運動流度 的英文怎麼說

中文拼音 [yùndòngliúdù]
運動流度 英文
coefficient of mobility
  • 運 : Ⅰ動詞1 （物體位置不斷變化） move; revolve 2 （搬運; 運輸） carry; transport 3 （運用） use; wield...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 運動 : 運動[舊時用語] arrange things or get things done through pull
  1. There are several procedures used to reduce these deteriorating effects, including the use of forward error correction techniques, error concealment methods and error resilience schemes. this paper studies error resilient techniques in internet video transmission. in this techeniques, reed - solomon ( rs ) codes across packets is used for error protection against packet loss, and a self - adaptive error concealment method based on motion feature is proposed, which can conceal errors more effectively, particularly for video sequences with acute motion

    本文針對因特網視頻傳輸中的丟包現象進行研究，一方面利用rs編碼來提高視頻壓縮碼流抵抗誤碼的能力；另一方面，提出了一種基於運動特徵的自適應誤碼掩蓋方法，能夠較好的掩蓋視頻傳輸帶來的誤碼，特別對于運動幅度較大的視頻序列更能體現出其優勢。
  2. The system of piv is constructed suitable for measuring the particle movement and the flow pattern of particle clusters is visualized in the cfb. under the low and high solid flux, this work also study the aggregate properties such as the two - dimensional shapes, velocity and existence time of clusters on several axial / radial positions

    對循環流化床冷態實驗臺兩測試段進行了流型和顆粒團可視化研究，分別獲得了較低循環流率下過渡區和在高循環流率下稀相區顆粒團的運動速度，形狀，持續時間及其動態變化情況。
  3. The process parameters of electric upsetting include : velocities of upsetting cylinder and anvil cylinder, heating current, preheating length and time, etc. because different materials have different mechanical, electric and thermal characteristics, and there are effects between different parameters, the determination of those parameters becomes a complex problem

    電熱鐓粗成形過程的工藝參數主要包括鐓粗缸活塞運動速度、砧子缸活塞運動速度、鐓粗壓力、加熱電流和預熱長度等。這些參數的選擇是一個復雜的問題，其復雜性不僅在於不同的材料具有不同的力學、電和熱傳導特性，而且各參數相互影響、相互制約。
  4. Then these separated interferograms can be recorded by ccd camera the experiments with the multi - frame interferometer was carried out on a small gas - puff z - pinch device with 23 kv working voltage and 210 ka peak current and about 2 risetime, and good results were obtained

    該套干涉儀在小型噴氣式z箍縮裝置上進行了實驗， z裝置的工作電壓23kv 、峰值電流210ka 、電流上升時間約2 。根據干涉圖條紋的移動數，可以計算出等離子體的電子密度和運動速度。
  5. Analysis of particle speed in fluid using digital image correlation techniques

    用數字圖象相關技術分析流體中粒狀物的運動速度
  6. Speed of charge and distribution of displacement current

    電荷的運動速度與位移電流的分佈
  7. A lot of results are made from calculating of case for geothermal reservoir property of earth energy within 200 2000 ( m. ) ， it is helpful to analysis influence of permeability coefficient, kinematic viscosity and thermal diffusion coefficient of soils and rocks on heat transfer performance

    在地表熱能熱儲物性為200 - 2000 （ m . ）的范圍內進行的理論計算，得到了許多重要結果，為分析巖土層滲透系數、流體運動粘度和導溫系數等對傳熱量的影響打下了良好基礎。
  8. The results demonstrate that the bubble velocity will increase with the increasing of the bubble volume, decreasing of resin viscosity and external pressure

    此外，樹脂種類和樹脂流動狀態對氣泡的運動速度也有較大的影響。
  9. Experimental process shows that variance of underwater distributary channel and declining rate of lake plane are closely related to moving intension of motive soleplate

    實驗過程顯示，水下分流河道的變遷與湖平面的下降速率及活動底板的運動強度密切相關。
  10. Three models are proposed as follows by applying the model of " mixed flow " : the stress of increasing fluid on fouling, collision between solid particles and fouling, and solid particles movement velocity ; the effects of operating parameters, properties of particles, and the volume fraction of particles on stress in solid - liquid two phase flow, collision stress between solid particles and fouling, maximal contacting area between solid particles and fouling and maximal contacting time between solid particles and fouling are investigated systematically by calculating and theoretical analysis

    利用「混流」模型，建立了兩相流體的剪應力模型、固體顆粒與垢層的碰撞模型和固體顆粒的運動速度模型；通過計算和理論分析，系統地考察了操作參數、顆粒物性、顆粒體積分率等對固液兩相流剪應力、顆粒對垢層的碰撞力、顆粒與垢層的最大接觸時間和最大接觸面積的影響。
  11. Under the low solid flux, the particle velocity in the whole flow field was processed by mqd in the transitional flow regions. the results show that the variation of particle velocity with the time and the influence of particle clusters in the real time. under the high solid flux, in the dilute flow region, the particle velocity is analyzed and discussed with the variation of operating condition

    在低循環流率下對過渡區典型流態下顆粒團的不同流態進行了mqd法處理，獲得了整場顆粒運動速度及隨時間變化規律，顆粒團運動對流場內顆粒速度的動態影響；對稀相區在較高固粒流率下對顆粒運動速度進行了變工況分析和討論。
  12. Based on prandtl ' s momentum transportation, this paper calculates in detail the physical quantities such as eddy viscosities, and ratio of eddy viscosity to motion viscosity, total stresses with respect to relative position in three regions of viscous sub - layer, buffer layer, and main turbulent stream for non - newtonian fluid flowing turbulently in ducts, which according to karman ' s three layer models and measurement of fluid parameters in evaluation apparatus, discusses the influence of polymer drag reduction on flowing properties of non - newton fluid, analyzes quantitatively principle of turbulent reduction phenomenon and condition of increasing reduction rate

    摘要以普蘭德動量傳遞理論為基礎，按照卡門的三層模型，通過室內模擬環道用0號柴油及加入減阻劑在圓管內的流動參數的測定，計算了非牛頓型流體管內湍流邊界層的層流內層、過渡層、湍流中心的渦流粘度，渦流粘度與運動粘度比、總應力隨相對位置的變化等定量參數，探討了高分子減阻劑對非牛頓流體流動特性的影響，對湍流減阻現象的機理與增大減阻率的條件進行了定量分析。
  13. In the part of the design of hydraulic loading system, constituting project of the hydraulic loading system of current test bench through comparing and analysing international and national current hydraulic loading projects and working out the pressure and flux of which according to the load and velocity and structure dimension of hydraulic executor - actuator. thus, choosing the power and hydraulic component and designing hydraulic loop

    在液壓加載系統設計部分，通過對國內外常用的幾種液壓加載方案的對比研究，最後確定了本試驗臺的液壓加載方案。根據液壓執行元件? ?油缸的外載荷、運動速度和結構尺寸我們便可以確定液壓加載系統的壓力和流量。
  14. In order to research the eddy current electromagnetic force that varies with the relative speed, including brake force and attraction, the high speed simulation test stand for track eddy current brake was developed

    為了研究渦流電磁力包括渦流制動力的電磁吸力，在不同的相對運動速度下的變化規律，研製了軌道渦流制動試驗臺。
  15. Based on the characteristics of the membrane structures, wind - induced nonlinear coupling dynamic response analysis which can be applied to closed membrane structures is developed and the added air mass the pneumatic stiffness and the acoustical damping of the closed membrane structures are deduced. applying the method to an aeroelastic model of wind tunnel test, the displacement the velocity and the acceleration of corresponding prototype structure in time domain are obtained

    本文針對封閉式薄膜結構和敞開式薄膜結構推導了全新的非線性流固耦合風振響應公式，其中耦合因素包括附加空氣質量、氣承剛度和聲致阻尼以及相對運動速度，並將此理論應用於一氣彈模型的計算，獲得了位移、速度、加速度時程以及加速度均方根。
  16. The curl was invented to help describe the properties of moving fluids.

    創造旋度一詞為了有助於描述運動流體的性質。
  17. The deep karst groundwater has been clearly investigated on dynamics characters such as the retention time, the transportation speed, the flowing direction etc, and on the hydrodynamic connection with other groundwater aquifers

    調查了深部巖溶地下水的滯留時間、運動速度、徑流方向等動力學特徵，以及它們與其它地下含水層之間的水力聯系。
  18. In the experimental data processing, the application of mqd cross - correlation arithmetic is successful in obtaining the properties of particle velocities under different operating conditions

    在對循環流化床冷態試驗臺進行piv測試試驗研究中，運用mqd互相關處理演算法獲得了不同工況下顆粒運動速度參數的分佈規律。
  19. The paper gets some information about the outlines, velocity, areas, and change of gas films and internal contracts of balls in different sizes by using subtract operation, binary image, fill holes of images, and so on

    通過利用差影演算法減少背景噪聲、圖像的二值化處理和填充處理、氣泡特徵分析、氣泡中心坐標的確定等得到兩相流中氣泡、液滴和顆粒的尺寸和運動速度以及氣膜分佈等兩相流重要參數。
  20. Applied the above theory and the dem program trubal, the unilateral compress problems for the regular generated particles with an interstitial fluid are studied, and the macro - strain - stress curves varied with the fluid properties and the velocity of the wall are gotten. then, he unilateral compress problems for the random generated particles are numerically simulated, and the macro - strain - stress curves are obtained. moreover, the numerical simulation results for the dry and moist cases are compared

    利用上述理論以及demtrubal程序，研究了存在填隙流體時顆粒規則排列單向壓縮問題，得到了宏觀應力應變曲線隨流體性質、壁的運動速度等的變化規律；並對隨機排列單向壓縮問題進行了數值模擬，得到了宏觀應力應變平均曲線；並對干、濕兩種情況下顆粒的模擬結果進行了對比。
分享友人
分享到 Line

分享到臉書