阻抗測試器 的英文怎麼說

中文拼音 [zǔkàngcèshìqì]
阻抗測試器 英文
impedance checker
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 抗 : Ⅰ動詞1 （抵抗; 抵擋） resist; combat; fight 2 （拒絕; 抗拒） refuse; defy 3 （對等） contend with...
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 阻抗 : [電學] impedance
  • 測試 : test; testing; checkout; measurement
  1. The study is imitating subulate tool penterite armor fabric by method of test for puncture of paperboard and corrugated fiberboard, and to ascertain the laver of armor fabric for absorb energy and arrestment, and any difference angle to compare the rank of defying ball, for understanding the sharp to the rank of annor fabric defy penterite energy, and penterite deep, the lose energy relation of sharp

    摘要本研究是以沖孔強度試驗機測試，模擬尖錐利器攻擊穿刺防彈衣，且對于防彈衣層數間的阻抗作用及能量吸收的情形，並對各種不同角度的抗彈織物疊層排列作相互比較，進而?解尖錐對防彈衣的抗穿透層數之能量及穿透深度、錐度之能量耗損之間關系。
  2. A new measurement system for electrical conductivity in an yj - 3000t press fitted with a wedge - type cubic anvil was set up on the basis of the old one. a solartron 1260 impedance / gain phase analyzer was used in the new system ; mo electrodes and a mo shield were also used to keep oxygen fugacity close to the mo - moo2, which is similar to that of iron - wustite ( iw )

    在yj ?緊裝式六面頂壓機上，對原有的礦物、巖石電性測量系統進行了進一步的改進：建立了一套以solartron1260阻抗增益?相位分析儀為測試儀器，使用mo電極和mo盾來控制樣品氧逸度的測量系統，該系統的氧逸度環境為mo ? moo _ 2 ，接近iw緩沖對。
  3. Double - way high impedence prepositive amplifier for electrochemical test

    雙路高阻抗電化學測試前置放大器
  4. Di - on electric one of the beijing hi - new - tech enterprise develop and manufacture lots of equipment like sf6 dewpoint meter dp100, cable fault location system cfl6000 and more. di - on electric supply the most advanced technology and equipment on such as gis surge arrestor on line monitoring, resistance measuring, ac dc metrology, thermal - temperature bridge, power transformer diagnostic and testing, cable diagnostic and fault location, sf6and oil moisture measuring, oil treatment and testing, optic fiber temperature monitoring, circuit breaker testing, relay testing and more

    迪揚電氣在gis和避雷器的帶電測試與故障診斷分析，電力電纜的故障定位與局放檢測，變壓器電抗器的各種測試診斷與溫度監測， sf6的水分測量與回收，絕緣油的測試分析與濾油處理，紅外測溫與光纖在線測溫，以及各種電阻測試與計量，溫度計量與電能計量等方面擁有世界一流的技術與成熟的儀器設備。
  5. Ac ground continuity tester

    交流接地阻抗測試器
  6. There are many methods for measuring impedance and commercial lcr meters may have very different working principles. it is more advisable that customers submit their impedance standards for calibration, which in turn can be used to perform in - house checking of their lcr meters. however, the laboratory may offer performance checks for lcr meters using impedance standards

    測量阻抗的方法有多種，故此市面上的電感電容電阻計或有截然不同的操作原理，一種比較適當的做法是客戶將其阻抗標準器送來本所校正，然後客戶可利用這些已校正的標準器替自己的電感電容電阻計進行測試。
  7. Manufacturer of high voltage resistors, power and precision resistors, high voltage dividers, hybrid circuits, resistor networks, pressure and force sensors and load cells

    -生產ai - 6000自動抗干擾精密介質損耗測量儀，氧化鋅避雷器測試儀，地網接地電阻測試儀，油介損電阻率測量儀。
  8. Under windows nt and labview development environment, using the linear fit module, exponential fit module > general polynomial fit module of labview to design a method for fitting the experiment data, the results of curve fitting indicate that the purpose of general polynomial fitting is better than the rest. separating the equivalent input impedance of magnetostrictive transducers without stimulate current from input impedance of it with stimulate loop based on the results of curve fitting, and determining the syntony frequency and electric simulation network parameters of magnetostrictive transducers by this input impedance. finally, with labview network functions, realizing magnetostrictive transducer electric simulation system based on web server and discussing a scheme for this system network by datasocket. the method of this paper can more accurately determine the syntony frequency and electric simulation network parameters of magnetostrictive transducers than the testing method of syntony & anti - syntony. at the same time, discussing virtual instrument measurement system and how to realize magnetostrictive transducer electric simulation network system by labview network functions of network virtual instrument measurement development environment

    在windowsnt系統環境和labview虛擬儀器技術開發平臺下，首次利用labview中的直線擬合模塊、指數擬合模塊以及多項式擬合模塊，設計了一種對實驗所得數據進行曲線擬合的方法，對三種擬合方法進行了比較，曲線擬合結果表明，多項式擬合方法相對于其它兩種擬合方法效果更好；根據曲線擬合的結果可從帶激勵線圈的磁致伸縮換能器的輸入阻抗中分離出磁致伸縮換能器鐵芯在無激勵電流時機械振動形成的等效輸入阻抗，並由此輸入阻抗確定了磁致伸縮換能器的諧振頻率及其電氣模擬網路參數；最後通過labview提供的網路功能，實現了基於web服務器的磁致伸縮換能器電氣模擬虛擬儀器測試系統，並探討了通過datasocket技術實現該系統網路化的方案。
  9. Equipment under test to the measurement terminal. the high pass filter output signal is switched from either conductor to the measurement terminal

    大體上講，電源阻抗穩定網路從檢測設備eut向測試埠看，是一個高通濾波器。
  10. Impedance, reflection coefficient, return loss, and vswr test procedure measured in the time and frequency domain for electrical connectors, cable assemblies or interconnection systems

    電連接器電纜附件或互連系統在時間和頻率域中測量的阻抗反射系數回程損耗和vswr試驗程序
  11. A series of experiments were conducted to research on electrode according to the principle of energy - storage materials, electroly tes, preparation techniques with the aids of the measure methods such as cyclic voltammetric measurements ( cv ), constant charge / discharge measurements, impedance spectrum, x - rays diffraction ( xrd ), transmission electronic microscope measurements ( tem ), and so on

    本文採用了循環伏安、恆電流充放電、交流阻抗、 x射線衍射、透射電子顯微鏡等實驗方法和測試手段對超大容量電容器的電極活性物質材料及電極製作工藝、電解質溶液的選取等問題展開了一系列研究。
  12. The paper mainly consists of three parts : the theoretical parts include the summarization of meridian research, and the research about the characteristic of low impedance on meridian and acupoints. the second part focuses on the design of the testing instrument, which comprises hardware design and software design. detector collects the reflected information which is stimulated by micro - current on meridian and acupoints, then the signals are transacted by micro - controller and meridian arithmetic, finally the health status report is displayed on screen and can be printed

    主要工作分為三個部分，第一部分是經絡研究綜述與經穴皮膚電阻抗特性;第二部分為儀器系統設計，包括硬體設計和軟體設計，實現對採集人體穴位經電流測試（給一定的電流刺激）所反射出來的信息，經微控制器和中醫經穴演算法的處理后，在屏幕上顯示或列印出被測者的健康狀況。
  13. The tests show that the neural network impedance relay has good function to anti fault resistance and adaptability to variation of system condition

    經測試該神經網路阻抗繼電器具有良好的抗過渡電阻功能，且能自適應于系統工況的變化。
  14. In the eddy - current testing, testing coil is the sensitive component connecting the specimen and the instrument, so it is called transducer. the information of the test specimen is reflected by the variation of the coil impedance ( or induced voltage )

    在渦流檢測中，檢測線圈是用來連接測試儀器和被測試件的敏感元件，它是渦流檢測中的傳感器，被檢試件的信息是通過線圈阻抗（或感應電壓）的變化反映出來的。
  15. The thesis mainly investigated the bati _ 4o _ 9 ( bt _ 4 ), which has the lowest dielectric loss in ba - ti system, and ( ba, sr ) tio _ 3, the a position substitute compound of batio _ 3. the dielectric properties of bt _ 4 / bst with different preparation way and different elements doping were investigated. a archimedes method, xrd, sem, impedance analyzer, network analyzer and hakki - coleman method were used to investigate the density, phase formation, microstructure, dielectric properties and doping mechanisms

    本論文以在ba - ti系中具有最低介電損耗的bati _ 4o _ 9 （ bt _ 4 ）高頻介質陶瓷和batio _ 3a位sr取代而得的（ ba ， sr ） tio _ 3 （ bst ）高頻介質陶瓷作為研究對象，對不同粉體制備方法制備的bt _ 4 / bst高頻電介質材料進行不同元素的摻雜，運用阿基米德方法， x射線衍射分析儀，掃描電子顯微鏡和阻抗分析儀，網路分析儀， hakki - coleman法等方法手段和測試儀器測試燒成樣品的密度，相組成情況，微觀結構和介電性能，探討造成介電性能起伏的形成機理。
  16. When tested with two saw filters whose center frequencies are 155mhz and 163mhz respectively, the ic completed the summing function of input signals, while the 5db bandwidth expands by about 10mhz. and the variation of the matched impedance caused by the ic is small enough to be ignored

    在對中心頻率分別為155mhz和163mhz的聲表面波濾波器進行加權控制的測試中，該電路實現了信號的疊加功能，輸出信號的5db帶寬展寬約10mhz ，且電路引起阻抗匹配的變化小。
  17. Elements of electrical and optical connection - test methods - electrical elements - measurement of stub input impedance of couplers

    電氣和光學連接元件.試驗方法.電氣元件.耦合器的短線輸入阻抗測量
  18. Elements of electrical and optical connection - test methods - electrical elements - measurement of surface transfer impedance of couplers

    電氣和光學連接元件.試驗方法.電氣元件.耦合器的表面傳輸阻抗測量
  19. Aerospace series - elements of electrical and optical connection - test methods - part 708 : electrical elements - measurement of surface transfer impedance of couplers

    航空航天系列.電氣及光學連接元件.試驗方法.第708部分:電氣元件.耦合器的表面傳輸阻抗的測量
  20. Elements of electrical and optical connection - test methods - electrical elements - measurement of open circuit impedance of couplers

    電氣和光學連接元件.試驗方法.電氣元件.耦合器開路阻抗的測量
分享友人
分享到 Line

分享到臉書