閾下應力 的英文怎麼說

中文拼音 [yùxiàyīnglì]
閾下應力 英文
subthreshold stress
  • 閾 : 名詞1. [書面語] （門坎兒） threshold; doorsill2. （界限; 范圍） threshold
  • 下 : 下動詞1. （用在動詞后,表示由高處到低處） 2. （用在動詞后, 表示有空間, 能容納） 3. （用在動詞后, 表示動作的完成或結果）
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  1. Under self - heating stress, a general degradation in subthreshold characteristic was observed, which is the consequence of defect generation along overall channel

    這主要是由於在自加熱應力下，整個溝道中都出現了缺陷態的產生，從而使器件的亞閾值擺幅發生了退化。
  2. The sort, material composite, structure properties and conduction mechanisms of eca ( electrical conductive adhesive ) were discussed in this paper. then three types of ega specimens were designed and made, on which temperature cycles test from - 55 ? to + 125 ? and thermal aging at + 125 ? were carried out. changes of the adhesive strength, eca ' s bulk resistance and contact resistance under the environment stress were summarized and a detailed evaluation on these specimens was given

    本文在全面闡述導電膠的分類組成、物理結構、導電機理的基礎上，設計並製作了三批導電膠樣品，通過對樣品進行長時間的- 55 ? ? + 125溫度循環和125高溫存儲試驗，總結了導電膠粘接強度、體電阻和接觸電阻在環境應力下的變化規律，對三類樣品的長期可靠性做出了全面的評價，並結合導電膠電阻率和「穿流閾值」的計算機模擬，給出了提高導電膠可靠性和電導率的建議，介紹了國內外在高電導率高可靠性導電膠研製方面的一些最新進展。
  3. The results show that at a given substrate temperature, there is a compressive stress threshold, below which cbn phase is thermodynamically stable and p above which hexagonal bn ( hbn ) phase is thermodynamically stable

    結果表明，在給定的襯底溫度下，存在一個壓應力閾值，壓應力低於此值時立方相是熱力學穩定相，壓應力高於此值時，六角相是熱力學穩定相。
  4. This paper analyzes the percolation mechanism and characteristics of gas under low - velocity percolation state in terms of slippage effect and threshold pressure effect by using molecular dynamics, thermodynamics and percolation mechanics in order to understand the practical reason of low - velocity non - darcy percolation

    摘要為明確氣體在低速滲流狀態下的滲流規律以及產生低速非達西滲流的實質性原因，運用分子動力學、熱力學和滲流力學等相關知識，基於滑脫效應和閾壓效應兩方面分析了氣體在低速滲流狀態下的滲流機理及滲流特徵。
  5. Erosion damage decreases rock load area, after defining damage variable, the damage stress in rock can be calculated by the method bring forward by lemaitre conveniently. for surrounding rock of a deep buried tunnel under the condition of drained, its seepage character is not only controlled by the high stress in rock, but also influenced by the development of erosion damage. in the whole course of rock " s deformation and failure, its seepage character decreases with the increment of stress in elastic stage, while " increases with the development of failure

    巖樣中全應力?應變三軸滲透試驗過程中的典型表現為隨著應力的增加，巖體內的空隙和裂紋受載閉合，滲透性降低，應力達到一定閾西南交通大學鷹士研究生學位論文第11頁值后，巖體內部裂紋發生擴展和歸並，滲透性增強；同樣，地下水的動、靜壓力作用對裂紋的擴展和歸並也起著促進作用。
  6. The author ' s main contributions are outlined as following : first, the roles of hot electron and hole in dielectric breakdown of ultra - thin gate oxides have been quantitatively investigated by separately controlling the amounts of hot electron and hot hole injection using substrate hot hole ( shh ) injection method. the changes of threshold voltage have been discussed under different stress conditions

    主要研究結果如下：首先，利用襯底熱空穴（ shh ）注入技術分別控制注入到超薄柵氧化層中的熱電子和空穴的數量，定量研究了熱電子和空穴注入對超薄柵氧化層擊穿的影響，討論了不同應力條件下的閾值電壓變化。
  7. When the performance degradation is caused by the discrete cumulative damages, the degradation failure model based on renewal process is proposed and used to analyze the reliability of metallized film pulse capacitors in the laser device. when the degradation process is continuous, two models based on wiener - einstein and gamma processes are presented respectively. because it is difficult to obtain an analytical expression of the failure model using the latter method, we present a failure model based on monte - carlo simulation

    根據該模型的特點，給出了基於參數回歸分析的統計推斷方法，分別提出基於比例危險模型的競爭失效分析方法和基於位置-尺度模型的競爭失效分析方法; （ 4 ）對于隨機失效閾值問題，研究並給出了相對失效標準下的退化失效模型和分析方法;對強度退化的動態應力-強度干涉失效進行分析，提出了周期性應力作用下的動態應力-強度干涉失效可靠性模型和復合應力作用下動態應力-強度干涉失效可靠性模型。
分享友人
分享到 Line

分享到臉書