重緊固螺栓 的英文怎麼說

中文拼音 [zhòngjǐnluóshuān]
重緊固螺栓 英文
schwerspannstift heavy-duty roll pin
  • : 重Ⅰ名詞(重量; 分量) weight Ⅱ動詞(重視) lay [place put] stress on; place value upon; attach im...
  • : Ⅰ形容詞1 (物體受到幾方面的拉力或壓力以後呈現的緊張狀態) taut; tight 2 (物體受外力作用變得固定...
  • : Ⅰ形容詞(結實; 牢固; 堅硬) firm; hard; solid Ⅱ副詞1 (堅決地; 堅定地) firmly; resolutely 2 [書...
  • : 1. [動物學] (軟體動物) spiral shell; snail; conch 2. (螺旋形的指紋) whorl (in fingerprint)
  • : 名詞1. (可開關的機件) bolt; plug 2. (塞子) stopper; cork
  • 緊固 : [設計] fastening; fixture緊固桿 anchorage bar; 緊固環 dead ring; 緊固夾 anchorage clip; 緊固件 fa...
  • 螺栓 : bolt; screw bolt; threaded bolt
  1. Repeat procedure with other body half and bolt together following the procedure noted above

    對另一半閥體復同樣的步驟,然後按照上述步驟用在一起。
  2. Pressure seal design without live load bonnet ( no spring washers ) : the gasket bolt tightness must be rechecked after operating test pressure and temperature has been achieved

    沒有動負載閥帽的壓力密封結構(沒有彈簧墊圈) :在工作試驗壓力和溫度達到限制值時,必須新檢查墊圈性。
  3. Using a wrench, reassemble the diaphragm assembly by turning the hex bolt clockwise to tighten

    用扳手,順時針方向旋轉六角新組裝隔膜總成,並將其
  4. The flange gasket bolts for the gate valves should be retightened during installation as the bolts may have loosened due to storage and shipping

    在安裝期間,閘閥上的法蘭墊圈應該,因為在庫存和運輸時可能會鬆懈。
  5. Note : the flange gasket bolts for the gate valves should be retightened during installation as the bolts may have loosened due to storage and shipping

    注意:閘閥的法蘭墊圈在安裝期間應該,因為在庫存和運輸時這些可能會鬆懈。
  6. Install the new element and gasket, checking for correct positioning. reconnect the electrical terminals and tighten the retaining bolt

    安裝新的加熱棒和墊圈,確認是否位置是否正確。新連接電氣端子,旋
分享友人