as well as the fluid, and inverse fourier transformation, the modal reactions ( moments ) are finally expressed by the shell ' s modal velocities

    然後用fourier變換分別求解環肋、艙壁、縱骨和流場的運動方程，將它們對殼體的作用力（力矩）用殼體周向模態展開，利用它們與殼體在連接處位移連續條件以及fourier逆變換得到用殼體速度表示的模態相互作用力（力矩） 。
  14. The best scheme was chosen after analysis and comparing and the structure was designed. at same time, the kinematics analysis was conducted, coordinate transformation matrix using d - h method was set up, and the kinematics equation direct solution and inverse solution was deduced, the velocity jacobian matrix was constructed using vector product method, and the values of displacement and velocity of some special point including the wrist point were calculated. secondly, the working space of the robot was analyzed and the axes section of practical working space was drawn

    首先，作者針對機器人的設計要求提出了多個方案，對其進行分析比較，選擇其中最優的方案進行了結構設計；同時進行了運動學分析，用d - h方法建立了坐標變換矩陣，推算了運動方程的正、逆解；用矢量積法推導了速度雅可比矩陣，並計算了包括腕點在內的一些點的位移和速度；然後藉助坐標變換矩陣進行工作空間分析，作出了實際工作空間的軸剖面。
  15. Due to the moving base existence of the minehunting and the frame structure characteristic of the sonar array, a new modeling thought in which the boat body coordinates is regarded as moving coordinates and the whirligig equation of sonar array compared with the self coordinates is founded on the basis of the euler ' s theorem and the coordinate transform is introduced. the dynamic equations of minehunting sonar array with the state matrix form are founded by settling the dynamic models with the vector form. so it offers theory foundation for analyzing the dynamic characteristic and designing robust control

    由於獵雷艇作為動基座的存在和聲納基陣的框架結構特點，提出了以艇體坐標系為運動坐標系，運用變形的歐拉定理和坐標變換建立聲納基陣相對自身坐標系的旋轉運動方程的建模思想；將所建立的矢量形式的動力學模型展開整理，獲得了狀態矩陣形式的獵雷聲納基陣動力學方程，為系統動力學模型的實用化奠定了基礎。
  16. Abstract : in this paper, an analytical study of the dynamics of the piston in a reciprocating internal combustion engine is conducted. the equations of reynolds and moving of piston are derived. a useful method of solution is obtained. the method is applied to s1100 diesel engine. the results of this study indicate that piston oil film is found to be sensitive to the piston - cylinder bore clearance, the location of the wrist pin and lubricant viscosity

    文摘:對往復式內燃機活塞的動力特性進行了分析研究，導出了活塞潤滑的雷諾方程和活塞運動方程，給出了可供實用的求解方法，並採用這種計算方法對s1100柴油機進行了設計計算與試驗研究.研究結果表明，活塞潤滑油膜歷程與活塞& &缸套的間隙、活塞銷的位置、潤滑油的粘度等因素密切相關
  17. The terminal states of the vehicle at the taem ( terminal area energy management ) interface box were predicted through the integration of the equation of motion, and to correct the state errors which the angle of attack and the bank angle were corrected in real time

    通過對運動方程積分預測飛行器在能量管理段界面處的終端狀態，實時調整迎角和傾側角方案，以使終端狀態誤差滿足要求。
  18. The theory of minimum entropy production or minimum rate of energy dissipation shows that a river is stable when it is in a relative equilibrium condition. ( 3 ) the river facies formulas of alluvial river have been developed using the theory of minimum rate of energy dissipation together with flow continuity and motion equations, suspended load transport or bed load transport equation. ( 4 ) the causes of the river patterns are explained using the theory of minimum rate of energy dissipation

    （ 3 ）基於最小能耗率原理，以水流能耗率作為目標函數，以水流連續方程、水流運動方程及懸移質挾沙力公式或推移質輸沙率公式作為約束條件，通過對目標函數求條件極值，分別推導出以懸移質造床為主的顯式河相關系式和以推移質造床為主的顯式河相關系式。
  19. Since these theoretical analyses are based on inviscid potential flow theory, theoretical calculation and computational simulation may complement each other. the hydrodynamics and undulating propulsion of specimens were studied using three dimensional computational fluid dynamics ( cfd ) modeling. the cfd analysis using kinematic model of undulatory dorsal / median fin draws a series of conclusions, which include that the body drag increases significantly with the lateral body oscillation ; the body drag is minimum while the start point of

    計算結果表明游動過程中的形體阻力隨側向周期性擺動而增大;當背鰭前端位於身體側向最寬處時，形體阻力具有局部最小值，結論與實驗觀測結果相吻合;在實驗觀測的典型運動參數下，波動面的運動方程中的非對稱因素的出現使推進力增大約1 . 10倍。
  20. Abstract : the shaping equation of steamed bread in circular trough camber of shaping roller, the instantaneous velocity of its surface, and the strength by shaping roller were analyzed during shaping, then a theory base for the design of steamed bread shaping machine was provided

    文摘:分析了饅頭成型過程中成型輥上圓弧槽曲面內饅頭生坯的運動方程，饅頭表面動點瞬時速度及饅頭成型時受力分析，為饅頭成型機的設計提供了理論依據。
分享友人
分享到 Line

分享到臉書