邊頻電流 的英文怎麼說

中文拼音 [biānbīndiànliú]
邊頻電流 英文
side frequency current
  • 邊 : 邊Ⅰ名詞1 （幾何圖形上夾成角的直線或圍成多邊形的線段） side; section 2 （邊緣） edge; margin; oute...
  • 頻 : Ⅰ形容詞（次數多） frequent Ⅱ副詞（屢次） frequently; repeatedly Ⅲ名詞1 [物理學] （物體每秒鐘振動...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 邊頻 : boundary frequency
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  1. The second, at the high frequency primary coil, when switch turn on with control signal ( the spwm pulse is modulated ), in the positive or negative semi - period of low frequency modulation signal, transformer coil with same direction voltage. the magnetic flux of transformer core will increase step by step. at the end, it leads to magnetic flux saturation

    二、在高頻變壓器原邊，當開關管接收控制信號脈沖列（經調制的spwm波列）導通時，在低頻調制信號的正半周或負半周內，施加在變壓器繞組上的是同一方向的電壓，變壓器磁芯中的磁通可能將級進地逐漸增加，導致磁芯飽和，造成磁偏或單向磁化，導致低頻電信號放大失真或由於很大的磁化電流而無法正常工作。
  2. The product is suitable for double straight line smoothing of grinding flat glass. coarse grinding, fine grinding, and polishing can be done at one time. adopt plc control system, which sets processing parameters via interface, and finishes processing at one time, ti has stable bottom structureprecise and smooth transmission system, the transmission belt drive adopts strong power and tran - sfrequency motor to control speed, constant power, constant rule, output and advanced equipment to control, completed product has high polishing level, which is an ideal option assistant processed equipment of processing delicacy glass and furniture glass factory

    本產品適用於磨削平板玻璃是雙直線平邊，粗磨精磨拋光一次完成採用plc控制系統通過界面設定加工參數次完成加工，具有穩重扎實的底座結構，精確流暢的傳動系繞，傳送皮帶驅動採用功率變頻電機調速控制，恆功率恆扭矩輸出和高配置的控製成品拋光亮度高是加工精品玻璃和傢具玻璃廠家使用的最佳輔助加工設備。
  3. One is that the operation duty cycle can not be larger than 50 % because of the requirement for the transformer resetting. as a result, the voltage stress of the secondary diode is high, which limits the usage of dfc in high output voltage application

    但由於變壓器磁芯復位的需要，其工作占空比必須小於50 ，從而造成占空比利用率不高，變壓器副邊電壓高，副邊高頻整流二極體的電壓應力大。
  4. The content of this theme is as follows : without time, without open, without stopping railway transport, and without interrupting traction current of block tested, meanwhile track circuit parameters in electrical and no electrical blocks is measured of on - line, dynamic and real - time. these parameters include voltage of fsk signal, voltage of industrial and harmonic wave interference, upper frequency, lower frequency, carrier frequency and low frequency 18 messages frequency

    本課題研究內容：在不要點，不開天窗，不中斷行車，不中斷被測區段牽引電流的情況下，在線、動態、實時測量電化區段和非電化區段的移頻信號電壓、工頻干擾電壓，移頻信號（調頻信號）的上邊頻、下邊頻、載波頻率、以及低頻18信息頻率等參數。
  5. This processing line has two sszm1200c straight line double edgers and 90 transfer table. 30 spindles on each sszm12000c, high collocated, wheels. high - level of polishing ; compact and steady base, precise and smooth transfermission system ; big power frequency - conversion motor to control the speed of pedeail ; plc control system sets processing parameters via interface, to control the width and the speed, the minimum size of the glass can be 127xl27mm ; the structure of the machines is compact and stable. this line is our new designed products, and it s the ideal choice of assistant equipment for exquisite and industrial glass, besides, it can be used with other machines to form a production line set

    本生產線由2臺sszml200c玻璃直線雙邊機和1個90中轉臺組成每臺sszml200c玻璃直線雙邊機配置30個磨頭，磨輪配置多，加工拋光精度好底座穩重扎實，傳動系統精確流暢大功率變頻電機調速控制傳送皮帶驅動plc控制系統通過界面設定參數控制，最小加工玻璃寬度尺寸小至127127mm機器結構緊湊性能穩定，是我公司全新設計的力作是大批量精品玻璃和工業玻璃磨邊生產的暈佳配套設備，可口與夾膠印花，鋼化等生產線配套使用
  6. Based on comparison between the parallel - parallel and parallel - serial combination ttfc, a novel two - transistor forward converter with parallel - serial / serial combination is proposed. this converter reduces greatly the current overshoot of the primary side switches and the voltage overshoot of the rectifying diodes. moreover, the size and weight of the converter can also be reduced by interleaving technique and increasing frequency

    本文在對並-串型和並-並型雙管正激組合變換器進行了詳細比較研究的基礎上，提出了一種新型並-串串型雙管正激組合變換器，該組合變換器可以大大減小原邊開關管的電流應力和副邊整流電路中二極體的電壓應力；通過交錯控制及提高開關頻率，大大提高了變換器的功率密度。
  7. Sszm500b straight line double edgers, and 90transfer taboe. 26 spindles on each sszm2500b. plc control system sets processing parameters via interface, and finishes processing at one time. this product has stable structure. precise and smooth transmission system, thetransmission belt drive adopts strong power and transfrequency motor to control speed, constant power, constantrele output and advanced epuipment to control, high polishing efficiency. it is the best matched equipment of large batch of furniture and decorated glass edge production, and production, and can be matched with gluing, printing, reinforcing, etc. production line

    才用plc控制系統通過界面設定加工參數一次完成加工，具有穩定扎實的底座結果精確流暢的傳動系統，傳送皮帶驅動採用大功率變頻電機調速控制，恆功率恆扭矩輸出和高配置的控制。結構緊湊，性能穩定可靠，拋光及生產效率高。是大批量的傢具和裝飾玻璃的磨邊生產的最佳配套設備，可以與夾膠印花鋼化等生產線配套使用。
分享友人
分享到 Line

分享到臉書