靜態破裂 的英文怎麼說

中文拼音 [jìngtàipòliè]
靜態破裂 英文
static fracture
  • 靜 : Ⅰ形容詞1. （安定不動; 平靜） still; calm; motionless 2. （沒有聲響; 清靜） silent; quiet Ⅱ名詞（姓氏） a surname
  • 態 : 名詞1. （形狀; 狀態） form; condition; appearance 2. [物理學] （物質結構的狀態或階段） state 3. [語言學] （一種語法范疇） voice
  • 破 : Ⅰ動詞1 （完整的東西受到損傷） be broken; be damaged 2 （使損壞） break; break down; damage 3 （使...
  • 裂 : 裂動詞[方言] （東西的兩部分向兩旁分開） open
  • 靜態 : [物理學] static state; quiescent condition; steady state; statics; dead level; akinesis; akynesis...
  • 破裂 : break; fracture; burst; split; rupture; crack
  1. The corbel ' s dimension should be ascertained as the manipulative condition of diagonal section. the amount of longitudinal reinforcement be ascertained on the basis of the flexure model, is obtained according to static for balance condition, the calculative expression of the load is obtained. and in terms of the design method in ultimate state the maximum load

    我國規范對于牛腿的設計規定，牛腿尺寸的確定以斜截面抗裂作為控制條件，縱筋用量的確定以彎壓破壞模型為基礎，根據靜力平衡條件得到承載力的計算公式，按照極限狀態設計方法計算得到，箍筋用量則按照構造要求確定。
  2. Sicp / al matrix composites, with 5, 15 and 25 % volume fraction of sic particles, were prepared by vacuum hot - pressing sintering processing in this paper. based on mechanics properties, sem observation and energy dispersive x - ray analysis, the interface reaction phenomenon of sicp / al composites made by vacuum hot - pressing sintering, as well as the reinforcement and fracture mechanisms of this composite were analyzed. the dynamic responses of sipc / al composites were studied by a split hopkinson high - speed pressure bar impact system which strain rate was from quasistatic state strain rate ( 3. 3 10 - 3s - 1 ) to dynamic state strain rate ( 5. 2 103 s - 1 )

    本研究以武裝直升飛機防護裝甲材料為研究對象，採用真空熱壓粉末冶金燒結工藝制備了含sic顆粒體積分數分別為5 、 15和25的sic顆粒增強鋁基復合材料，結合其力學性能、掃描電鏡和界面微區能譜分析結果，分析了sic _ p al復合材料的真空燒結過程中的界面現象，以及材料增強和斷裂機理，並利用hopkinson高速壓桿沖擊實驗系統對其從靜態到動態（應變率為3 . 3 10 ~ （ - 3 ） s ~ （ - 1 ） 5 . 2 10 ~ 3s ~ （ - 1 ） ）的壓縮破壞響應進行了研究，分析了不同體積分數sic _ p al復合材料高應變率壓縮載荷下，材料的變形和微觀損傷機理，以及利用高速沖擊空氣炮測定了改復合材料制備剃度復合板的穿透性能。
  3. At first in the condition of low - velocity impact it is discussed with the formation of ceramic smash cone angle on the base of quasi - statistic hertz and 3 a 6 y a c - theory. then using spherical stress wave reflection and transmission theory under the state of medium - high velocity the formation of spot in the ceramic back. finally the damage mechanism of ceramic suffered by the high impact is simply discussed

    首先，在低速撞擊的條件下，基於準靜態hertz的理論與薩布斯基理論，分析了陶瓷破碎錐角的形成；其次，在中高速撞擊條件下，利用球面應力波反射迭加理論，分析了陶瓷背面的層裂的形成；最後，簡單討論了高速撞擊下陶瓷的破碎機理。
  4. Based on the pseudo - static experimental results of nine abnormal joints, the damage process of abnormal joint is divided into four stages of original crack, entire crack, ultimate state and failure, the effect of axial force ratio, stirrup ratio and height of column section on seismic behavior of abnormal joint are discussed, the conclusion that anti - shear capacity of abnormal joint are studied in entire crack state by studying the minor core of abnormal joint is made, the calculating formula for anti - shear capacity of abnormal joint is proposed with a view to asymmetry in stirrup yield

    摘要根據9個鋼筋混凝土框架異型節點試件的擬靜力試驗結果，指出異型節點受力過程分為初裂、通裂、極限和破壞4個階段；討論了軸壓比、節點核芯配箍率、柱截面高度變化對異型節點抗剪性能的影響；提出應考慮節點核芯區箍筋屈服的不均勻性並在通裂狀態下以「小核芯」為分析單元來研究此類節點抗剪承載力的建議；最終給出了異型節點抗剪承載力的計算公式。
  5. Together with the localization of seismicity on faults, this leads to the conclusion that a fraction of the crust is susceptible to rupture, while presently being quiescient

    與斷層的局部地震活動性一起考慮，可以得出如下結論地殼的一部分，在目前處于靜止狀態條件，它實際處於一種易受影響導致破裂的敏感狀態。
  6. At first, development of various cracks carefully recorded and strains on both the rebars and the stirrups were measured in detail, together with the deflections of the beam. in such a way, correlation between the measured strain profiles of the reinforcement and the observed cracking development of each specimen was pursued. principal factors contributing to the cracking pattern and failure mode were figured out as a result

    首先，通過單調靜力加載試驗研究，對梁的裂縫延伸和開展、縱筋應變、箍筋應變、梁的撓度等指標進行了細致的量測，試圖追蹤每一試件在裂縫發展及破壞過程中縱筋應變狀態的變化和裂縫發展程度的相關性，進而總結出有腹筋約束梁裂縫開展及鋼筋應力分佈的一般規律。
  7. According to test results of two specimens of local transfer rc joint from inclined column to beeline - shaped wall under vertical static loads and results of corresponding finite element analysis ( ansys ), fundamental behaviors of the joint are achieved, which include paths of vertical load transfer before and after cracking, stress distributions, occurrence and development of cracks and final failure mode of the joint

    本文通過兩個鋼筋混凝土斜柱?一字形薄壁柱局部轉換節點在豎向荷載作用下的靜力試驗以及有限元分析，獲得了該節點的基本性能，其中包括開裂前後的豎向荷載的傳遞路徑、試件應力分佈，裂縫的發生、發展，及試件最後的破壞形態等。
  8. Numerical simulation on splitting failure mode of rock under static and dynamic loadings

    靜態和動態載荷作用下巖石劈裂破壞模式的數值模擬
  9. The selection of primary parameters of demolishing the foundation of air compressor in the coal mine by static fragmentation measure, implementation method and blasting results are presented

    摘要介紹了用靜態破裂法拆除煤礦空壓機基礎的主要參數選取、施工方法及破碎效果。
  10. It is found that the great cracks on the coarse surface are initiated easily than on the smooth surface by the sem observation and the crack size obtained at the dynamic indentation experiment is bigger than at the static indentation experiment under the same load. it is showed the single crystal silicon is easier to initiate the crack and fracture under dynamic load, the single crystal silicon ’ s

    然後通過sem觀察單晶硅試件表面壓痕形貌，發現粗糙表面比光滑表面容易生成大裂紋，在相同載荷作用下單晶硅材料在動態壓痕試驗得到的裂紋要大於在靜態壓痕試驗得到的裂紋，表明在動態加載條件下單晶硅材料更容易生成裂紋和破碎。
  11. The quasi - static damage stage under the quasi - static stress field produced by gas from explosion. finally, the general model for blasting damage and fracture is gained. in the thesis, a gas - driven fracture propagation and damage localization at the crack tip model during explosion products are proposed

    根據爆炸力學，將巖石的爆破損傷分為兩個階段來研究，第一階段為爆炸應力波作用下的動態損傷階段，第二階段為爆生氣體靜態壓力場作用下的損傷階段，最終得出了巖石在爆破作用下的爆破損傷斷裂全過程演化模型。
分享友人
分享到 Line

分享到臉書