電流下降 的英文怎麼說

中文拼音 [diànliúxiàjiàng]
電流下降 英文
fall of current
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 下 : 下動詞1. （用在動詞后,表示由高處到低處） 2. （用在動詞后, 表示有空間, 能容納） 3. （用在動詞后, 表示動作的完成或結果）
  • 降 : 降動詞1. （投降） surrender; capitulate 2. （降伏） subdue; vanquish; tame
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  1. Pulse electric current heat treatment ( pecht ) developed by sodick, ltd., of japan, is a recently developed material processing method which consists of spark plasma sintering and welding, plasma activated sintering and welding, big pulse electric current ( bpec ) diffusion welding etc. the following are basic merits of pecht : rapid heating and cooling ; short sintering or welding time ; lowering sintering or welding temperature

    脈沖電流熱加工（ pulseelectriccurrentheattreatment ，比如燒結，焊接等）是九十年代發展起來的一種材料快速制備新技術，它包括放電等離子燒結與焊接、等離子活化燒結與焊接、脈沖大電流擴散焊接等。它具有升溫、降溫速度快、能在較低的溫度下燒結或焊接以及時間短的特點。
  2. Finally, the method of estimating power customer emission level based on binary linear regression is put forward, which make it a condition that harmonic emission is steady at the point of common coupling. combined with power system thevenin equivalent and customer norton equivalent, according to the principle of least squares method, the voltage that a customer ' s harmonic current begets at the point of common coupling can be estimated in the light of the plural correlation of network parameters

    最後，提出了基於二元線性回歸的用戶諧波發射水平估計方法，該方法在假設公共聯接點諧波發射穩定的情況下，結合系統側戴維南等值與用戶側諾頓等值的電路圖，按照最小二乘法原理，利用電網各參數的復數關系推導關于系統側諧波阻抗的二元線性回歸方程，並根據諧波阻抗的估計值求取用戶諧波電流在公共聯四川大學碩士學位論文（ 2003 ）接點產生的電壓降。
  3. Multiple functions available ： start / crater arc current, increase / decrease time, base / crest value current, pulse frequency, pulse rate, post flow time, hf welding

    功能豐富：起始/收弧電流、上升/下降時間、基值電流、峰直電流、脈沖頻率、占空比、滯后關氣時間分別可調，高頻引弧。
  4. Multiple funcyions available : start / crater arc current, increase / decrease time, base, crest value current, pulse frequency, pulse rate, post flow time, hf / friction welding, water / gas cooling

    功能豐富：起始/收弧電流、上升/下降時間、基值電流、峰值電流、脈沖頻率、占空比、滯后關氣時間分別可調，高頻/接觸引弧、水冷/氣冷可供選用。
  5. At last, control circuit of one cycle controlled bridge switching power amplifier is improved with the basic idea of one cycle control. the simulation results show that the amplifier of improved control circuit not only solve the question of output dc offset, but also keep the voltage gain lowered by voltage compensation technique

    最後，根據單周控制的基本思路，改進了單周控制的全橋開關功率放大器的控制電路。模擬結果表明，改進控制電路后的系統不但解決了輸出直流偏置問題，而且解決了電壓補償方法所造成的放大器增益下降問題。
  6. According to pump performance curve shown we can get that the distance h is changed with the rotate speed n in the same point q, and the flux q is changed with the rotate speed n in the same point h. from the curve we can get the rule that the distance and rotate speed are in direct with ratio at the same flux point, and the rotate speed and the flux are also in direct with ratio at the same distance point

    根據相似定律：流量與轉速的一次方成正比；揚程與轉速的二次方成正比；功率與轉速的三次方成正比。即在降低轉速，調低水泵出水揚程的同時，功率下降的幅度非常大，從中可以節省相當大的電能。完全應在高水位時降低水泵機組轉速，從而使電機的輸出功率隨著轉速下降值與轉速原值商的三次方關系下降。
  7. We found the " forward stimulated raman scattering " will be excited if the pulse length is greater than plasma wave length. the " forward stimulation raman scattering " decreases the phase velocity and the amplitude of the wake wave which will lead to the reduction of maximum kinetic energy of the electrons trapped

    結論是：當脈沖長度接近等離子體波長時，稀薄等離子體將發生「前向受激raman散射」 ，它使脈沖后沿拉長，導致尾流場的相速度變小，以至於被尾流場「捕獲」的電子最大動能大大下降。
  8. Basing on other researchers ’ work, this paper has put forward a novel type of icc ( induced current cancellation ) shielding layer for rfic / mmic performance improvement, to reduce high frequency loss, increase q value, and expand its application frequency range. and present how to realize rfic / mmic components such as i / o pad, inductors, baluns and so on by applying icc shielding layer structures. furthermore co - design methods of ic component structure and foundry process structure designs has been presented in this thesis

    在無線通信技術對cmos射頻/微波集成電路需求的大背景下，本論文提出了用於高頻集成電路（ rfic / mmic ）器件的各類新型icc （ inducedcurrentcancellation ，感應電流相消）屏蔽工藝結構，由此設計製造的ic部件解決了傳統半導體工藝無法實現射頻/微波集成電路的難題，以達到降低高頻集成電路器件的高頻損耗，提高器件q值以及擴寬器件應用頻帶的目的。
  9. Conventional hard switching technology has several flaws below : on and off loss, inductive off, capacitive on and diode recover problems. comparing with it, the loss of on and off decreases markedly, as the switches are on and off in zero voltage or zero current cases. and also the size of converter becomes smaller because of the higher of switching frequency

    傳統硬開關技術由於存在開通關斷損耗大、感性關斷、容性開通、二極體反向恢復等問題，與之相比，軟開關技術在零電壓或零電流條件下導通，開關損耗明顯降低，加上開關頻率的提高使得變換器的體積得以減小，這也是軟開關技術受到青睞的原因。
  10. By recharging voltage recharge current vary, and as for the recharge gradually increases, not because of battery heating period and declined slightly

    充電電壓因充電電流不同而異，並隨充電的進行而逐漸上升，到未期因電池發熱而略有下降。
  11. And the results of calculation and numerical simulation indicate, without increasing the intrinsic collector - junction area of power devices, collector - combed structure helps to raise the intrinsic heat - dissipating area and base ' s perimeter, improve heat - dissipating method of each cell of the chip, enhance the distribution uniformity of junction temperature and current of each cell of the chip, reduce the thermal resistance and raise the dissipation power pd and output power p0, fairly well relax the contradiction among frequency, out - put power and dissipation power of the devices, and further improve the devices " property against second breakdown

    而計算分析和二維數值模擬分析結果表明：梳狀集電結（基區）結構在不增加器件本徵集電結面積的條件下，增大了器件的本徵散熱面積和基區周長，改進了每個子器件單元內的散熱方式，提高了單元內結溫和電流分佈的均勻性，降低了器件的熱阻，增大了器件的耗散功率和輸出功率，較好地緩解了目前傳統結構中頻率與功率、功耗的矛盾，並有利於改善器件抗二次擊穿的性能。
  12. It has been confirmed practically that the diamond highness above base material can be adjusted with the range when the generator is put into use, and the result shows that the current density drop sharply with the increase of machining gap

    結果表明，間隙值的擴大伴隨電流密度的顯著下降，檢測電解電流控制脈沖能量的方法對實現電蝕層厚度基本可控是可行的，可讓金剛石突出一定高度。
  13. Transient electromagnetic methods ( tem ) can be called as time domain electromagnetic methods. the exploration equipments of tem include two units : transmitter and receiver. emission current falls down from i to 0 suddenly when step current passes through the transmitter loop

    瞬變電磁探測需要發射的電流激勵信號要足夠強、功率足夠大，發射電流波形的關斷時間要求比較苛刻，而且發射部分還需提供實時監測發射電流、關斷時間，記錄電流下降沿等功能。
  14. Elements of electrical and optical connection - test methods - voltage drop under specified current for terminal lugs and in - line splices

    電氣和光學連接元件.試驗方法.終端接線片和連機拼合接頭在規定電流下的電壓降
  15. From the experiment we have found out that the carbon fibre can improve the anode performance when it was used as pam additive and meanwhile it can have some benefits to the anode life. when its content at 0. 2 - 0. 3 % in pam can achieve its best result and under this situation it can improve the utilization of pam by 5 % at different discharge current. carbon fibre and sulfate sodium is used as complex pam additive and its effect is better than that of carbon fibre which alone is used as additive

    通過實驗我們發現，碳纖維作為鉛酸電池的正極活性物質添加劑能提高鉛酸電池正極的性能，並且對電池正極板的壽命有一定的好處，當碳纖維在正極活性物質中的含量為0 . 2 0 . 3能得到最理想的效果，這個時候能在各種不同的放電電流下提高正極活性物質的利用率5左右，並且能夠使極板的電化學阻抗降低。
  16. As a result, the fermi level at the surface will shift towards the valence band maximum ( vbm ). accordingly the band bending increases, and the surface depletion layer thickness enhances, therefore, the channel thickness reduces. this is the main factor resulting in the decrease of saturated drain - source current

    表面費米能級向價帶頂移動，能帶彎曲加劇，肖特基勢壘高度增加，表面耗盡層變厚，導電溝道變窄，是導致源漏飽和電流下降的主要因素。
  17. Aerospace series - elements of electrical and optical connection - test methods - part 217 : voltage drop under specified current for terminal lugs and in - line splices

    航空航天系列.光電連接件.試驗方法.第217部分:終端插片和內連接件用規定電流下的電壓降
  18. When the switch is closed, the variable pump has no oil supply, the current decline will keep the motor in empty waiting state, thus effectively save energy

    當水開關關閉時變量泵不供油，電流下降使電機處在空載待機狀態，這樣就有效達到節能。
  19. It deals preferably with interpolation output based on divided circuit. so, it ameliorates some characteristics of stepping motor, and improves interpolation precision. in this paper program is designed by mscomm to explain work principle of communication between person computer and single microcomputer for processing files designed by cad, then it is processing component parts

    本文對于在細分驅動中常出現的在細分電流的下降沿，由於電流下降速度慢而不能很好地實現細分的問題給予解決；解決了有細分電路后的插補輸出控制，這樣既改善了步進電機的某些性能，又提高了插補精度；為了將cad設計的加工文件直接通信給單片機，然後進行加工，本文用mscomm設計的程序用來說明其工作原理。
  20. The conclusion is that under the neutron and 7 - ray synthetical irradiation environment of a reactor, ionization effects of neutron on the vlsi made with cmos technology are weak, and that the displacement effects of neutron induces the decreases of mobility ratio and density of charge carrier, which causes the decrease of the total static current, so it compensates the increase of the static current caused by the synthetical ionization effects of neutron and - ray

    對試驗結果綜合分析得出：在反應堆的綜合輻照環境下，中子電離效應較弱，並且由於中子位移效應引起載流子遷移率降低和載流子濃度降低，使得總的靜態電流下降，從而抵消中子和射線綜合電離導致的靜態電流增長。
分享友人
分享到 Line

分享到臉書