過度燃料空氣 的英文怎麼說

中文拼音 [guòdùránliàokōngqì]
過度燃料空氣 英文
overfire air
  • 過 : 過Ⅰ動詞[口語] （超越） go beyond the limit; undue; excessiveⅡ名詞（姓氏） a surname
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 燃 : 動詞1. （燃燒） burn 2. （引火點著） ignite; light
  • 料 : 名詞1 （材料; 原料） material; stuff 2 （喂牲口用的穀物） feed; fodder 3 （料器） glassware 4 （...
  • 空 : 空Ⅰ形容詞（不包含什麼; 裏面沒有東西或沒有內容; 不切實際的） empty; hollow; void Ⅱ名詞1 （天空） s...
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 過度 : excessive; over; undue; ana-; hyper-
  • 燃料 : fuel
  • 空氣 : 1 （大氣） air; atmosphere 2 （氣氛） atmosphere 3 （氣閘） air brake4 pneum ; pneumo ; pneumat ;...
  1. In the third chapter of this dissertation, based on the physical and chemical properties of hydrogen and the combustion characteristics of hydrogen, the quasi - dimension combustion calculation model of hydrogen ? fueled engine is set up through analyzing the characteristics of turbulence flame and chemical reaction kinetic of hydrogen ? air mixture. the model includes the dual ? area thermodynamics sub - model, quasi - dimensional turbulent entrainment combustion sub ? model, turbulence flame promulgating sub ? model, hydrogen - air mixture chemical kinetic sub - model and loss of heat transfer sub - model and so on

    本文從氫燃料的物化特性和燃燒特徵著手，通過分析氫空氣混合氣燃燒的湍流火焰結構和燃燒化學反應動力學，基於雙區燃燒模型，建立了包括雙區熱力學、準維湍流卷吸燃燒、湍流火焰傳播速度、氫空氣混合氣燃燒化學反應動力學以及傳熱損失等模塊的燃燒模型，並給出了相應的計算方法。
  2. In it, studies are carried out such as the combustion theory analysis of biomass briquetting, equipment design, thermal performance test, air flow field test, density field test in the hearth, temperature field test, the dreg characteristics, main design parameters and technological and economic evaluation, and so on. the author has gained all kinds of indexes of the equipment and the changing laws of air flow field, temperature field, density field, dreg and main design parameters. this will lay theoretical foundation on design, operation and technology improvement, meanwhile, this will offer actual guidance for development of equipment

    本文通過對「生物質成型燃料燃燒設備設計」 、 「生物質成型燃料燃燒設備熱性能試驗」 、 「生物質成型燃料燃燒設備空氣流動場試驗」 、 「生物質成型燃料燃燒設備溫度場試驗」 、 「生物質成型燃料燃燒設備爐膛內氣體濃度場試驗」 、 「生物質成型燃料燃燒設備結渣特性試驗」 、 「生物質成型燃料燃燒設備主要設計參數確定試驗」及「生物質成型燃料燃燒設備技術經濟評價」等方面的系統研究，獲得了生物質成型燃料燃燒設備各項性能指標及燃燒空氣流動場、溫度場、濃度場、結渣性能、主要設計參數變化規律。
  3. Abstract : the in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    文摘:針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況，提出了若干技術改造措施包括，增大對流管表面積以增大對流段的熱負荷；增加輻射管的換熱面積；修正煙囪高度；換用新型燃燒器，變自然通風為強制供風，以增大燃燒器的發熱量，減小過剩空氣系數，節省燃料2 % 3 % ；在對流段和煙囪之間增設空氣預熱器以提高空氣入爐溫度；採用高溫輻射塗料增強輻射換熱效果，從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。
  4. The in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況，提出了若干技術改造措施包括，增大對流管表面積以增大對流段的熱負荷；增加輻射管的換熱面積；修正煙囪高度；換用新型燃燒器，變自然通風為強制供風，以增大燃燒器的發熱量，減小過剩空氣系數，節省燃料2 % 3 % ；在對流段和煙囪之間增設空氣預熱器以提高空氣入爐溫度；採用高溫輻射塗料增強輻射換熱效果，從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。
  5. This hot blast stove has following features : the highest temperature of flue gas in general flue reaches 600 ; the air and gas are preheated to 300 ; the hot blast temperature is over 1200 ; the flue gas temperature is below 180

    使用該熱風爐后所取得的效果是：總煙道內綜合排煙溫度可達600 ；可將空氣、煤氣預熱到300 ；以單一高爐煤氣為燃料時，熱風溫度可達1200以上；煙氣經過空氣、煤氣換熱器后溫度低於180 。
  6. Axial - flow ventilation fan is applicable to canging air ordissipating hear at such places as metal lurgical factory, steel rolling mill, chemical plant, refrigerating chamber, restaurant, grain depot, cultivating field, tunnel, storehousr, residence, ect. while removed the shell, it in the long echaust pipe with series connection method. the fan has complex structure, low noise, wide power selective range

    72型離心通風機可作為工三及大型建築的室內通風換氣，還可作輸入氣體，輸送空氣或其它不自燃的對人體無害的，對鋼鐵材料無腐蝕性的氣體，氣體溫度不得超過80 。
  7. What ’ s more, the emissions of the nox and pm are quite lower because of its unique homogeneous charge and low temperature combustion process

    分析了進氣溫度、過量空氣系數和egr率對乙醇燃料hcci燃燒的影響規律。
  8. Abstract : at measurement of the temperature increasing and analysi s of gas composition in the pellet layers during reduction of iron ore - coal pel let in air, it is found out that released volatile from the pellet is fired when the pellet is heated to the beginning temperature of fast release of volatile, and after the heat output of fired volatile heats the pellet to the beginning tempe rature of fast reduction by carbon, combustion of co generated by the reduction of carbon takes place and the heat output of burnt co is transferred into the pel let to supply the endothermic reduction in the pellet

    文摘:通過測量鐵礦-煤球團在空氣中還原時料層溫度上升規律和氣體成分變化情況，得出了球團被加熱到揮發分開始激烈析出溫度時，揮發分開始燃燒，放出的熱是將球團加熱到碳的直接還原開始激烈進行溫度時，碳的還原產生的co氣體開始燃燒，提供球團還原耗熱
  9. At measurement of the temperature increasing and analysi s of gas composition in the pellet layers during reduction of iron ore - coal pel let in air, it is found out that released volatile from the pellet is fired when the pellet is heated to the beginning temperature of fast release of volatile, and after the heat output of fired volatile heats the pellet to the beginning tempe rature of fast reduction by carbon, combustion of co generated by the reduction of carbon takes place and the heat output of burnt co is transferred into the pel let to supply the endothermic reduction in the pellet

    通過測量鐵礦-煤球團在空氣中還原時料層溫度上升規律和氣體成分變化情況，得出了球團被加熱到揮發分開始激烈析出溫度時，揮發分開始燃燒，放出的熱是將球團加熱到碳的直接還原開始激烈進行溫度時，碳的還原產生的co氣體開始燃燒，提供球團還原耗熱
  10. The engine mapping data, vacuum degree and a lot of other data can be gained by engine mapping. this article used these data to analyze the factors that impact on dynamic performance of engine deeply, then drawn a conclusion that the throat area and the shrinking degree of the mixer are the main parameters

    通過發動機臺架試驗，獲得發動機外特性和進氣真空度等大量的實驗數據，在這些實驗數據的基礎上，對影響汽油cng兩用燃料發動機動力性的因素進行了深入地分析，結果表明混合器的入口角度和喉口面積是影響兩用燃料發動機動力性的主要參數。
  11. In this combustion mode the mixture, composing of the fuel, air and the recirculated exhaust gases ( egr ), is compressed, auto - ignited, combusted

    成功的實現了乙醇燃料hcci燃燒的測控平臺。研究結果表明:進氣溫度、過量空氣系數和egr率對乙醇燃料的hcci燃燒有重要影響。
分享友人
分享到 Line

分享到臉書