電位校正 的英文怎麼說

中文拼音 [diànwèijiàozhēng]
電位校正 英文
potential correction
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 位 : Ⅰ名詞1 （所在或所佔的地方） place; location 2 （職位; 地位） position; post; status 3 （特指皇帝...
  • 校 : 校名詞1. （學校） school 2. （校官） field officer3. （姓氏） a surname
  • 正 : 正名詞（正月） the first month of the lunar year; the first moon
  • 校正 : check; correction; adjust; revise; proofread and correct; rectify; calibrate; make true; master c...
  1. Single range voltmeters are normally calibrated at cardinal points ( maximum 10 test points ). for multi - range voltmeters, the basic calibration will include measurements at full ranges and linearity check at 5 voltage levels for one range. linearity check for other ranges can be offered at extra cost

    單量程電壓表一般以基點（最多十個測試點）進行校正；多量程電壓表的基本校正則會包括全量程測量及按五個電壓量位為一個量程進行線性檢查。
  2. Fourthly, this paper standardizes the linear of the inductance sensor and analyzes its error. then we discuss the angle error of the laser sensor and the datum plane error of the mechanism. finally, the paper gives some advice to improve the mechanism

    第四，此外，本文還對電感傳感器進行了線性校正及誤差分析，討論了激光傳感器傾角誤差，並對機械設計中的定位結構進行了誤差分析，提出了改進的措施。
  3. The correction of mass fractionation in the measurement of rhenium and osmium isotope ratios by icp - ms

    電感耦合等離子體質譜法測量錸和鋨同位素比值的質量分餾校正
  4. In the hardware design, the paper completes modules ’ design like outside memory, patulous a / d, patulous d / a, rs232 communication, ecan communication, led control, keyboard control, distant control, emulation, reset, logic voltage switch, dsp supply power regulate and ac - dc power circuit, as well as room layout design like anterior panel, back panel etc. and dsp transfers data with peripheral equipments except outside memory using serial ports. besides, the whole circuit is configured in interrupt response. thus, it can meet system demand as well as take full advantage of tms320f2812 ’ s hardware resource. in the software design, the paper finishs programs like the interface programms intercommunicates with people, the distant control program, ad and da modules ’ control program, in addition, the paper select the velocity and acceleration state - feedback algorithm and is written in the program. the software design uses dsp integrate exploiting environment named ccs2. 2 of ti inc. as software instrument, and programs with the combination of c language and assembly language. moreover, in order to maintenance or modify the software expediently and shorten software ’ s exploitation time, the design adopt software modularization technique. finally, some air cylinder experiments are carried out to proved that the pneumatic controller is very practical

    在硬體設計中，本文完成了片外存儲器擴展、 a / d擴展、 d / a擴展、 rs232通信介面、 ecan通信總線介面、液晶顯示控制、鍵盤控制、遠程控制、模擬、復位、邏輯電平轉換、 dsp工作電源校正電路和ac - dc電源等模塊設計以及控制器前面板、後面板等的空間布局設計。其中dsp與除外部存儲器的外圍設備之間的數據傳送全部採用串口通信，同時系統電路配置成中斷響應方式，這樣既滿足了系統要求，又充分利用了tms320f2812的硬體資源。在軟體設計中，本文完成了人機界面功能模塊、遠程控制模塊、 ad擴展模塊、 da擴展模塊、速度和加速度狀態反饋的控制演算法的程序設計。
  5. Measurement at full range setting for a dc current calibrator with not more than 3 ranges

    一臺不超過三個量程的直流電流校正器全量程定位測量。
  6. The feedbacks of position, velocity, acceleration and dynamic pressure were applied to adjust the model, so the control system of single jar electrodraulic servo mechanism was built. to reduce the system error and interference error, the compound control was designed. the results of simulations showed that the magnitude attenuation and phase lag of the system come to the project demand

    引入包括位置反饋、速度反饋、加速度反饋和動壓反饋在內的反饋控制技術對電液伺服驅動機構模型進行綜合校正，從而建立單缸電液伺服控制系統，並在分析系統誤差和擾動誤差后，加入復合控制減小系統誤差和抑制干擾，模擬結果表明復合控制系統的控製品質有了明顯改善，能夠滿足工程需求。
  7. Based on an analysis of the major factors affecting the quality of data obtained in aeroelectromagnetic survey, this paper has put forward zero horizontal drift correction methods such as field value standardization and phase check and correction, studied and developed a suite of techniques suited to data - processing and graphical representation for aeroelectromagnetic method

    摘要在分析探討影響航空電磁測量數據質理主要因素的基礎上，提出了場值標定，相位校驗改正等零水平漂移改正方法，研究開發了一套適合航空電磁法數據處理與圖示的方法技術。
  8. The simulation results show that, image will be severely degraded by phase fluctuations at typical conditions of the ionosphere, and can be well focused after calibration

    模擬結果表明，電離層引起的相位起伏對成像影響較大，校正後可得到比較滿意的結果。
  9. High water cut stage ; formation water resistivity ; spontaneous potential ; electrofiltration potential ; correction

    高含水期地層水電阻率自然電位過濾電位校正
  10. Curves in actual production, such as hole diameter, bed thickness, mud invasion, shale content, electrofiltration potential, etc. are analyzed. correspondent calibrating methods are proposed

    對影響自然電位曲線的各種因素井徑層厚泥漿侵入泥質含量過濾電位等進行了分析，並對其影響因素提出了校正方法。
  11. The steady - state errors of current closed loop system with pi current regulator in stationary and synchronous frames are compared using complex vectors. also, the corrector of rotor displacement control is studied by the root locus method

    應用復合矢量概念，對比了靜止坐標系和同步旋轉坐標系pi電流調節器組成電流閉環系統的穩態誤差，並用根軌跡法對轉子位移控制系統的校正環節進行了研究。
  12. Sb2015 - 3 precision decade dc resistance box adopts high voltage glass glaze resistors and special high voltage seal switch. its electric performance is very stable and insulation intension is very high. the resistance value can be adjusted under the condition of ceaselessly opening voltage ( note : the using switch should not be at the point of 0. ) it is easy to operate and suitable to be used to calibrate insulation resistance meter, and suitable to be used as high resistance standard

    3型精密十進位直流電阻箱採用高壓玻璃釉電阻器及獨特的高壓密封開關，電性能穩定可靠、絕緣強度高、可在不斷開測試電壓的條件下調節電阻值（正在使用的那隻開關不處在「 0 」位置時） 、操作方便，適用於檢定/校準絕緣電阻表，也可作為高阻標準。
  13. Sb2015 - 2 precision decade dc resistance box adopts high resistance superfine glass silk and special high voltage seal switch. it electric performance is very stable and insulation intension is very high. the resistance value can be adjusted under the condition of ceaselessly opening voltage ( note : the using switch should not be at the point of 0. ) it is easy to operate and suitable to be used as dc resistance standard to calibrate insulation resistance meter

    2型精密十進位直流電阻箱採用高阻玻璃微細絲電阻器及獨特的高壓密封開關，電性能穩定可靠、絕緣強度高、可在不斷開測試電壓的條件下調節電阻值（正在使用的那隻開關不處在「 0 」位置時） 、操作方便，適用於檢定/校準絕緣電阻表，也可作為直流電阻標準。
  14. Deserve to have room of the lacquer that bake, wds special computer detector, automobile body is corrective appearance, four - wheel the maintenance equipment such as line of fixed position appearance, automatic bolt and special tool

    配有烤漆房、 wds專用電腦檢測儀、車身校正儀、四輪定位儀、自動栓測線及專用工具等維修設備。
  15. Concerning the problem of the frequency instability, slight but not negligible, in electric power system, this paper discusses the resultant error in measurement in detail and develops an error - correction interpolated algorithm in frequency domain. taking advantage of the high calculating speed of pc, the measurement error in frequency, amplitude, and phase are well eliminated

    本文針對電網頻率輕微但不可忽視的不穩定造成的測量誤差問題進行了詳細的討論，形成了一套在頻域實現誤差校正的方法?插值演算法，並利用pc機高速的數據處理能力軟體校正了各次諧波的頻率、幅值及相位。
  16. Before more advanced lithography tool is produced, in order to use current tools to manufacture vdsm ic, reticle correction methods such as perturbing the shape ( via optical proximity correction ( opc ) ) or the phase ( via phase - shifting masks ( psm ) ) of transmitting aperture in the reticle are proposed by the industry

    在波長更小的光刻系統出現前，為了能利用現有設備解決集成電路的可製造性問題，工業界提出了對掩模作預失真（光學鄰近校正）和在掩模上加相位轉移模（移相掩模）等的掩模校正方法。
  17. To correct these effects, two methods were introduced in this paper : using weighted function to constrain second phase error caused by dispersion, and utilizing pga algorithm to reduce the phase perturbation due to the irregularities of the ionosphere

    本論文介紹了兩種校正方法：利用加權函數抑制色散效應引起的二次相位誤差，以及使用相位梯度自聚焦演算法較正由電離層的不規則性引起的信號相位起伏。
  18. The thesis finished a sample instrument used in measurement node. it is based on 8 - bit micro controller unit and has smart functions including auto calibration, auto scale change and auto balance of whetstone bridge. the data can be processed, stored, transferred and displayed in the sample device

    本文完成了測試系統中基於16位微處理器的網關的硬體架構和軟體實時多任務內核的設計；研製了基於8位微處理器的具有自校正、自動量程轉換及測試電橋的自動調平功能的測試節點樣機；實現了測試節點的數據處理、存儲、顯示和傳送；繪制並編寫了測試節點的硬體電路圖和軟體源程序。
  19. The basic calibration for a single decade ivd will include measurement of voltage ratio for all output settings of the ivd at one test frequency

    一個單盤感應分壓器的基本校正工作包括按一測試頻率，測量該電感分壓器所有輸出定位的電壓比。
  20. A new virtual calibrator for instrument transformer is presented. a phase difference correction method is applicable to correct electronic instrument transformer

    摘要介紹了一種新型的虛擬互感器校驗儀，它採用相位差校正法解決了校驗電子式互感器的問題。
分享友人
分享到 Line

分享到臉書