阻抗變換電路 的英文怎麼說

中文拼音 [zǔkàngbiànhuàndiànlù]
阻抗變換電路 英文
impedance inverter circuit
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 抗 : Ⅰ動詞1 （抵抗; 抵擋） resist; combat; fight 2 （拒絕; 抗拒） refuse; defy 3 （對等） contend with...
  • 換 : 動詞1. （給人東西同時從他那裡取得別的東西） exchange; barter; trade 2. （變換; 更換） change 3. （兌換） exchange; cash
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 阻抗 : [電學] impedance
  • 電路 : [訊] circuit （ckt）; electric circuit; electrocircuit電路板 circuit board; 電路保持 guard of a c...
  1. Impedance - matching balanced traction transformers ( balanced transformers in this paper for short ) are step - down transformers, they transfer symmetrical three phase voltage in primary side to perpendicular two phase voltage in secondary side. they are different from any other transformers, so their short - circuit current analysis and short - circuit test method must be taken into special account

    阻抗匹配平衡牽引變壓器（本文中簡稱平衡變壓器）是一種將一次側三相對稱電壓變換為二次側二相垂直電壓的降壓變壓器，它不同於已有的任何一種變壓器，短路電流的分析計算和短路試驗必須予以重新研究。
  2. Some design guide lines are discussed based on the structure of the system. the mutual inductance coupling model of the system is introduced. the circuit impedance is analyzed

    針對非接觸感應電能傳輸系統的構成，討論了非接觸感應電能傳輸系統的設計準則，介紹了變換器的互感等效電路模型，並進行了阻抗分析。
  3. A fem software as an important tool, work has been done as follows : the method using fem to design anomalous structure of transducers was adopted ; the vibration modes of the elastic pipe, ultrasonic transducers and system has been analyzed in piezoelectric coupled field. resonant frequencies of the transducers have been matched quite well with resonant frequencies of pipe, which can make it easy and accurate to design a transducer. the values of equivalent dynamic capacitors and dynamic inductances of ahead nine orders have been gotten derived by fem method, and fem equivalent circuit of the transducers has been built

    以ansys有限元軟體為主要分析工具完成了設計工作;在經典換能器設計理論和前人經驗的基礎上，對不規則形狀的換能器採用了有限元的方法設計;在耦合場中分析了換能器、導管及整體裝置的振動情況，使換能器的諧振頻率與導管的諧振頻率達到了較好的匹配，使設計變得更加容易和準確;利用有限元方法建立了振子的等效電路模型，求出了其前6階模態的等效動態電容電感值，為阻抗匹配和驅動電路的設計提供了依據。
  4. A new method for equivalent conversion of circuits, that is the impedance splitting method is proposed

    摘要提出了電路等效變換的一種新方法-阻抗分裂法。
  5. By utilizing the knowledge of digital circuit and simulation circuit, the system designs the pretreatment dealing circuit of the myoelectrical signal, which has the feature of big input impedance well suppress of public module and high gains. then the signal is gathered with " zhentong " data gathering after dealing with, and the software of signal processing is explored before the myoelectric signal is analyzed. after picking up eigenvalue, it is proved that the result is unanimous basically with the data of the relevant materials ; the other is to control artificial hand by the eigenvalue of the myoelectric signa l and at last the system gets very good control results

    即利用數字電路和模擬電路等相關知識，設計了具有輸入阻抗大、共模抑制好、增益高等特點的肌電信號前置處理電路，利用「振通」數據採集儀對處理后的信號進行採集，並利用快速傅立葉變換的相關知識編寫了信號處理程序，對肌電信號進行了波形分析、幅值譜分析和功率譜分析，提取了信號特徵值，與相關資料的數據相比，基本一致；二是利用肌電信號的特徵值對肌電假手進行控制。
  6. Presents the simple but highly reliable on - line detection of ultrasonic transducer clamping capacitance based on the impedance circuit model constructed through the impedance characteristics of the ultrasonic transducer under triple harmonics, and concludes from experimental results that this method can be used to effectively detect the variation of clamping capacitance while the transducer is operating, and the matching inductance can be dynamically regulated according to the results of detection, and dynamic matching can therefore be achieved in the real sense at the end of the transducer to improve the overall performance of the whole system

    為了解決大功率超聲應用的換能器電端匹配問題，分析了超聲波換能器在諧振頻率三次諧波下的阻抗特性，給出了超聲換能器三次諧波下的阻抗電路模型.並根據阻抗電路模型建立了對超聲換能器的夾持電容實現在線檢測簡單、可靠性高的方法，實驗證明該方法有效的.該方法可以在換能器工作過程中隨時檢測夾持電容的變化，根據檢測結果對匹配電感進行動態調整，實現真正意義上的換能器電端的動態匹配，從而大大改善匹配質量，提高系統的工作性能
分享友人
分享到 Line

分享到臉書