阻抗元件 的英文怎麼說

中文拼音 [zǔkàngyuánjiàn]
阻抗元件 英文
impedor
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 抗 : Ⅰ動詞1 （抵抗; 抵擋） resist; combat; fight 2 （拒絕; 抗拒） refuse; defy 3 （對等） contend with...
  • 件 : Ⅰ量詞（用於個體事物） piece; article; item Ⅱ名詞1. （指可以一一計算的事物） 2. （文件） letter; correspondence; paper; document
  • 阻抗 : [電學] impedance
  1. A general graphical user interface based on object - oriented technique, database and visualization in scientific computing has been conducted. we can draw electrical components of the distribution network and fill the components data easily. background programs analyze topology automatically and constitute node admittance matrix, node impedance matrix

    它使用圖形元件直接繪成系統接線圖，在屏幕上輸入元件參數，后臺程序自動進行網路拓撲分析，然後基於稀疏技術，利用支路掃描法形成節點導納陣，連續回代法形成節點阻抗陣。
  2. Simultaneously cross - linked and quaternized 4 - vp - co - nbuma was also investigated as humidity sensing materials and showed good linearity, high sensitivity, good high stability at high humidity and high temperature, and durability to organic solvent, etc. sensors based on 4vp - co - buma ( vp / buma = l / l ) with crosslinking and quaternization reaction of 17 hours exhibited a change of three orders of magnitude ( 104 ~ 107 ) in impedance over the range of 95 % rh ~ 30 % rh, showing high sensitivity, and little hysteresis was observed

    元件具有響應線性度好，靈敏度高，濕滯小、高溫高濕穩定性好、耐無水乙醇有機溶劑性能好等優點。其中，交聯季胺化17小時配料比為1 1共聚物濕敏元件，在33 rh 95 rh濕度范圍內，阻抗變化達3個數量級（ 10 ~ 7 - 10 ~ 4 ） ，響應靈敏度高，幾乎無濕滯。
  3. For bus system installation, the focus is put on cable selection principle, installation process and antinoise measure ; for security protection equipment installation, the intrinsic safety concept, installation method equipment selection and installation under two electric power supply modes ( entity concept and fisco model ) and the bus system protection against surge voltage are illustrated ; for network component installation, the selecting, installing and integrating methods of general purpose terminators, repeaters, link equipment, bus power supply and impedance module are described

    在總線電纜的安裝方面，著重討論了電纜的選型原則、安裝方法和抗噪防擾措施；在安全保護設備安裝方面，介紹了總線系統中本質安全的概念、安裝方法、兩種供電方式（實體概念和fisco模型）下設備的選擇與安裝以及總線系統浪涌電壓的保護和設備安裝方法；在網路元件的安裝方面，主要列舉了通用終端器、中繼器、鏈路設備、總線電源及其阻抗模塊等的選擇、安裝和集成方法，為總線系統的安裝提供了可以借鑒的實用經驗。
  4. The pt secondary loop voltage drop is a changing amount and has the characteristics of indirection and certain randomness. the second, according to the cause of pt secondary loop voltage drop, the different methods to reduce the pt secondary loop voltage drop were analyzed and the conclusions are draw as below : 1. changing bigger section wire and maintaining the connector plugs regularly can reduce the pt secondary loop voltage drop effectively, but ca n ' t guarantee which meets the relevant rules

    首先，通過對電壓互感器二次壓降的形成機理進行分析，得出以下關於二次壓降的相關結論： 1 、電壓互感器二次壓降等於二次迴路阻抗和迴路電流的乘積； 2 、電壓互感器二次迴路阻抗分為元器件自身阻抗和接觸阻抗兩部分，且接觸阻抗佔主要部分，從而使得電壓互感器二次迴路阻抗具有動態特性，而且具有一定的隨機性； 3 、電壓互感器二次迴路電流與二次負荷和迴路阻抗大小相關，因而二次迴路電流也是變化的； 4 、電壓互感器二次壓降是一個變化量，且具有單向性和一定的隨機性。
  5. Strain - gauge load cell or force transducer, minimum load impedance 320r

    應變測壓元件或傳感器的最低負載阻抗為320r 。
  6. Pmosfets and two 16 - bits shift registers were used as the impedance converting and address selection of the elements respectively. the thermal insulation layer was a polyimide film of five micrometers an

    用pmos場效應管作熱釋電元件的阻抗轉換，用雙16位移位寄存器作敏感元件信號讀出的選址。
  7. The optimal aging conditions for the sensors investigated are : u 200 mv, f1 khz, t24 - 48 h, rh 81 - 87 %, t 3 80c ii the sensing mechanism of the humidity sensors has been explored by means of complex impedance analysis

    合適的老化條件為：施加電壓200mv ， 1khz ， 24 48h ， 38 ， 81 87 rh 。採用復阻抗譜分析法，研究元件感濕機理，認為napss濕敏元件感濕機理為離子導電，其電導隨濕度的變化可由改進的onsager方程描述。
  8. In the eddy - current testing, testing coil is the sensitive component connecting the specimen and the instrument, so it is called transducer. the information of the test specimen is reflected by the variation of the coil impedance ( or induced voltage )

    在渦流檢測中，檢測線圈是用來連接測試儀器和被測試件的敏感元件，它是渦流檢測中的傳感器，被檢試件的信息是通過線圈阻抗（或感應電壓）的變化反映出來的。
  9. It was found that self - assembly films of napss / pdda showed low impedance, good linearity and high sensitivity. impedance of sensors with 25 bilayers of napss / pdda composite film changed linearly for four orders of magnitude ( 10 - 10 q ) over the range of 20 % rh ~ 95 % rh. furthermore it was found that organic / inorganic nanocomposite films exhibit faster response than organic / organic composites

    發現： napssrpdda體系具有阻抗低、響應線性度好、濕滯小、響應快、靈敏度高等優點，其中雙層數為25的濕敏元件在20 rh95 rh濕度范圍內具有良好的線性響應，阻抗變化近4個數量級』 l 』 q卜靈敏度高。
  10. Filters, couplers and baluns are fabricated in the high frequency passive device integration regions

    濾波器、耦合器和平衡非平衡阻抗轉換器系製造在高頻被動元件整合區域內。
  11. The first, the effect of the sizes of coupling slots in a coupling double gap cavity on the cavity characteristics is studied through simulation computation of three dimensions electromagnetic field and analysis of equivalent lumped element circuit. it is concluded by the research that, in lower frequency band, bigger coupling slots in a coupling double gap cavity are beneficial to raising the characteristic impedance and lowering the frequency of it mode

    第一，採用三維電磁場模擬計算方法和集中元件等效電路法研究了耦合雙間隙腔中耦合槽尺寸對諧振腔性能如何影響等問題，得出了重要結論：在較低頻率波段，耦合雙間隙腔中開大耦合槽有利於提高模的特性阻抗，降低模頻率。
  12. Elements of electrical and optical connection - test methods - electrical elements - measurement of characteristic impedance of a bus or a stub terminator

    電氣和光學連接元件.試驗方法.電氣元件.總線或短線端子的特徵阻抗的測量
  13. Elements of electrical and optical connection - test methods - electrical elements - measurement of stub input impedance of couplers

    電氣和光學連接元件.試驗方法.電氣元件.耦合器的短線輸入阻抗測量
  14. Elements of electrical and optical connection - test methods - electrical elements - measurement of surface transfer impedance of couplers

    電氣和光學連接元件.試驗方法.電氣元件.耦合器的表面傳輸阻抗測量
  15. The agilent 4263b lcr meter is agilent technologies most cost - effective low - end lcr meter, designed for both component evaluation on the production line and fundamental impedance testing for benchtop applications

    Agilent 4263b lcr表是agilent物超所值的低端lcr表，專用於生產?的元件評估和臺式應用的基本阻抗測試。
  16. Rcs of facets of targets coated ram was resolved by combining impedance boundary condition ( ibc ) and geometric optics ( go ) and rcs of those edges were approximated by computing the rcs of edges of impedance wedge through method of equivalent currents

    其中，塗覆目標面元的散射場是通過結合阻抗邊界條件和幾何光學法（ go ）而得到；而塗覆目標棱邊的散射場則是通過等效電磁流法求解阻抗劈的邊緣繞射場近似得到的。
  17. It was found that introduction of hydrophobic monomer into polymer chain improved the response linearity and sensitivity, and the impedance of sensors decreased with longer quaternization time and shorter distance between electrode tracks

    發現：疏水性單元的引入，提高了濕敏元件的響應線性度和靈敏度；季胺化時間的延長，使聚合物季胺化程度提高，濕敏元件阻抗減小；電極叉指間距增大，阻抗增大。
  18. Aerospace series - elements of electrical and optical connection - test methods - part 708 : electrical elements - measurement of surface transfer impedance of couplers

    航空航天系列.電氣及光學連接元件.試驗方法.第708部分:電氣元件.耦合器的表面傳輸阻抗的測量
  19. Elements of electrical and optical connection - test methods - electrical elements - measurement of open circuit impedance of couplers

    電氣和光學連接元件.試驗方法.電氣元件.耦合器開路阻抗的測量
  20. Aerospace series - elements of electrical and optical connection - test methods - part 701 : electrical elements - measurement of open circuit impedance of couplers

    航空航天系列.電氣及光學連接元件.試驗方法.第701部分:電氣元件.耦合器開路阻抗的測量
分享友人
分享到 Line

分享到臉書