阻抗斷電器 的英文怎麼說

中文拼音 [zǔkàngduàndiànqì]
阻抗斷電器 英文
impedance relay
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 抗 : Ⅰ動詞1 （抵抗; 抵擋） resist; combat; fight 2 （拒絕; 抗拒） refuse; defy 3 （對等） contend with...
  • 斷 : Ⅰ動詞1 （分成段） break; snap 2 （斷絕;隔斷） break off; cut off; stop 3 （戒除） give up; abstai...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 阻抗 : [電學] impedance
  • 電器 : electrical equipment [appliance]電器燈 electric appliance lamp; 電器乾燥爐 electrical drying furn...
  1. For the circuit - breakers of rated voltage 252kv up, the synthetic test methods are introduced according now condition because of the limitation of the transformer short - circuit capacity. the correlative prescribes on switching line - charging current in gb / t1984 - 200x " alternating - current high - voltage circuit - breaker " are discussed according to the test results and theoretic analysis

    由於開合空載架空線路試驗對電源側的阻抗有明確的規定，這就要求試驗電源必須具有足夠大的短路容量，實驗室很難滿足要求，因此，一般對較高電壓等級的斷路器採用合成試驗方法，本文介紹了利用現有條件，對252kv以上電壓等級的斷路器採用合成試驗時的試驗線路。
  2. Di - on electric one of the beijing hi - new - tech enterprise develop and manufacture lots of equipment like sf6 dewpoint meter dp100, cable fault location system cfl6000 and more. di - on electric supply the most advanced technology and equipment on such as gis surge arrestor on line monitoring, resistance measuring, ac dc metrology, thermal - temperature bridge, power transformer diagnostic and testing, cable diagnostic and fault location, sf6and oil moisture measuring, oil treatment and testing, optic fiber temperature monitoring, circuit breaker testing, relay testing and more

    迪揚電氣在gis和避雷器的帶電測試與故障診斷分析，電力電纜的故障定位與局放檢測，變壓器電抗器的各種測試診斷與溫度監測， sf6的水分測量與回收，絕緣油的測試分析與濾油處理，紅外測溫與光纖在線測溫，以及各種電阻測試與計量，溫度計量與電能計量等方面擁有世界一流的技術與成熟的儀器設備。
  3. This paper presents a novel method for short - circuit current calculation, using zero impedance branch to simulate electrical equipment ( such as circuit breaker )

    提出了將電氣設備（如斷路器等）用一條零阻抗支路模擬的短路電流計算方法。
  4. It utilizes zero impedance branch characteristic, combining structure - transform and structure - static short - circuit current calculation method to calculate the short - circuit current directly through the electrical equipment when short - circuit fault takes place at the two sides of the electrical equipment, and settles the problems that the traditional method cannot directly figure out the short - circuit current

    該方法利用零阻抗支路特點，結合定結構和變結構短路電流計算方法，能夠直接求出在電氣設備兩側分別發生短路時，通過電氣設備（如斷路器）的短路電流，從而合理地解決了傳統的故障分析方法不能直接求出流過設備的短路電流的問題。
分享友人
分享到 Line

分享到臉書