量熱術 的英文怎麼說

中文拼音 [liángrèshù]
量熱術 英文
calorimetry
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 術 : 術名詞1. （技藝; 技術; 學術） art; skill; technique 2. （方法; 策略） method; tactics 3. （姓氏） a surname
  1. Standard test method for total sulfur in aromatic compounds by hydrogenolysis and rateometric colorimetry

    通過氫解分析和比率量熱術測定芳香化合物中硫總含量的標準試驗方法
  2. Nuclear energy - nuclear fuel technology - waste - thermal reactivity assessment of bituminized waste by microcalorimetry

    核能.核燃料技術.廢料.用微量熱法對瀝青固化廢物進行熱反應性評定
  3. In this thesis, the development of emulsion polymerization theory and related new technologies are comprehensively reviewed, and the synthetic technologies of acrylate latex modified by organosilicon both at home and abroad are also reviewed. based on the current development and research in this field, attentions of this study are focused on three ways for preparing novel acrylate latexes modified by organosilicons, that is, 1 ) the acrylate monomers are copolymerized with unsaturated silicons by emulsion copolymerization ; 2 ) a new latex with microphase separation morphology is synthesized, which shows a core - shell structure character ; 3 ) soap - free polymerization is explored for preparing a higher - performance latex using an unsaturated silicon monomer, different acrylates and a reactive emulsifier. by using techniques of delaying addition of organosilicon monomer and a hydrolysis inhibitor, the hydrolysis and condensation of 3 - ( trimethoxysilyl ) propyl methacrylate during polymerization can be effectively prevented, as a result, organosilicon content in the macromolecular chain is increased

    同時採用有機硅單體延遲滴加及添加水解抑制劑等技術，有效防止了-甲基丙烯酰氧基丙基三甲氧基硅烷在乳液聚合過程中的過渡水解及縮合反應，提高了聚合物大分子鏈中有機硅鏈節的含量；利用紅外光譜與差示掃描量熱儀對產物分子結構進行了表徵，並通過對共聚產物力學和吸水率的測試，證實了本研究所制備的有機硅改性丙烯酸酯共聚物具有比純丙烯酸酯聚合物更優良的力學及耐水性能；從分子設計角度出發，利用醇解反應合成出水解、縮合反應速率較慢的兩種新型不飽和有機硅單體： ?甲基丙烯酰氧基丙基三乙氧基硅烷和?甲基丙烯酰氧基丙基三異丙氧基硅烷；利用核磁共振對新型硅烷單體結構進行了證實；研究表明利用新型硅烷單體可以制備出高硅烷含量的有機硅改性丙烯酸酯乳液，且其聚合產物具有較高的力學及耐水性能。
  4. The essential elements and process of gas reservoir formation of ordovician in ordos basin have been annalysed systematicly and scientificly by means of the theory and method of organic geochemistry and tectonic geology in this dissertation. the several advanced techniques, such as gas generation thermal simulation, on - line individual gas compounds carbon isotope determination ( py - gc - c - ir - ms ), the analysis technique of light hydrocarbons and biomarkers in natural gas, gas migration simulation and gas carbon isotope determination in fluid inclusions, have been applied to focuse on the study of the gas generation mechanism of souce rock, correlation between gas and source rock, reservoir formation history, migration direction, charging road in detail

    應用有機地球化學和構造地質學理論和方法對鄂爾多斯盆地奧陶系天然氣地質研究中薄弱環節成藏要素和作用進行了系統科學分析。利用烴源巖生氣定量熱模擬技術、熱模擬在線碳同位素實驗技術、氣體輕烴和生物標志物分析技術、運聚成藏物理模擬技術和包裹體中碳同位素分析技術等多種先進的實驗技術對烴源巖的生氣機理、氣源和混合比、成藏史、充注路徑、運移方向和構造作用與成藏關系等問題進行了深入的研究，在前人研究的基礎上，經過本次大量的實驗分析和綜合研究，提出了一些新的認識。
  5. Excimer laser corneal refractive surgery and wavefront technology have developed rapidly these yeas. now, wavefront - guided laser vision correction becomes the hotspot in corneal refractive surgery. applying the technology of cad / cam, this paper has studied modeling technologies in excimer laser vision correction

    近年來準分子激光角膜屈光手術、眼波前像差的測量技術迅速發展，當前波前像差引導的個體化切削技術成為研究的熱點問題。
  6. Kinetics of 8 " phase precipitation and influence of electric field applying during solution process are studied by differential scanning calorimetry ( dsc ) technique

    以示差量熱分析技術（ dsc ）研究相析出的動力學及固溶電場的影響。
  7. The current pulse - heating technique for thermophysical properties measurement

    電流脈沖加熱瞬態熱物性測量技術
  8. First this paper introduces the development of microscale heat transfer from theory, experiment and computer simulation. then it analyses the heat transfer mechanism during short - pulse heating of metals and the microscale heat conduction in dielectric thin films. last it expatiates on the principle of ac calorimetric method and its experimental techniques

    本論文首先從微尺度理論、實驗技術和計算機模擬三方面介紹了微尺度傳熱學研究現狀，接著分析了超短激光脈沖加熱金屬薄膜過程中的熱傳導和介質薄膜中的熱傳導機制，闡述了超短激光脈沖交流量熱法的原理和實驗技術。
  9. Differential scanning calorimeter ( dsc ) combined with melt fluxing technique was used to realize undercooling of melt and its specific heat was measured at the same time, and its thermodynamics were calculated simultaneously and compared to four well - known models

    本文將差示掃描量熱法（ dsc ）和助熔劑處理技術相結合，研究了熔體的過冷現象，測量了過冷狀態下熔體的比熱，計算了過冷熔體凝固過程中的其它熱力學參數，並與四種近似模型進行了比較分析。
  10. Airborne gravimetry has been rapid development during the past decades and becomes one of the very active topics of the research in the gravity field

    摘要近十幾年來，航空重力測量技術的研究和應用日趨活躍，業已成為地球重力場研究中最為熱門的領域之一。
  11. Kinetics of 8 " phase dissolution in aged 1420 alloy and influence of electric field applying during aging process are studied by dsc technique

    以示差量熱分析技術（ dsc ）研究了時效處理后1420合金的相回溶動力學及時效電場的影響。
  12. Thrust vectoring is the key technique for the modem fighter with agility and post - stall maneuver ability and good flight quality. and now it is the necessary technique for the fourth generation fighter and hot technique for the performance improvement for the third generation fighter

    推力矢量技術是現代戰機具有敏捷性、過失速機動能力、良好的飛行品質的關鍵技術，其已成為第四代戰斗機的必備技術和第三代戰斗機改型的熱門技術，得到了越來越多的重視。
  13. Thermal cutting - classification of thermal cuts - geometrical product specification and quality tolerances

    熱切割.熱切割分類.產品幾何量技術規范和質量公差
  14. Thermal cutting - classification of thermal cuts - geometrical product specification and quality tolerances iso 9013 : 2002 ; german version en iso 9013 : 2002

    熱切割.熱切割分類.產品幾何量技術規范和質量公差
  15. Pdsc pressure differential scanning colorimetry

    壓差掃描量熱術
  16. Techniques of measurement for flow properties in arcjet

    電弧加熱發動機參數的測量技術
  17. Abstract : in the paper, we set up new mathematical models of heating power paramenters, discussed the measuring techniques and introduced intelligent instrument with 8031 scp

    文摘:本文建立了高精度、寬范圍的水蒸汽熱力參數數學模型，分析了相應的測量技術問題，介紹了以8031單片機為主要部件的智能化熱力參數測量儀的構成。
  18. As the requirement of energy - saving and indoor environment gets higher and higher, variable flow technology are widely used in heating and air conditioning systems, namely by changing power or resistance to adjust the flow of the system 、 subcircuit and terminal equipment so as to match usually mutative dynamic heat ( cold ) load variation

    隨著節能和室內環境要求的愈來愈高，供暖和空調系統廣泛採用了變流量技術，即用改變動力或改變阻力的方式調節系統、支路以及末端設備的流量，使之與經常變化的動態熱（冷）負荷相匹配。
  19. Fiber technology has been developed for many applications in both fiber optic communication and sensor systems. fiber sensors have presented a direction to modern measurements for their unique characteristics, among them intensity modulation fiber sensors own strong applications

    光纖技術無論是在光纖通信領域還是在光纖傳感領域都可稱得上是一個具有革命性的技術開拓，光纖傳感本身具有的優點使其成為研究熱點，為現代測量技術的發展提供了一個方向。
  20. Present the experimental research carried out on strain and stress by applying the resistance strain surveying technique to the big hole sealed heads in the new fire - tube heating boilers with the laws of strain and stress distribution obtained and allowable working pressure given because there is no applicable standards or specification for calculating the strength of crude oil heating boiler heads perforated by densely distributed big - holes, which, to a certain extent, hampered the further development of crude oil heating boilers in china, and concludes from experimental results that strain and the stress of circumference are fairly large near the edge of big - hole, and the cross ribs enhance strength of sealed head to a certain degree

    油田火筒加熱爐密集大開孔封頭的設計計算，因沒有相應的強度計算標準在一定程度上限制了我國油田火筒加熱爐技術的發展.採用電阻應變測量技術，對新型火筒加熱爐大開孔封頭進行了應力應變試驗研究，得到了封頭的應變和應力分佈規律，給出了大開孔封頭允許的工作壓力.試驗結果表明，大孔邊緣圓周處應力應變較大，十字筋板對封頭有一定加強作用
分享友人
分享到 Line

分享到臉書