過載電流開關 的英文怎麼說

中文拼音 [guòzǎidiànliúkāiguān]
過載電流開關 英文
excess current switch
  • : 過Ⅰ動詞[口語] (超越) go beyond the limit; undue; excessiveⅡ名詞(姓氏) a surname
  • : 載Ⅰ名詞(年) year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  • : Ⅰ動詞1 (使開著的物體合攏) close; shut 2 (圈起來) shut in; lock up 3 (倒閉; 歇業) close down...
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  1. It can open and shut and bear the normal electric current of the operating return circuit. it also can open and shut and bear the limited overload electric current within stipulated time

    它能合、承斷運行迴路正常,也能在規定時間內合、承斷規定的
  2. 1 m 0. 5, the phase - shifted angle 6 is controlled in term of sine law which makes the magnitude of resonant voltage track a reference sine voltage, and the resonant voltage is rectified, filtered, inverted and then the better sine - voltage output is obtained, theoretical analysis and experimental results show that for the resistive load and inductive load, the switches of leading leg of the phase - shift - controlled circuit are always turned on at zvs, and ones of lagging leg are turned on at zvs ( < 0 ) or turned off at zcs ( ( > 0 ), moreover, all switches in the low - frequency inverter are always turned on and off at zvs, the measured circuit efficiency for rated load reaches up to 88 %

    從功率單向動角度出發,提出了一種lcc諧振型恆頻移相單相高頻鏈逆變路拓撲,在調制系數0 . 1 m 0 . 5情況下,控制移相角按正弦規律變化,使諧振壓脈沖列的幅值追蹤參考正弦壓信號,經、濾波、低頻逆變,從而獲得正弦度較好的輸出壓。理論分析和實驗結果證明對于阻性負或阻感性負,移相全橋具有超前橋臂零通,滯后橋臂或者零通( _ 0 )或者零斷( _ 0 )的軟特性,而低頻逆變器的各個均實現零壓條件下的通與斷。
  3. Product this company, brush of british, high - handed limit that manufacturing technology produce to flow fuse box, products suitable for family exchenge 50hz, specified voltage 3kv kv, 6kv 7. 2kv, 12kv 15kv system, can cooperate and is used with other protection electric apparatuses such as the on - load switch, vacuum contactor, as high - handed motor, electric power voltage transformer and electric power overload or holding up of equipment, etc. protect the component

    本產品是英國brush公司高壓限熔斷器製造技術生產的,產品適用於戶內交50hz ,額定壓3kv 3 . 6 kv , 6kv 7 . 2kv , 12kv , 15kv系統,並可與其它保護器如負荷,真空接觸器配合使用,作為高壓動機,力變壓器及力設備的或短路等保護元件。
  4. Product this company, brush of british, high - handed limit that manufacturing technology produce to flow fuse box, products suitable for family exchenge 50hz, specified voltage 3kv kv, 6kv, 12kv 15kv system, can cooperate and is used with other protection electric apparatuses such as the on - load switch, vacuum contactor, as high - handed motor, electric power voltage transformer and electric power overload or holding up of equipment, etc. protect the component

    本產品是英國brush公司高壓限熔斷器製造技術生產的,產品適用於戶內交50hz ,額定壓3kv 3 . 6 kv , 6kv 7 . 2kv , 12kv , 15kv系統,並可與其它保護器如負荷,真空接觸器配合使用,作為高壓動機,力變壓器及力設備的或短路等保護元件。
  5. Zero - voltage turn - on and zero - voltage turn - off in lagging arm and leading arm of soft - switching topology, working waveform of power transformer and process of rectifier and transition are presented in detail. the influence of resonant inductance of the power transformer, resonant capacitor and variation of load to the process of soft - switching are given

    主要對軟滯后橋臂和超前橋臂的零通、程,功率變壓器的工作波形及整程進行了詳細的模擬分析,並重點討論了逆變器的諧振感、諧振容以及負變化對軟程的影響。
  6. There are five parts are as follows : in part one, the concept of switching function is introduced first to establish the nonlinear mathematical model of the induction motor variable frequency speed adjustment system which is fed by a sine pulse width modulated ( spwm ) inverter and takes the effect of the main magnetic circuit saturation into consideration, then the low frequency oscillation of the system is simulated according to the model. next, from the view point of energy conversion of the inverter - induction system, a criterion for the low frequency oscillation is proposed to determine whether the system is in low frequency oscillation which is judged by whether the interval of the negative current component of the inverter input current is more than 1 / fc ( fc is the carrier wave frequency of the inverter ) or not

    首先引入函數概念,建立了正弦脈寬調制( spwm )逆變器供異步動機,考慮主磁路飽和時的變頻調速系統整體數學模型,模擬系統的低頻振蕩;其次從逆變器-異步動機系統能量轉換角度出發,提出通檢測逆變器輸入中負的間隔時間是否大於1 / f _ c ( f _ c為逆變器波頻率)來判定系統是否出現低頻振蕩;最後的實驗結果驗證了系統低頻振蕩建模和判據的實用性和正確性。
  7. The sieries product is suitable for the system with current 50hz - 60hz and the rated voltage of 3. 6kv 40. 5kv. it can be matched with other protective electrical equipment vacuum connection, loading switch etc. it can also be used as the overload or short circuit protection parts for high voltage motor, transformer, voltage mutual inductance attenuator and other power equipment

    本系列產品適用於交50hz - 60hz ,額定壓3 . 6kv 40 . 5kv系統,可與其它保護器如真空接觸器,負荷等配合使用,作為高壓動機力變壓器壓互感器及其它力設備的或短路保護等元件。
  8. Compressor overload protector, over - current protector, high and low pressure switch, temperature protection

    壓縮機保護器,超保護器,高低壓,溫度保護
  9. In order to avoid the current ripple and the high switch frequency of fixed - band hysteresis current controllers, two hysteresis controllers of change hystersis - band are proposed. one is the sinusoidal - band hysteresis current controller, the other is the adaptive hysteresis current controller based on fuzzy theory

    由於常規的滯環控制器不能有效地防止負脈動,並且存在著容易導致逆變器的器件的頻率高的問題,論文提出了兩種變環寬滯環控制器結構,其一是正弦環寬滯環控制器,其二是模糊變環寬滯環控制器。
  10. When switching the no - load overhead lines by alternating - current high - voltage circuit breaker which is a kind of daily operations in electric power system, over - voltage is probably bringed out and insulating property of the electric devices is breakdowned sometimes, especially, when occuring re - strike. the main purposes that the tests on switching line - charging current are performed in the laboratory are assessing re - strike performance of circuit - breakers. according to the test results, the design of the circuit - breaker is optimized and re - strike performance is improved

    高壓斷路器是力系統中最鍵最重要的設備之一,斷路器合空架空線路是力系統中常見的操作,操作程中通常會出現壓,對系統絕緣造成威脅,嚴重時會破壞系統的絕緣性能,發生事故,隨著力系統壓等級的提高、輸線路不斷延長及傳輸容量的增大,由操作壓引起的絕緣閃絡、設備破壞事故的幾率更加突出。
  11. It can turn on, bear and break normal current in circuit, but also bear and break the overloaded current within stipulated time

    它能合、承斷運行迴路正常,也能在規定時間內合、承斷規定的
  12. The tap - changer is made with solid state relay as its working mechanism and controlled by microprocessor. this switch has totally cancelled the mechanical drive organization, by the microprocessor according to the voltage of second side microprocessor decide the working condition of solid state rely, high regulation speed, need not transition resistor, rush current is low. operating frequently ; there is no electric arc to produce, can put in the fuel tank of the voltage transformer directly ; the structure is simple, the fabrication cost is low, benefit and use widely among the voltages transformer of distribution

    其中的有調壓分接,它是一種完全由固態繼器作為分接執行機構,由單片機控制的有自動調壓的變壓器分接。該完全取消了機械傳動機構,由單片機根據變壓器二次側壓的高低,決定與變壓器各分接頭聯接的固態繼器的工作狀態。調節速度快,改變分接頭時不需阻,沖擊小,可頻繁操作;無弧產生,可以直接放在變壓器油箱中;結構簡單,造價低,便於在配變壓器中推廣使用。
  13. In this paper, associated with the key problem of 550kv sf6 high voltage circuit breaker which is used in gis of three gorges project, the mathematical models of static electrical field and one - dimensioned and two - dimensioned gas flow field during the overall breaking process in arc chamber of circuit breaker are developed. on the basis of gas discharge theory, the criteria to judge the interruption success is determined. through the combination of one - dimensioned and two - dimensioned gas flow field software, the problem that the primary two - dimensioned gas flow field software ca n ' t calculate the hot gas flow field has been effectively solved

    本文結合長江三峽550kvgis中sf6斷路器的科技攻項目,建立了斷路器程中滅弧室內靜場、一維氣場、二維氣場的數學模型;根據氣體放的基礎理論選定了衡量斷路器能否成功斷的標準,並通一維和二維氣場的有機結合,有效地解決了原二維氣場計算軟體無法計算有斷的難題,具有較強的工程實用性。
  14. The measuring range and any available overload that can be used tare can be compared on site by means of dip switches

    任何用直驅動的應變力傳感器都和它連接。通dip可以現場比較量程和可用皮重。
  15. In chapter 3, according to the requirements of high voltage power supply used for charging capacitors with constant current, the series resonant converter ( src ) was chosen as the main circuit frame. the dynamic process of src was discussed by using mathematical analyses and numeric simulation to study the operational characteristics, the effects of parameters of resonant circuit on them and the relationship between switching frequency and out put power, which provided the bases of designing the power supply

    第三章中根據高壓容恆源的運行特點,選擇了串聯負諧振變換器作為主路結構形式,並對其動態程進行了數學分析及數值模擬,討論了該路的運行特點、諧振迴路參數對運行特性的影響以及工作頻率與功率輸出的系,為源的設計提供了依據。
分享友人