降壓電阻器 的英文怎麼說

中文拼音 [jiàngyādiànzǔqì]
降壓電阻器 英文
voltage dro ing resistor
  • 降 : 降動詞1. （投降） surrender; capitulate 2. （降伏） subdue; vanquish; tame
  • 壓 : 壓構詞成分。
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 電阻 : （物質阻礙電流通過的性質） resistance; electric resistance （電路中兩點間在一定壓力下決定電流強度...
  1. The fault that the series resistor has high value can be avoided by using the constant current amplifier, and the fault that the dividing resistor reduces the working voltage of the speaker can be avoided by using the constant voltage amplifier

    使用恆流功放，可以避免傳統方法中串聯電阻取值過大的缺點；使用恆壓功放，可以消除分壓電阻降低揚聲器工作電壓的不足。
  2. So choose parameter of damping device with reduce energy storage to improve cvt become and respond effective way of characteristic wink rational, this increases the capacity of sending for raising the dynamic stability of the supervoltage power transmission and transformation system, guarantee power system safe and reliable to run and have important technology economic meanings

    因此，合理地選擇阻尼器的參數以降低儲能是改善cvt瞬變響應特性的有效途徑，這對于提高超高壓輸變電系統的動態穩定性，增大輸送容量，保證電力系統安全可靠運行具有重要的技術經濟意義。
  3. The dac ' s output voltage can be exported by two groups of line - output structure. the simulation result shows this structure also can low the effect of the parasitic capacitances

    D a轉換器採用了兩組行輸出的電阻串結構，能有效地降低寄生電容對轉換電壓輸出的影響。
  4. The synchronous rectifying and low power sampling technology is used to reduce the power consumption, flexible external loop compensation, error amplifier output clamp are adopted for better system large signal response. the piecewise slope compensation technology is employed to minimize the consequence of over compensation. the sensor resistor is externally connected, which realize output voltage programmable. the overheat protection and under voltage protection modules are integrated in the die to allow the reliable operation of the system

    同時，電路設計採用同步整流技術、低功耗電流采樣技術降低功耗，提高轉換效率;採用靈活的外部環路補償技術、誤差放大器輸出嵌位技術以實現良好大信號特性;採用分段斜坡補償技術，消除不穩定因素，並最大程度地減小過補償帶來的問題;採用外接輸出采樣電阻的方式，實現輸出電壓的可編程。
  5. The shorter the interval between the two pulses of the current wave, the fewer strikes the varistors can endure. at the same time, the dc ljima changes fast - slowly - fast alone with the experiment continuing. microstructual disorder, such as variations in the height of the electrostatic potential at grain boundaries and electrode protrusions into the zinc oxide varistors, causes substantial temperature rise in a microscopic region around the defect and is the source for failure

    雷電的多重閃擊對雷電過電壓保護器件的影響更加嚴重，本文首次採用不同間歇時間雙脈沖電流沖擊對氧化鋅電阻進行了多次試驗，試驗表明：氧化鋅電阻在雙脈沖電流沖擊下更容易出現老化破壞現象，間歇時間越短，電阻能耐受的沖擊次數越少；此外，直流u _ （ 1ma ）值隨沖擊次數的增加具有快一慢一快的下降過程。
  6. Impedance - matching balanced traction transformers ( balanced transformers in this paper for short ) are step - down transformers, they transfer symmetrical three phase voltage in primary side to perpendicular two phase voltage in secondary side. they are different from any other transformers, so their short - circuit current analysis and short - circuit test method must be taken into special account

    阻抗匹配平衡牽引變壓器（本文中簡稱平衡變壓器）是一種將一次側三相對稱電壓變換為二次側二相垂直電壓的降壓變壓器，它不同於已有的任何一種變壓器，短路電流的分析計算和短路試驗必須予以重新研究。
  7. The pt secondary loop voltage drop is a changing amount and has the characteristics of indirection and certain randomness. the second, according to the cause of pt secondary loop voltage drop, the different methods to reduce the pt secondary loop voltage drop were analyzed and the conclusions are draw as below : 1. changing bigger section wire and maintaining the connector plugs regularly can reduce the pt secondary loop voltage drop effectively, but ca n ' t guarantee which meets the relevant rules

    首先，通過對電壓互感器二次壓降的形成機理進行分析，得出以下關於二次壓降的相關結論： 1 、電壓互感器二次壓降等於二次迴路阻抗和迴路電流的乘積； 2 、電壓互感器二次迴路阻抗分為元器件自身阻抗和接觸阻抗兩部分，且接觸阻抗佔主要部分，從而使得電壓互感器二次迴路阻抗具有動態特性，而且具有一定的隨機性； 3 、電壓互感器二次迴路電流與二次負荷和迴路阻抗大小相關，因而二次迴路電流也是變化的； 4 、電壓互感器二次壓降是一個變化量，且具有單向性和一定的隨機性。
  8. By compared with the simulation results and the experiment results, we come to the conclusions that : ( 1 ) circuit with assistant network can widen soft - switching extent in lagging arm, reduces duty - cycle loss on the secondary, diminishes switching dissipation of inverter spot - welding power source. ( 2 ) the range of resonant capacitor, the important factor to soft - switching process, not only affects zero - voltage turn - off of power switches, but also affects the range of zero - voltage turn - on of power switches. so resonant capacitors must be considered according to many aspects ; ( 3 ) it easily fulfils soft - switching condition in lagging arm as leakage inductance of power transformer increases, but bigger leakage inductance of power transformer increases opening dissipation of transformer and decreases efficiency of soft - switching inverter power source

    通過模擬結果與軟開關點焊逆變器試驗結果的對比分析，得到了如下主要結論：採用輔助網路可以完全拓寬全橋軟開關逆變器的滯后橋臂軟開關范圍，減小了次級占空比丟失，降低了逆變電阻點焊電源的開關損耗；諧振電容是影響軟開關工作狀態的重要因素，其大小不僅影響開關管的零電壓關斷，同時也影響開關管的零電壓開通范圍，因此，諧振電容應該綜合考慮；功率變壓器漏感越大，越容易滿足滯后橋臂的軟開關條件，但是大的漏感也使變壓器的通態損耗增加，降低了軟開關逆變器的效率。
  9. Specific issues examined are : compensation for the variation of the stator resistance, the offset error of the dc bus voltage, the voltage error generated by the forward voltage drop the dead time of the switches, improvement of the steady state performance, and the speed sensorless control for the pmsm dtc drive system are of major concern in this thesis

    定子電阻變化，直流母線電壓漂移，開關器件反向相電壓降、逆變器死區時間引起的電壓誤差的補償，提高系統穩態運行性能以及永磁同步電機直接轉矩控制的無速度傳感器運行方案等問題都是本文研究的重點。轉矩的快速響應是直接轉矩控制演算法的一個卓越的性能。
  10. Using sige bicmos darlington configuration as the input stage, the input resistance is increased by the mos devices while the transconductance of sige hbts is maintained. in the same time, the equivalent input noise is controlled well because of the sige hbts ’ good noise performance in the input stage

    輸入級的設計採用sigebicmos達林頓結構，在保留sigehbt高跨導優勢的基礎上充分利用mos器件來提升運放輸入電阻，此外，基於輸入級中sigehbt良好的噪聲特性，運放的輸入參考噪聲電壓可以大大降低。
  11. It is found that after stressed by surges the varistors show a decrease in both break - down voltage and nonlinear exponent, and an increase in leakage current

    實驗結果顯示，氧化鋅變阻器受突波侵襲后，會生成崩潰電壓降低，非歐姆指數值減小，以及漏電流增加等劣化現象。
  12. At last this paper gives the analyse of power and the output data. this low - power atmospheris pressure altimeter is mainly made up of the sensor, the lead plane and management of power supply

    其中降低系統功耗的設計是本文的重點。該氣壓高度表主要由壓阻式壓力傳感器、主機、電源管理組成。
  13. Constant stator magnetic linkage control frequency converter includes power devices utilizing igbt, drive circuit using three - phase drive ic with multiple protection functions. pwm signal formation circuit in the way of voltage space vector control and realized with pld ( programmable logic device ) devices and compensation for the influence of supply voltage variation and stator resistance voltage drop

    其中，恆定子磁鏈控制變頻器的設計中主電路採用功率器件igbt ；驅動電路採用三相多功能集成驅動晶元； pwm脈寬調制信號產生電路採用電壓空間矢量控制方式，由pld器件實現；對電源電壓變化及電阻壓降造成的影響進行了補償。
  14. Comparing with conventional resurf structure, the novel structure has only half the device length and 1 / 3 of the on - resistance as well as comparable breakdown voltage. we have also done some worked on the soi composite structure

    通過將tsoi結構的ldmos與常規resurf結構soi - ldmos的比較，在同等耐壓下採用新型結構的器件長度縮短了1 / 2 ，比導通電阻降低了2 / 3 。
  15. In the conventional pmsm dtc system, the stator flux linkage is calculated from the integration of the difference between the machine input voltage and voltage drop across the stator resistance, and the input voltage is obtained by synthesizing the dc - link voltage and the switching mode of the inverter

    在常規直接轉矩控制系統中，定子磁鏈是通過直接積分電機端部輸入電壓與定子電阻壓降之差計算得到的。電機端部的輸入電壓又是通過電機直流母線電壓和逆變器的開關狀態綜合得到的。
  16. If the speaker needs more current ( its overall impedance drops ) then a lower amplifier output impedance will allow that current to be drawn out of the amplifier without causing much of a change in the applied voltage - and that means less distortion

    如果揚聲器需要更大電流（揚聲器的整體阻抗降低） ，那麼一個低輸出阻抗的放大器可以容許在輸出相應電流的同時，所施加的電壓變化更小，這也意味著失真更小。
  17. If the speaker needs more current ( its overall impedance drops ) then a lower amplifier output impedance will allow that current to be drawn out of the amplifier without causing much of a change in the applied voltage - and that means [ i ] less [ / i ] distortion

    如果揚聲器需要更大電流（揚聲器的整體阻抗降低） ，那麼一個低輸出阻抗的放大器可以容許在輸出相應電流的同時，所施加的電壓變化更小，這也意味著失真更小。
  18. The research of the transformer low insulation resistance problems

    變壓器絕緣電阻降低問題的試驗研究
分享友人
分享到 Line

分享到臉書