離合控制器 的英文怎麼說

中文拼音 [lígěkòngzhìqì]
離合控制器 英文
clutch control
  • 離 : Ⅰ動詞1 （離開） leave; part from; be away from; separate 2 （背離） go against 3 （缺少） dispens...
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 控 : 動詞1 （告發;控告） accuse; charge 2 （控制） control; dominate 3 （使容器口兒朝下 讓裏面的液體慢...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 控制器 : controller; regulator; monitor; pilot; keyer; manipulator; control unit; control device; [自動化]...
  • 控制 : control; dominate; regulate; govern; manage; check; cybernate; manipulate; encraty; rule; rein; c...
  1. So, this paper researches the principle of measuring system of insulating oil dielectric loss and volume resistivity. during the measuring process, the insulating oil must be heated and kept at 90 in 15 minutes. medium - frequency induction heating method is presented to instead of the electrical resistance furnace heating method on chapter 2, and a kind of subdivision - controlled integral - separated digital pid algorithm is designed to control the medium - frequency induction heating apparatus

    本文對恆溫控制系統進行了研究，提出了以中頻感應加熱方式取代原有的電阻爐加熱方式，設計了一種分段控制的積分分離式數字pid控制器來控制中頻感應加熱裝置，並通過通信設計將恆溫控制系統與介損及體積電阻率測試系統有機結合為一體機，實驗結果表明該恆溫控制系統完全滿足介損及體積電阻率測試中的控溫要求。
  2. 4. adopting full auto tension controler and magnetic powerm, magnetic clutch for unwinding and feeding drawing

    4放卷進料牽引採用全自動張力控制器和磁粉制動器離合器控制。
  3. 4. adopting full auto tension controller and magnetic power, magnetic clutch for unwinding and feeding drawing

    4放卷進料牽引採用全自動張力控制器和磁粉制動器離合器控制。
  4. Products includes clutch cover. clutch disk for light & heavy vehicles, piston ， engine for gasoline & diesel engine, shock absorber for light & heavy vehicles, auto remote security systems, power window controllers, normal alarm, door locks, fuel caps, steering column locks, alternator & starter, alloy & die casting parts, other automotive parts, wet and dry cylinder liner of gasoline and diesel engine

    主營產品有適用於輕，重型車用的離合器蓋，離合器鋼片，適用於汽油發動機和柴油發動機用的活塞，發動機，適用於輕，重型車用的減震器，汽車遙控安全系統，電窗控制器，報警器，門鎖，交流發電機，起動器，汽缸等。
  5. Yct series eddy - current coupling drives are ac speed - regulation motors, which are featured by easy contorl and stepless speed variation within a wide speed range

    Yct系列電磁調速電動機由拖動電機、電磁轉差離合器、測驗速發電機和電磁調速控制器組成。
  6. 5 ) from the viewpoint of synthetic fuzzy control, expert control and graded control, a practical control strategy and controller for cvt vehicle standing start is put < wp = 6 > forward

    5 ）從綜合模糊控制、專家控制和分級控制的觀點，提出了無級自動變速汽車離合器起步控制策略，設計了離合器起步模糊控制器。
  7. Regarding the hysteretic properties and time - varying of the system, the scan round performance of the controller, adopt incremental pid algorithm in constant - pressure controlling and combine it with the integral - separated dead - zone algorithm as appropriate for the situation of the measuring system and applies fuzzy self - tuning to control pid controller parameters

    由於系統的滯后時變性和控制器的循環掃描工作方式，恆壓控制採用增量式pid控制演算法，結合測量系統實際情況加入積分分離帶死區改進演算法，並對pid參數進行模糊自整定控制，設計了一種參數自整定模糊pid控制器。
  8. Automotive air conditioner accessories : automotive air conditioner cooler, evaporator, heat sink, air conditioner, temperature adjuster, heater, central cooler, air desiccators, cooling fan controller, internal heat exchanger, compressor, motor, air warmer, warm air device, electronic fan for cooling condenser, liquid can, thermal expansion valve, air condition pipeline, switch, clutch, connector, height valve, shunt valve and all kinds of automotive air conditioner production materials ( body aluminum, copper materials, etc ), production equipment, measurement equipment, etc

    車用空調配件：各種車用空調冷凝器、蒸發器、散熱器、空調器、調溫器、加熱器、中冷器、空氣乾燥器、冷卻風扇控制器、內部熱交換器、壓縮機、電動機、暖風機、暖風裝置、各種冷凝器電子扇、貯液灌、熱力膨脹閥；各種車用空調管路、開關、離合器、接頭、高低閥、換向閥及各種車用空調生產材料（車用鋁材、銅材等） 、生產設備、檢測設備等。
  9. Control of automatic diaphragm clutch engagement

    自動膜片彈簧離合器的接合控制
  10. The mathematic models of dc servomotor and clutch operation mechanism have been built. and controller has been designed. simulation results indicate that the operation mechanism and controller has good performance

    建立了伺服電機數學模型和基於膜片彈簧的離合器機械執行系統模型，設計了伺服電機驅動離合器執行機構及控制器，模擬結果表明，採用本文設計的離合器執行機構及控制器，響應快，控制精度高，滿足車輛起步的要求。
  11. They will short down the working life of air compressor because they are always started or stopped when we want to make the railway carriage stay in a fixed temperature. now, automatic and intelligent control systems are being applying in bus air - conditions control. in this way, computers control the work of air compressor, the turnaround speed of fan, the open degrees of wind controlled doors and so on

    我國大多數客車空調仍然採用簡單的壓縮機開關控制及循環離合控制系統，如：離合器?熱力膨脹閥系統（ cctxv ）和離合器?節流管系統（ ccot ） ，這些控制方式的精度低，當進行恆溫控制時壓縮機處于頻繁的開、停狀態，縮短了壓縮機的工作壽命。
  12. We prove theoretically that under certain reasonable assumptions the formation is asymptotically stable even wills bounded disturbances ; that is, the proposed sliding mode controller can asymptotically stabilize the errors in relative distance, relative bearing and heading direction, respectively

    在合理的假設下，從理論上證明了存在有界干擾情形下機器人編隊的漸近穩定性，即所設計的滑模控制器使得相對距離誤差、方位角誤差及運動方向誤差漸近穩定。
  13. Zalila [ 1 ] proposes the concept of hybrid fuzzy and classical controller ; according to the concept, the controller can be classified into the speed regulator and the distance controller, and the data transmitted back by the sensor in agv can be used as the basis of next what the vehicle should control

    提出混合模糊與傳統控制器的概念，把控制器分為速度調節器與距離控制器，根據車子傳感器所回傳的信息，做為判斷下一個車子所要控制的依據。
  14. Feeding and discharging ate controlled through magnetic powder brake and clutch ( japanese mitsbish aut tension controller )

    放料、收料均由磁粉制動器、離合器控制（或選配日本三菱自動張力控制器） 。
  15. Winding rolling photo - electricity with automatic deviation. every part of winding is adopted with magnetic powder clutch, and every part of rewinding is adopted withmagnetic powder clutch controller

    放卷光電自動糾偏。各放卷均採用磁粉制動器，各收卷均採用磁粉離合控制器。
  16. First, robust controllers design with mixed performance requirement is researched by giving output - feedback synthesis with h2, h and regional pole placement constraints. second, reduced - order robust filters design for continue - time / discrete - time systems is researched. the filters obtained are a set of permitted ones and have optimality and unbiased estimation

    首先，以極點配置、 h _ 2 、 h _為目標的輸出反饋綜合為例研究多目標魯棒控制器設計；再則，對連續離散時間系統研究降階魯棒濾波器設計，使得所設計的濾波器具有最優性和無偏性。
  17. This paper introduces control area network ( can ) into intelligent reclose controller, so it is very easy to construct multi - master system and multi - machine backup system. in feeder automation, after the intelligent reclose controller isolate faults, controller use the can to report fault message to dispatch center, helping determining the reason and fault point

    將can總線引入重合控制器，不僅實現控制單元的多主式通訊系統及多主機備份，而且往饋線自動化系統中，在重合控制器無通道自動隔離故障的基礎上，實現故障信息的匯總，便於調度中心及時的掌握故障原因及查找故障點。
  18. To apply neural networks to the simulation of ship maneuvering motion, an nnrm ( neural network recursive model ) is designed and used to simulate a serial full - scale tests conducted in yangtze river and the comparison between simulated results and the measured ones is satisfactory. ship trajectory tracking is a well - known maneuvering problem with an increasing practical and theoretical interest. but the real - world tracking applications encounter a number of difficulties caused by the presence of different kinds of uncertainty due to the unknown or not precisely known system model and environmental effects

    本文利用智能控制技術的優越性，嘗試將智能化控制技術用於船舶操縱運動模擬，初步探索了將現代控制理論和智能技術融入船舶操縱預報、模擬的研究方法，提出了用於船舶操縱運動模擬的線性神經網路（ lnn ） 、神經網路遞推模型（ nnrm ）和nnrm 、交錯航跡距離（ cte ）和視距（ los ）混合控制器模型三種控制模型：並將控制模型的理論研究應用到實船試驗數據分析、計算，將模擬結果與實際的試驗結果作了比較。
  19. Clutch locking controller was designed base on building model of clutch

    在建立離合器起步模型的基礎上，設計車輛起步模糊控制器。
  20. Using distributed architecture, this controller integrates functions of protection, metering, signaling, communication and new kind of distribution automation. it combines the function for integrated automation and feeder automation. so this product can be used not only in the reforming of substation, realizing the protection of equipments and power lines, but also in ring power network, through repetitious reclose, eliminating instantaneous faults and isolating permanent faults

    本文所研究的智能重合控制器採取戶外分散式結構，將保護和測量、控制、信號、通訊以及新型配電自動化等功能集成一體；與斷路器配合，將綜合自動化系統中的測量、保護功能與饋線自動化系統中的重合功能相結合，不僅可以運用於變電站的改造，實現站內設備、線路的保護；還可以運用於城鄉環網中，通過多次重合，消除暫時性故障，隔離永久性故障。
分享友人
分享到 Line

分享到臉書