集中荷載 的英文怎麼說

中文拼音 [jízhōnghézǎi]
集中荷載 英文
concentrated load
  • 集 : gatherassemblecollect
  • 荷 : 荷名詞（蓮） lotus
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 集中 : concentratecentralizefocusamassgroupmassingput togather
  1. Two numerating methods are used in traditional structural design of gate chamber. first, considering the gate frusta to be fastened on the weir body, it is calculated as plane stress problem independently. then applying the results ( moment and vertical force ) on the bottom of gate frusta as concentrating load on the weir body, and the weir body is viewed as a elastic foundation beam or plate and unilateral stress analysis was performed

    傳統閘室結構計算有兩種計算方法，其一是將閘墩視為固端于堰體上，單獨進行閘墩平面受力計算，再將閘墩下部的計算結果（彎矩和垂直力）作為集中荷載作用於堰體上，堰體作為彈性地基梁或板進行片面應力計算。
  2. This paper presents a manufacture and calculating method for castellated beams. according to the method, three beams are designed and tested, the detailed and trustworthy experimental data are obtained. in comparison of the castellated beam with the circular hole castellated beams during the process, that the yield of load and the strength limit for the latter are higher than the former is verified

    本文通過設計製造兩種不同截面形式的3根蜂窩梁（ 2根圓孔、 1根六邊形孔） ，進行了兩點集中荷載下的試驗，取得了較為翔實可靠的試驗數據，通過整理與分析，對兩種蜂窩梁的整體受力性能和承載力作出評價，得出圓孔蜂窩梁的屈服荷載和極限承載力都高於六邊形孔蜂窩梁的結論。
  3. This paper focuses on the research of the stress mechanism of the ribbed shell structure in statics, dynamics and under the explosive load on the basis of the engineering practice of cave depot of single aircraft. in this paper, according to the classical shell theories, the basic differential equilibrium of the ribbed shell structure and the finite element analysis of 3d rippled plate are established, in which the function of annular ribs reinforcement bars and 3d ripped steel plates are distributed in the range of the steel, and the functions along the longitude direction of tension, bending, and torsion are neglected ; applied with dynamic analytical theory, the dynamic model of ribbed shell structure and the analytical theory model of elastic - plastic are set up ; the triangle series method is used to solve the displacement and stress under the distributed load and the concentrated load of the ribbed shell structure

    本文以軍用機場地面單機掩蔽庫工程建設為工程背景，首次對內襯三維波紋鋼板混凝土拱型復合結構的受力機理進行了靜力、動力和爆炸荷載的分析研究。根據將橫肋、鋼筋及三維波紋鋼板的作用均勻分佈在殼體范圍內的情況，忽略橫肋、鋼筋及三維波紋鋼板沿殼體母線方向的抗拉、抗彎及其抗扭作用，首次推導出了內襯三維波紋鋼板混凝土殼體的微分平衡方程，建立了有限元計算模型，並採用三角函數法，求解了三維波紋鋼板混凝土拱型復合結構在分佈荷載和集中荷載作用下的位移響應和應力響應，並與普通殼體進行了比較。
  4. Traditionally, loads of the arc gate are applied on the support or gate frusta as a set of concentrated load, but the effect range of such load on the frusta cannot be solved by material mechanics and structure mechanics. most of the load cases are fulfilled through optic - elastic test

    通常弧門荷載作為一組集中荷載作用於牛腿或閘墩上，而這組荷載對閘墩受力的影響范圍材料力學方法和結構力學方法是不能解決的，受力狀況大部分是通過光彈試驗完成。
  5. This idealization would, however, disguise the fact that the thin web beneath the point load is in danger of buckling.

    然而，這個理想化的結構不能指出在集中荷載下面薄腹板處于屈曲危險的現象。
  6. The wavelet - based differential quadrature method ( wdqm ) is proposed to overcome the shortage of generalized differential quadrature method ( gdqm ) in treating the problem of concentrated loading

    針對廣義微分求積法求解集中荷載問題精度不高的缺點，本文利用小波微分求積法進行了改進。
  7. Regarding the rc beams subjected to concentrated load or even load and braced by bonding steel, an analysis is made on the relevant factors influencing maximum anchorage shear stress of steel sheet. the analysis is based on elastic theory and makes use of the formula for calculating anchorage shear stress of steel sheet. as indicated by the results, the maximum anchorage shear stress not only realtes to such parameters as height of cross section of rc beam and span but also relates to the thickness of adhesive layer, elastic modulus, thickness of steel sheet, and length of steel sheet. the present method will check maximum an chorage shear stress on the end of shear sheet so as to prevent rc beam from local damage. the present results will offer important reference for our country to further perfect bracing design by bonding steel method

    在彈性理論的基礎上，利用鋼板錨固剪應力計算公式，對在集中荷載或均布荷載作用下採用粘鋼加固的混凝土梁，分析鋼板錨固最大剪應力的有關影響因數.結果表明，最大錨固剪應力不但和混凝土梁的截面高度、跨度等參數有關，還和粘膠層厚度、彈性模量、鋼板厚度及鋼板長度有關.採用文中方法可以對鋼板端部最大錨固剪應力進行驗算，防止混凝土梁出現局部受拉破壞.研究結果為進一步完善我國粘鋼法加固設計提供重要的參考資料
  8. In this paper, five restrained beams with web and different longitudinal reinforcement were tested under static point loads, with the shear - span ratio being kept around 1. 5. on this basis, the overall process of cracking development under shear and the effect of longitudinal reinforcement ratio on it was investigated

    本文通過集中荷載作用下五根剪跨比為1 . 5 、不同縱筋率的有腹筋約束梁的試驗，深入研究了有腹筋約束梁的受剪破壞全過程及縱筋率對其的影響。
  9. Thea, aimed at different situation and with the combination of the compatibility truss theory and limited balance principle and the truss - strut model, the shear strengthening theoretic formula for the beams under concentrated load is put forward. ground on the test data and real engineering, the simple design formula is afforded

    然後，作者以桁架一拱模型和軟化桁架理論為基礎，綜合極限平衡原理，考慮了拉應變存在條件下混凝土抗壓強度的軟化，針對不同加固情況推導了集中荷載作用下的矩形截面約束梁的抗剪加固理論公式。
  10. On the basic of former research men ' s experience, 18 experimental members ( including 9 simple beams and 9 restrained beams ) are designed and tested. in the experiment, phenomena are observed and record by taking photos in the whole process from the first crack appears to test members crash completely, experimental data is attained including load values of crack - appear load, critical load and terminal load, stress values of reinforcing steel bar stress, compressed concrete stress and beam flank stress and values of deflection etc. by analyzing the crack ' s appearing and developing form and stress values of concrete and steel bars, the crash modes of test beams are defined ; shearing force - deflection curves are contrasted and analyzed ; the effects on shear strength of the three factors as shear span ratio, concrete strength and restraining moment are also analyzed

    借鑒已有試驗的經驗，本文設計和完成了對18根超高強混凝土無腹筋梁（包括9根簡支梁和9根約束梁）在集中荷載下抗剪強度的試驗，觀察了試件從裂縫出現到完全破壞失去承載能力全過程的試驗現象並通過拍照進行記錄，獲得了試件的斜裂縫出現荷載、臨界斜裂縫荷載和極限荷載等荷載值和縱筋應變、混凝土受壓應變和梁側混凝土應變等應變值以及撓度值等。
  11. Profiled sheeting made of coated or non - coated steel sheet and panels. bending tests under linear loads and or under concentrated loads

    有塗層或無塗層鋼製成形板.線性荷載和或集中荷載下的彎曲試驗
  12. In this paper we study the transverse stiffeners of the thinned - web beam bearing several concentrated longitudinal strain actions. thinking of using post - buckling strength of web plate, we study some facts about tran sverse stiffeners including strain ability, condition of breaking, calculation of strength and stabilization of the stiffener bearing regional load action

    本文對受多個集中荷載作用的薄腹板梁的橫向加勁肋進行了研究，分析了利用腹板屈曲后強度時，橫向加勁肋的受力狀態、破壞機理，以及加勁肋局部承壓的強度計算公式和穩定計算方法。
  13. Study of strut - and - tie models for simply supported deep beams subjected to point loads

    集中荷載作用下簡支深梁的壓拉桿模型研究
  14. Construction and examination concentrated load

    施工和檢修集中荷載15
  15. The non - linear equations of strings under a concentrated load are derived

    摘要建立了集中荷載作用下懸索的非線性方程。
  16. The natural vibration frequency analysis of suspended cables under a concentrated load

    集中荷載作用下的懸索自振頻率分析
  17. 0. 08g 1000 revolutions. mechanical capability : uniform load 9200 15000n m2, concentrated load 2900

    機械性能：均布荷載920015000n m ，集中荷載29003300n
  18. The elastic mechanics solution of statically indeterminate beams fixed at two sides under the action of concentrated load

    集中荷載作用下兩端固支梁的彈性力學解
  19. Top displacements get largest in structure under the concentrated load, and get smallest in structure under the uniform load

    結構頂點位移在頂點集中荷載下達最大，在均布荷載時最小。
  20. The paper points out that the natural vibration frequency of strings can not be used to that of suspension cables

    指出工程實際中不能將弦線的自振頻率作為有集中荷載作用的懸索的自振頻率。
分享友人
分享到 Line

分享到臉書