隨負載變化的 的英文怎麼說

中文拼音 [suífùzǎibiànhuàde]
隨負載變化的 英文
load-variant
  • 隨 : Ⅰ動詞1 （跟; 跟隨） follow 2 （順從） comply with; adapt to 3 （任憑; 由著） let （sb do as he li...
  • 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 的 : 4次方是 The fourth power of 2 is direction
  • 負載 : [電學] load
  1. Great intermittent noise, wide variety of impendence along with the load and great attenuation of signals have restricted the further utilization of power line

    但是，電力線通信通道存在間歇性噪聲大、阻抗隨負載變化大、信號衰減大等缺點，嚴重製約了它的有效利用。
  2. Circulation for transferring record then, based on the above limitations, this paper proposes a dynamic load balancing method. through the simulation of the change over time of the traffic of customer data, it draws a comparison in the deviation of the change over time of the traffic in a certain sdm ( service data module ) with respect to that of the average traffic of all modules between old method and new method. the load imbalance ratio, the number of records transferred per unit time and the reduction of number of modules are evaluated

    本論文針對上述兩個問題，提出一種改進的負載平衡方法，通過對用戶數據流量隨時間變化的模擬，比較了記錄遷移方法改進前後每一模塊的流量變化與所有模塊平均流量變化的趨近程度，同時還對幾個重要參數：模塊數量縮減率、負載不平衡比和單位時間內記錄遷移數量，它們之間的關系進行討論，得出改進后的記錄遷移方法能夠達到動態平衡負載的效果。
  3. This thesis also have constructed mathematic model based on the analytic method, which used the load as input and the pressure as output, meanwhile, it have made theoretic analysis of time response. the theoretic analysis was highly agreed with the experimental result

    在對出口節流調速系統液壓缸兩腔壓力隨負載變化的動態特性的理論分析時，用解析法建立了以負載為輸入，壓力為輸出的數學模型，進行時間響應分析，其理論分析結果與試驗結果相吻合。
  4. Through experimental research, the calculation formula that the pressure highly - adjusted capacity of two cylinder chambers varied with the change of step load and the formula about hydraulic elements main parameter ( rated pressure ) were both made, which had important valuation in selecting the main parameter about this hydraulic system

    通過試驗研究得出了出口節流調速系統中液壓缸兩腔壓力超調量隨負載變化的計算公式以及出口節流調速系統中液壓元件主參數（額定壓力）計算公式，有利於正確選擇系統的元件及主參數。
  5. The inverted pwm changing electric current the technique is applied in the prototype model. the prototype model was tested and operated on spot, power factor could reach beyond 0. 95, the effect of following modulating voltage was better, the curve of factor of modulated voltage of exchanging systems changed following load rate was linear, the output of wave form was a flat and steady sinusoidal wave

    樣機採用了逆變式pwm變流技術，對其進行了現場測試與試運行，測試結果是電網側的功率因數可達0 . 95以上，跟蹤調壓效果良好，變流系統輸出調壓系數（ k ）隨負載率（ p ）的變化曲線基本滿足直線關系，輸出波形呈平滑穩定的正弦波。
  6. Abstract : the rechargeble batteries are used for backup power internal electrically equipments and instruments. but batteries lifetime usually is shorten by overwork and then malfunctions of equipment are induced. to avoid the complexion described above, the protection circuit against overwork is designed. it is based upon the voltage comparator and regulator. it will light up a red led when the volume of the batteries discharged close upon 50 % ; it will switch off the load automatically when it discharged closing to 80 % of their energy capacity, thus overwork of batteries can be avoided and lifetime may be extended

    文摘:用蓄電池做后備電源的系統（或設備） ，常因過放電導致電池提前報廢而造成設備故障.根據電池電壓隨容量變化的規律，利用電壓比較器和電壓基準源設計製作了電池放電保護電路，當電池放電量接近容量的50 %時，啟動預警信號；當電池放電量達到容量的80 %時，電路自動切斷負載，防止電池過度放電，延長電池壽命，保證系統（或設備）在供電恢復正常后能正常運行
  7. It is difficult to replicate hinge moment accurately and rapidly because surplus torque affect dynamic performances of load simulator system badly with large intensity and continuous variation derived from variable velocity of rudder system

    這種干擾作用具有強度大、隨舵機速度不同連續變化的特點，它的存在嚴重影響了負載模擬器的動態性能，使得加載系統難以準確、快速地復現空氣動力鉸鏈力矩。
  8. Firstly, the experimental phase current and input power data obtained from load test are employed to estimate the parameters in ii rated condition. then, the phase current and input power data in locked rotor condition are used to track the variation of the parameters of the secondary coil with slip frequency. the classical method and the direct modification method are also used to estimate the parameters of the induction machine in comparison with this technique

    首先利用了負載試驗的定子電流和輸入功率數據來識別額定工況下的電機參數，然後又使用了堵轉時的定子電流、輸入功率數據來識別電機二次繞組參數隨轉差頻率的變化，並與傳統參數測試方法和直接修正參數法進行了比較。
  9. The formulas of three kinds of loaded ultrasonic transformers are presented ; then, the graphs of resonance frequency and the amplitude magnification coefficient, following the change of load, are charted by the programs of matlab

    得到了三類常用變幅桿頻率方程和放大系數的表達式；並通過matlab編程，分別繪制了三類變幅桿共振頻率及放大系數隨負載變化的曲線圖。
  10. By close study on the average temperature rise, temperature distribution, and tune constant of the class f resin dry type power transformer ' s high voltage and low voltage winding under self - cooling and wind - cooling mode, we find out the connection between the variation of the load and the items, mentioned above. the results of the experiments can be reference to both thermal design optimization of dry type power transformer and the revision of current standards. meanwhile, we develop the software, which can predict the overload ability of the dry type power transformer

    本文對f級樹脂澆注式乾式變壓器的高、低線圈的平均溫升，內部溫度分佈和時間常數在自冷和風冷，兩種冷卻方式下隨負載變化的規律進行了研究，得出了平均溫升、熱點溫升和時間常數隨負載變化的相互關系和有關計算用參數和公式，試驗結果可作為改進乾式電力變壓器的熱設計的依據和對現行標準進行修改的參考。
  11. The wind loading of a tracking radar antenna, for example, results from a mean velocity component that varies with time plus superimposed random gusts

    例如跟蹤雷達天線的風力負載是由一個隨時間變化的平均速度成分與迭加的隨機陣風組成的。
  12. The problem of noise is a chief block to restrict the popularity and developement of the plc because of the irregularity of power line network, the randomness of transmission distrance and load facility diversities

    由於低壓范圍內電力線網路的非規則性、傳輸距離的隨意性、以及電力線上負載變化的多樣性，使得干擾問題成為制約低壓電力線載波通信發展和普及的主要障礙。
  13. Accorded to the experimental research, under different flow area of flow valve and different adjusted pressure of relief valve, conclusion that the regulation of the pressure p1, p2 in the two cylinder chambers varied with the change of step load were as follows : when the throttle valve was series - connected on the return oil - line in the metering - out control system, under the same flow area and the same adjusted pressure of relief valve, with the incremental quantity of step load, the pressure highly - adjusted capacity of the hydraulic cylinder chamber with piston - rod decreased, meanwhile, it ' s time of rise, time to peak and the governing time all decreased. while the pressure highly - adjusted capacity of the hydraulic cylinder chamber without piston - rod increased

    通過試驗研究得出系統在不同的流量閥開度、不同溢流閥調節壓力（進口壓力）下，液壓缸兩腔壓力p _ 1 、 p _ 2隨階躍負載變化的規律：當出口節流調速系統的回油路上串接節流閥時，隨階躍負載的增加，在相同流量閥開度、相同溢流閥調節壓力的情況下，液壓缸有桿腔壓力p _ 2 （ t ）的超調量是減小的，上升時間、峰值時間以及調整時間也是減小的；液壓缸無桿腔壓力p _ 1 （ t ）的超調量是增加的。
  14. Abstract : this paper deals with the simulation result analysis of three phase synchronous generator with rectified output with stator y connected, as well as with stator connected. the curves of overlap angle, displacement angle and power factor with load are presented, and the tendency of these curves are also described

    文摘:對整流負載時凸極同步發電機定子繞組及y聯結模擬結果進行分析，繪出反映整流特性的換流重疊角、位移角以及功率因數隨負載變化曲線，並對變化趨勢進行分析。
  15. The reported statistics were trended over time, which provided a way to measure and compare workloads across servers

    所報告的統計信息是隨時間變化的趨勢，提供了一種對服務器上的負載進行測量和比較的方法。
  16. Based on the torque - speed characteristic curve of induction motors, analyses were done on changes in slip with an variation in frequency when an induction motor drives different kinds of loads, including those with constant torque, constant - maximum torque, variable torque ( except fans and pumps ) and constant power, as well as fans and pumps, the formulas to calculate the slip and the speed under different frequencies and loads were presented

    摘要以異步電動機機械特性曲線為基礎，分析了變頻調速異步電動機在拖動恆轉矩負載、恆最大轉矩負載、變轉矩（非風機和泵類）負載、恆功率負載以及風機和泵類負載時，轉差率隨頻率變化的規律。
  17. In our protocol, uniform spacing and segmentation polices make algorithm adjust with the change of loading situation dynamically, which suppresses cell jitter pretty well and also improves the bandwidth efficiency

    本文給出分段均勻間隔mac協議，均勻間隔和分段分配帶寬的策略可以使協議自動地隨負載狀況變化而調整，既很好地控制了抖動，又提高了帶寬效率。
  18. The voltage - stabilizing step is now focused on the control of constant - power in the semiconductor laser. in fact, the output voltage is changed when the load changed. as a result, it comes to be an important technology to make it stable when the load changed

    但事實證明，隨著負載的變化，光電轉換電源輸出端的電壓是不穩定的，因而採用何種方法確保在負載變化的情況下電源輸出仍是穩定的就成了光電轉換電源研究的一個重要問題。
  19. A voltage regulator mainly composed of a comparator is added to the main conversion circuit to stabilize the output voltage. using tspice simulation software, it is obtained that the output voltage of the converter with this regulator has a reduced ripple of less than 0. 8 % and almost has nothing to do with the varied load resistance of more than 800

    為了穩定輸出電壓，在變換器主電路的基礎上增加了主要由比較器構成的穩壓環節，通過使用tspice對其模擬、優化設計后，得到的輸出電壓紋波小於0 . 8 ，並且在負載電阻? 800時，輸出電壓基本不隨負載電阻阻值的變化而變化。
  20. Surplus force almost affected overall dynamic performances of electro - hydraulic load simulator system with large intensity and continuous variation derived from variable velocity of rudder system

    這種干擾作用具有強度大、隨舵機速度不同連續變化的特點，它的存在幾乎影響了負載模擬器的所有動態性能。
分享友人
分享到 Line

分享到臉書