電動傳感器 的英文怎麼說

中文拼音 [diàndòngzhuàngǎnqì]
電動傳感器 英文
electrodynamic transducer
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 傳 : 傳名詞1 （解釋經文的著作） commentaries on classics 2 （傳記） biography 3 （敘述歷史故事的作品）...
  • 感 : Ⅰ動詞1 （覺得） feel; sense 2 （懷有謝意） be grateful; be obliged; appreciate 3 （感動） move; t...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 電動 : motor driven; power driven; power operated電動擺 motor pendulum; 電動扳手 electric wrench; 電動泵...
  1. Study on ultra - low frequency vibration sensor by using magnetoelectric speedometer

    用磁電式速度計實現超低頻振動傳感器的研究
  2. Electrical transducers recording on multichannel oscillographs are necessary for most structural dynamic tests.

    大多數結構動力試驗都需要可在多道示波器上進行記錄的電氣傳感器。
  3. Being added an anti - phase compensating winding, this device, which is placed between high voltage line and first insulator, makes the synthesized magnetic field in magnetic core reach a dynamic balance, and thus solves the problems from remanence and assures the measurement accuracy

    其漏電流傳感器增加一個反相的補償線圈，使得電流傳感器磁芯內的合成磁場達到動態平衡，解決了由於剩磁而帶來的問題，保證了測量精度。
  4. In order to make the sensitivity of 2 - demension accelerometer along the two main arbors almost identical, symmetric four - beam structure that embeds a double - sides interdigitated differential capacitive with puckered beam in two directions was used as sensitive component. in addition, the differential capacitive accelerometer fabricated by bulky silicon micromechanical technique has high sensitivity, wide measurement scope, less nonlinear error, and simple converting circuit. then, the structure parameters of the sensitive component were calculated and stimulated, which results in a set of the optimized structure design parameters, main fabrication procedure and several key fabrication technology

    為使二維振動傳感器在兩主軸方向的靈敏度大致相同，敏感元件採用高度對稱的四梁結構，其中每個軸向上均採用帶折疊梁的雙側叉指電容結構，採用體硅微機械工藝製作的高深寬比叉指電容式敏感元件，具有高靈敏度、寬量程、非線性誤差小、外圍電路簡單等優點;對設計的敏感元件結構參數進行了計算，並利用有限元法進行了模擬分析，根據模擬結果得出了優化參數;在確定敏感結構的基礎上，研究了敏感元件採用體硅微機械加工工藝製作的工藝流程和關鍵工藝技術;對敏感晶元內部的c - v介面電路進行了原理設計與分析，利用差動測量技術得到由振動引起的微小電容變化量，經c - v介面電路進行相位調制處理，然後通過解調輸出與加速度成正比的電壓信號。
  5. This system equips material movement transducer on feeding equipment ; meanwhile, it measures main current of double disk cooler ; the former inputs plc switching value ; the latter inputs analog quantity to judge material condition of double disk for avoiding no material or few material but much water feeding

    該系統在加料設備上加裝自行研製的物料移動傳感器，同時檢測雙盤冷卻器的主電機電流，前者輸入plc開關量採集模塊，後者輸入plc的模擬量採集模塊，用以判斷雙盤內的物料存留情況，避免無料或料少時水的過分加入。
  6. With the development of power system, on one hand, the capacity of the power system is increasing very rapidly and the system current becomes larger and larger. on the other hand, with the optimization of the administration and allocation of the power energy, the traditional ct can ’ t meet the demand. our company ’ new product ( vsm ) is very urgent to develop a new type of ct to meet such requirement

    現代電力系統的容量在不斷加大，系統電流值不斷增加;並且對電力系統的輸配電自動化要求也越來越高，需對電力系統的運行進行在線監測、實時控制、故障預測、保護、通訊等，傳統的電流互感器越來越難以滿足電力系統的發展，因此，在電力控制保護和監測中起樞紐作用的電流傳感器提出了小型化、高可靠性、智能化的要求。
  7. This paper introduces a miniature electric field sensor ( efs ) using dual piezoelectric ceramics bars as driving structure

    摘要一種新型的，以壓電陶瓷條為馭動、硅為屏蔽和感應電極的微型電場傳感器。
  8. Chang jun, liu tong - yu2, wang qing - pu, zhang xing - yu, wang qian, ma liang - zhu, li yong - fu, wang hong - chun, single - end fiber optic vibration sensor based on over - coupled fused coupler, optoelectronics letters, accepted

    常軍，王青圃，張行愚，劉統玉，馬良柱，李永富，過度耦合融熔雙錐型單端光纖振動傳感器，光電子?激光，已接收， 2006
  9. On the aspect of errors analysis of hrg, a brief introduction of the close - loop detection theory of hrg is present first. later the expressions of close - loop detection errors are deduced in theory. the impact of stimulating signals, turning speed, outside appended oscillation, the location & area of electrodes, and the current loss in capacitor is considered, and the primary analysis of error compensation is given

    在半球諧振陀螺誤差分析方面，本文從半球諧振陀螺的閉環檢測原理出發，對半球諧振陀螺閉環檢測誤差進行了分析和推導，考慮了激勵信號、轉動速率、外界附加振蕩、電極位置及極板面積和電容傳感器等因素造成的陀螺誤差並對誤差補償進行初步分析。
  10. The combined motor vibration sensor which is held manually with double charge amplifier placed inside and with frequency compensating circuit is designed based on the existed press - electricity accelerator of vibration and the measuring vibration system of charge amplifier in the paper

    本文在現有振動壓電式加速度計、電荷放大器測振系統的基礎上，設計了手持式內置微型雙電荷放大器和頻率補償電路的一體化發動機振動傳感器。
  11. This experiment can help students to understand that hysteresis really appears, to some extent, on actual materials, it can also help them to grasp the concept of distance between electrodes changeable capacitance transducer, and improve the ability to apply knowledge comprehensively and the ability to design and practice

    通過這一實驗，能幫助學生理解真實材料在一定程度上存在遲滯現象，掌握變極距電容傳感器的概念，提高知識的綜合應用能力和設計動手能力。
  12. Furthermore, capacitance - voltage converting circuit in the sensitive chip was designed and analyzed, and using differ - measurement technique trivial capacitance variation caused by vibration could be converted into detective voltage signal. secondly, signal processing circuit was designed and simulated

    二、對後端信號處理電路進行了設計及模擬，在外殼設計的基礎上製作出了雙軸振動傳感器樣品，並對其基本性能指標進行了測試與分析。
  13. First start sensor a first start sensor is an electronic device within some paralleling equipment that senses generator set and bus voltage and frequency, and determines whether or not a generator set is the first unit ready to close to the bus following a call to start under " black start " conditions

    首啟動傳感器首啟動傳感器是應用於某些並聯設備中的電子裝置，功能是感知發電機組和母排的電壓、頻率，判斷哪個機組在接到「黑啟動」信號后第一個可以合到母排。
  14. In this thesis, we focus on dual axis capacitance vibration transducer, which was fabricated by micro - electromechanical systems ( mems ). the operation mechanism of this kind of accelerometer was analyzed. under external acceleration, the space between sensitive quality mass and detecting electrode will change, which causes the variation of equivalent capacitance

    本論文研究了採用微機械加工技術（ mems ）製作的雙軸電容式振動傳感器，其基本工作原理是利用慣性質量塊在外界加速度的作用下與檢測電極間的空隙發生改變，從而引起等效電容的變化來測定振動加速度的。
  15. The controlling box collects the temperature and the humidity of the experiment box and the temperature of the water tank with platinum resistance transducer that has three paths. then they are sent to the microprocessor 89 c55 to dispose by a / d and sent to the d / a to be an 4 ~ 20 ma output of simulant value. at the same time, the outputs of six paths switch quantity drive respectively the relaies of heightening temperature reducing temperature alarm and so on

    「恆溫、恆濕控制箱」由三路鉑電阻傳感器採集試驗箱的溫度、濕度和水箱的溫度，經12位a d送至微處理器89c55處理，送至d a輸出4 20ma模擬量，同時，輸出六路開關量分別驅動加濕1 、加濕2 、升溫、降溫、除濕、報警等繼電裝置。
  16. The table is a important device in the hardware - in - the - loop simulation system, and it simulates the flight of unmanned aerial vehicle so as to achieve flying parameters from those sensors. the signals of sensors in the table are transmitted by many cables previously, thus it confines the movement range of the three - axis frameworks. as the perfomance of uav become complicated, the signals cables are replaced by wire rings in some tables, but it brings many difficulties and unreliable factors for the simulation table ’ s design also. bluetooth, as a new short - range wireless communication technology, is a reasonable and feasible scheme in this condition

    三軸模擬轉臺是無人機地面半實物模擬系統中的重要設備，用來模擬飛機在空中的姿態和角運動，以驅動傳感器產生飛行姿態、角速度及角加速度信號。早期轉臺上傳感器信號通過穿在框架中的電纜進行傳輸，這就限制了框架的運動范圍。隨著無人機任務的復雜程度不斷提高，出現了採用導電滑環傳遞信號的模擬轉臺，但這也給轉臺設計帶來了困難，且存在不可靠因素。
  17. The company has eight productive workshops with casting, forging, molding, copper - aluminium welding, injection, metal processing and heat - shrinkable cool - shringkable quality testing center. which owns abundant technical personnel, advanced examination means and first - class machinery equipment. quality assuranec system of the company is quite perfect, and our company has passed quality system approval of iso9001 and iso9002, all power products have received productive licenses of national technical supervisory bureau

    樂清市歐迪電子自動化有限公司是一家專業于電子傳感器研發製造的生產型企業公司具備有一流的技術團隊，十多年的開發經驗，不斷進行技術創新，致力於產品的精緻化設計強化管理過程式控制制，不斷追求卓越品質，擁有一流的產品完善的服務，良好的聲譽。
  18. A medium frequency - small size vector hydrophone of co - vibrating type is wrapped with low density compound material and in shuck only one piezoelectric ceramic accelerator is used for each channel to measure the vector components of the underwater acoustic field

    摘要中頻小型同振式矢量水聽器採用低密度復合材料作為矢量通道外殼、壓電加速度計作為內部振動傳感器，以拾取水下聲場中的矢量信息。
  19. To the object of two - flow, we trace its dynamic character and measure its correlated parameters by eight - electrode capacitance sensors. then turning the dispersed information to the integral information by sufficiently using information of object. the simulation experiment proved that this information fusion arithmetic can recognize the flow type precisely and timely

    針對管道中的兩相流被測對象，利用8極板電容傳感器對其在管道中的動態特性進行追蹤，並測取相關參量，利用信息融合演算法處理所獲得的信息，充分利用傳感器信息資源，將分散的傳感器信息融合成所測流型的整體信息。
  20. A scenario of the magneto - optical current sensor for large dynamic range measurement

    一種大動態范圍的磁光電流傳感器方案
分享友人
分享到 Line

分享到臉書