離心試管 的英文怎麼說

中文拼音 [líxīnshìguǎn]
離心試管 英文
centrifuge tube
  • 離 : Ⅰ動詞1 （離開） leave; part from; be away from; separate 2 （背離） go against 3 （缺少） dispens...
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 管 : Ⅰ名詞1 （管子） pipe; tube 2 （吹奏的樂器） wind musical instrument 3 （形狀似管的電器件） valve;...
  • 離心 : 1 （不是一條心） be at odds with the community or the leadership2 （離開中心） centrifugal; eccen...
  • 試管 : [化學] test tube試管動物 test tube animal; 試管架 test tube stand; 試管培養 tube culture; 試管嬰...
  1. In this thesis hydraulic experimental studies and theoretical analyses on the vortex - flow drop shaft were conduced and the following results were accomplished : ( 1 ) in the model test some hydraulic characteristics including the shape of air core in the center of the drop shaft, the radial distribution of water flow velocity and the distribution of pressure on the wall of the drop shaft were measured under the condition of high water head above 250m and large discharge above 1400m3 / s. ( 2 ) a kind of computational method for the spiral water flow in the air core region of drop shaft was discussed and applied and the results agree the experimental data well. ( 3 ) the total ratio of energy dissipation in the drop shaft can reach 90 % and the energy dissipation in every region was discussed quantitatively

    本文通過試驗研究與理論分析對旋流式豎井泄洪洞應用於高水頭、大泄流量情況時存在的一些水力學問題進行了研究和探討，取得以下主要成果：一、結合小灣工程導流洞改建，對高水頭（ 252m ） 、大泄流量（ 1400m ~ 3 s ）條件下旋流式豎井中的水流運動特徵進行了比較全面的測量，包括空腔形態、徑向流速分佈及井壁壓強等；二、提出了豎井空腔段螺旋水流水力計算方法，其計算結果與實測值吻合良好；三、利用試驗與計算結果，對旋流式豎井的消能機理進行了探討，對豎井各部分的消能能力有了總體認識；四、對豎井下部消力井的合理井深進行了優化試驗研究，發現消力井合理深度為0 . 9d左右；五、通過試驗研究，歸納出豎井水流總摻氣量估算方法，為導流洞排氣方案的設計提供了參考依據；六、在高水頭、大流量條件下，豎井空腔段下部流速很高，盡管水流螺旋運動引起的離心力可以確保井壁壓強保持正壓，但空化數依然較低，因此豎井的空化空蝕始終是工程界關注的重大問題。
  2. Laboratory centrifuges ; centrifuge tubes for relative centrifugal acceleration up to 4000

    試驗室用離心機.相對離心加速度在4000以下的離心機管
  3. This research was also supposed to provide a valuable reference for the construction of 500kv eastern hangzhou transformer substation project. to guarantee the rationality of the torsion and bending load application, a set of experimental equipments was transformed from a traditional one by exerting tangential force on the brim of the fan board and conducting broad - billed roller application. in the actually fulfilled experiments on the capabilities of the members under different ratios of torsion and bending, the equipments proved to be well qualified in load applying to large - tonnage members

    試驗中，為保證扭轉及彎矩荷載施加的合理性，在浙江大學工程結構試驗室原有的加載設備的基礎上，分別採用在扇形板邊緣施加切向力和寬軸承滾軸加載的方法，改造並調試出一套可專門用於大噸位構件施加扭轉荷載及組合作用的試驗設備，並利用這套設備進行了離心鋼管混凝土構件在不同彎扭比的組合作用下的試驗研究。
  4. Given that these regulatory requirements are there for good reasons, because they are necessary for upholding the stability and integrity of financial systems, regulatory arbitrage should clearly be discouraged. one way of doing so is to put pressure to bear on the offshore financial centres for upgrading their regulatory standards and, for those who are slow or reluctant to effect improvements, to name and shame them

    為保持金融體系的穩定與健全，這些規管要求都是不可或缺的，因此試圖避過規管的做法顯然應受到制止，其中一個做法是對離岸金融中心施壓，要求它們提高規管標準，並點名批評不予改善或進度欠佳者。
  5. To discuss the feasibility of applying this technique into the practice of engineering, this paper references the real project of the running tunnel from great showplace to scientific house in shenzhen metro, uses the geotechnical centrifuge of southwest jiaotong university, then researches the settlement of the ground and the influence on the pipeline underground in stratum with abundant water by the technique of undraining spin - spay pile, at last draws a conclusion about the principle of the ground settlement with the construction method of excavating soil rich in water without dewatering at shenzhen metro

    為了探討離心模型試驗技術這一研究手段在地下工程中應用的可行性，結合地質、水文、結構較為復雜的深圳地鐵大科區間暗挖施工sk3 + 355斷面的具體實例，應用我校新近建成的100gt土工離心試驗機，採用離心模型試驗技術對在富水地層應用水平旋噴樁工藝進行控制降水施工對地表沉降變形及地下管線的影響進行了研究。
  6. As a result of growing need, in 1999, the research on capabilities of the centrifugal concrete filled thin - walled steel tubular under tension and torsion was started by zhe jiang electric power design institute and the civil engineering department of zhe jiang university

    針對這種情況，本文進行了一系列的試驗及理論研究。 1999年浙江省電力設計院結合500kv杭東變電所工程與浙江大學結構工程研究所合作開展了「離心鋼管砼結構抗扭性能的試驗研究」 。
  7. Specification for glass centrifuge tubes for general laboratory use

    實驗室通用玻璃離心試管規范
  8. In this thesis, the resistance performance of concrete - filled steel tubes under simple load is summed up first. according to the resistance expressions under press and bending, a concise formula of resistance under torsion is deduced on the ground of two former formulae. the format of this formula is of good similarity with that under press and bending

    在對比了原有的兩種計算方法的基礎上，對離心鋼管混凝土構件在純扭轉作用下的極限承載力公式，提出了與結果試驗更加吻合、形式上更為簡潔的抗扭承載力實用計算公式，在形式上與軸壓和彎曲承載力公式統一起來。
  9. The deficient mill output has been finally resolved by two renovation programs for the classifier and the central air pipe of d - 12 - d double - in and double - out mill, one of the biggest pulverizes ; higher ah inlet gas temperature and exhaust gas temperature also rectified by refractory modification and the tuning of sootblower " s running mode

    對世界最大的d - 12 - d雙進雙出磨煤機的分離器和磨煤機中心風管等部位通過兩種方案的改造試驗最終解決了該磨煤機的出力不足問題；通過對衛燃帶改造和調整吹灰器的運行方式解決了空預器入口煙溫和排煙溫度高的問題。
  10. This specification covers the manufacture, supply, acceptance testing and inspection of a number of centrifugally cast steel sleeves to be used for rolling canstock aluminium strip in a cold mill

    此規格包含了幾種用於卷動冷軋機中的罐料鋁條的離心鑄鋼套管的製造、供應、驗收測試和檢驗程序。
  11. This article is pointed out that the internal control system of our country commercial bank still is in stage newly established, and the internal control ground range international standard still has the equivalent distance, and the real effect is also too not ideal ? controlling the questions that exist in the system construction inside in accordance with our country commercial bank, and on the foundation to spirit that " the guide to the commercial bank internal control " according to the chinese people bank issuing is recently passed on and uses for reference the advanced interior accuse management practice experience of abroad commercial bank, this article puts forward building the tentative plan of pdca ' s internal control that fits our country national condition system o this tentative plan is stressed in the optimum research to realize the method of internal control system, and the substance is building the control system that the circular spiral moves upward of interior accuse policy decision - interior accuse execution - interior accuse control - interior accuse policy decision,

    本文通過對我國商業銀行內部控制現狀進行調查研究后指出，我國商業銀行的內部控制體系還處于初級階段，內部控制水平距離國際標準還有相當的距離，內部控制的實際效果也不太理想。針對我國商業銀行內控體系建設中存在的問題，根據中國人民銀行最近發布的《商業銀行內部控制指引》所傳達的精神並借鑒國外商業銀行先進的內控管理實踐經驗，文章嘗試把符合iso9002標準的質量管理方法（ pdca循環方法）和內控制度建設結合起來，在此基礎上提出建立一個符合我國國情的pdca內部控制體系的設想。該設想著重於內部控制體系最佳實現方式的研究，實質是建立一個以內控決策系統為中心，充分體現內控管理與監督，從內控決策? ?內控執行? ?內控監督? ?內控決策的不斷循環螺旋上升的控制體系。
  12. And the theoretical a nalyses done in this paper are listed below : first, the experimental data on the members of varied parameters under torsion demonstrate the general rule of the deformation while the tubular is under torsion. the paper establishes three phases of the deformation of the tubular under torsion, namely, the elastic deformation, the elastic - plastic deformation, and ultimate failure. through regression analysis, a simplified method is proposed for calculating the capabilities of the tubular under elastoplastic torsion, and the formulary for bearing value, is also recommended as a reference in engineering design

    本文根據不同參數的構件受扭性能試驗結果，研究了該結構受力變形全過程的基本規律，提出了受鈕全過程的三個工作價段，即彈性變形階段，彈塑性變形階段和極限破壞階段，經分析回歸得到扭轉全過程彈塑性的簡化分析方法及承載力計算公式，可供工程設計參考；同時根據本文的彎扭試驗結果以及對離心鋼管混凝土構件進行的理論分析，推導了彎扭試驗相關承載力的關系。
  13. Report accidents and incidents promptly to the responsible person. these include spillage of infectious materials and chemicals, breakage of tubes during centrifugation, cuts, burns and contamination of non - intact skin or mucous membrane by potentially hazardous materials

    發生意外或事故后須盡快向負責人員報告，包括傳染物料及化學品濺溢、離心沉澱時試管破裂，以及破損皮膚或黏膜被可能具危險性的物料割傷、燒傷或沾染。
分享友人
分享到 Line

分享到臉書