面模 的英文怎麼說

中文拼音 [miànmó]
面模 英文
face mold
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  • 模 : 模名詞1. （模子） mould; pattern; matrix 2. （姓氏） a surname
  1. - similar to asm, active appearance models ( aam ) is also composed of two parts : the aam subspace model and the aam search

    -與主動形狀模型演算法類似，主動表面模型也由兩部分組成：子空間模型和搜索過程。
  2. Experimental results demonstrate that our method can find the optimal aam subspace model rapidly and improve the performance of aam significantly

    實驗結果表明，本文提出的方法能夠快速、準確地找到最優子空間，從而極大地提高主動表面模型的性能。
  3. As a mix - mode chip, the application - specific controller including analog signal and digital signal processing block can be applied to receiving, amplifying, processing, controlling signals of pir, and offer a wide application in some fields. in analog circuits, by sub - threshold mosfet, a self - bias current source is presented, which has a high power supply restrain ratio and a complementary to absolute temperature characters

    這款晶元是一款數模混合晶元，包括模擬信號處理（含模數介面模塊）和數字信號處理兩大模塊，完整實現對紅外信號的接收、放大、處理、控制，產生有效數字電平驅動繼電器、可控硅等負載，應用於自動燈等多種場合。
  4. Docking mechanism test - bed is mainly used to simulate dynamics process of two aerocraft ’ s docking on the ground, validate rationality of the mechanism ’ s design and estimate stability of the docking process

    對接機構綜合試驗臺主要用於地面模擬空間兩飛行器對接的動力學過程，對機構設計的合理性、對接過程中的穩定性進行驗證和評估。
  5. Wherethe long bridge deck within 0. 5 l amidships is regarded as strengthdeck, the midship section modulus and minimum thickness of the deckplating comply with the requirements of 2. 2. 1 and 2. 4. 2. l of this ischapter

    例1 :在船中部0 . 5l區域內的長橋樓甲板作為強力甲板時，其船中剖面模數及最小厚度應滿足本章2 . 2 . 1及2 . 4 . 2 . 1的要求。
  6. A thoracic 3d model pool was established, composed of main structures including thyroid cartilage, criocoid cartilage, arytenoids cartilage, trachea, esophagus, main branches of great arteries and veins, sternal stem, clavicle, lungs and bronchi, and heart. the components could also classified into 2 categories, i. e. contour labels with two different solving powers, and surface models of main organs and the chest itself. the models could be showed in several ways

    包括甲狀解全學夕居戈j軟骨、環狀軟骨、構狀軟骨、氣管、食管、大動脈和大靜脈的主要分支及屬支、胸骨柄、鎖骨、肺和支氣管及心臟等主要胸部和頸部結構，該模型庫包括兩種水平解析度的器官輪廓，以及胸部各主要臟器的表面模型、胸部的整體模型，可以多種方式進行展示。
  7. Ais system is composed with communication processing module, base band processing module, radio module and interface module

    Ais系統由通信處理模塊、基帶處理模塊、射頻模塊和介面模塊組成。
  8. Bus interface module bim

    總線介面模塊
  9. ( 3 ) distill the environmental geologic factors and analyzes their harmness and reasons mainly analyzes the status in quo, reason, distribution, harmness and defend for the falls, surface sink, mine suddenly water, landslip, castoff, etc. ( 4 ) evaluate the probability of the geology calamity take use of the method of factors and coverage union to evaluate the probability of the geology calamity, and then plot out the high, middle and low probabilit

    （ 3 ）提取環境地質因素並進行分析其危害及成因利用提取的要素、數字地面模型和屬性數據庫及常規資料重點分析了構造、塌陷、礦坑突水、崩塌、廢棄物、地下水疏干區等要素的現狀、分佈、成因、危害及防治。 （ 4 ）為金礦區地質災害易發性做出評價利用權重值和圖層疊加的方法對金礦區地質災害易發性做出評價，把金礦區劃分為高易發地區、中易發地區和低易發地區，針對這些地區提出治理措施。
  10. Abstract : duri ng concrete deep well constructi on ， because of thediffi culti es i n engi neeri ng geographi cal conditi ons ， the ordi nary bilateral hydrauli c sli di ng formwork technology can not be adopted. therefore ， an unilateral sli di ng formwork technology lifted by chai n block method can beappli ed to advantage and better solved the proble m

    文摘:在混凝土深井施工中，由於受地理環境的限制，不能內外安裝模板時，難以應用一般的液壓滑模施工技術，而採用單面模板、鏈條葫蘆提升滑模工藝，可較好地解決這一問題。
  11. Gis ( geographic information systems ) is a computer system with collecting, checking, intergreting and analysing information which is related with interface of earth. digital terrain model display two demission geographic position and relational properts information with digital pattern. dtm is an important component of gis, and is basic of " digital earth "

    數字地面模型（ digitalterrainmodel ， dtm ）是地表二維地理空間位置和其相關的地表屬性信息的數字化表現，是地理信息系統（ geographicinformationsystem ， gis ）的重要組成部分，是數字地球的基礎。
  12. A plane pattern of equilateral - dodecagon based camera self - calibration

    基於正十二邊行平面模板的攝象機自標定
  13. Regard - ing the surface runoff mechanism, liang and xie 1, 2 presented a new surface runoff parameterization which dynamically represents both the horton and dunne runoff generation mechanisms within within a model grid cell together with a consideration of the subgrid - scale het - erogeneity, which can be applied to not only humid regions but also droughty regions as well 3, 4. regard - ing the soil water movement, xie et al. 5 developed an unsaturated flow numerical model based on the finite element method, and xie et al. 6 presented another numerical model to compute soil moisture and water flow flux together by means of a mixed finite element method

    在地表徑流方面，文獻1 3發展了一種同時考慮蓄滿超滲產流機制及次網格非均勻性的新的徑流機制模型，並用其改進了陸面模式vic variable infiltration capacity中的徑流計算，該模型既適用於濕潤地區也適用於乾旱地區4 .在土壤水模型方面，文獻5採用有限元質量集中法發展了非飽和土壤水流的數值模型，文獻6則採用混合有限元法建立了非飽和土壤水分含量和通量計算的數值模型
  14. ( 1 ) at first, the conception of egis is put forward. and some basic techniques of it are discussed, including the integration of the applied numerical model with gis, the research of creating dem ( digital elevation model ) and the application of dem in ece

    本文的主要研究內容是： （ 1 ）提出建立工程地理信息系統egis ，並進行一些基本方法的探討，包括應用模型與gis集成模式的討論，數字地面模型生成的方法比較和應用。
  15. Response surface model of proper dosage and exposure time of a broad spectrum fumigant, sulfuryl fluoride

    硫酰氟熏蒸除鼠的投藥劑量與作用時間的響應面模型研究
  16. Corneal surfaces in eyes with regular astigmatism are thought to be toroidal surfaces. based on mathematical models for corneal surfaces before and after treatment, a corneal ablation model is given for such refractive errors as spherical myopia, compound myopic astigmatism, and simple myopic astigmatism. a similar corneal ablation model is also given for such refractive errors as hyperopia, compound hyperopic astigmatism, and simple hyperopic astigmatism

    採用超環面（ toroidalsurface ）建立起規則散光下的角膜曲面模型方程;定量研究了手術光學區屈光不正兩種通用的矯正模型，一種模型適用於單純近視、復性近視散光、單純近視散光的矯正，另一種模型適用於單純遠視、復性遠視散光、單純遠視散光的矯正;另外，作為影響手術效果的重要因素，提出了一種用於光學區直徑和過渡區寬度均可調節時過渡區角膜切削量的計算模型。
  17. And the interfaces have analog input, analog output and digital input / output. we have used differently cards, such as pc - 6330d a / d card, pcl - 728 d / a card based isa bus, ipc - 5375 i / o card and so on. in addition, we select micro - stir switches and pressure sensors as sensor elements to inspect the system and choose relays and induction valves to control the bicycle pump and the motor

    總線採用isa內部總線；介面主要有模擬量輸入介面、模擬量輸出介面、開關量輸入輸出介面等，課題分別選用pc - 6330d型a d板卡、基於isa總線的型號為pcl - 728的d a板卡、型號為ipc - 5375的i o板卡；另外，課題選用了微動式行程開關、壓力變送器作為傳感元件檢測系統，選用繼電器、電磁控制換向閥實現對氣缸、電機的控制；採用vc + + 6 . 0編制控制軟體，實現了纖維鋪放技術的計算機控制。
  18. From the model study of the fractal random rough surface, we acquire one dimensional ? two dimensional fractal random rough surface model with fractal theory ; 2. the calculation of the scattering field of light ; the establishment of the scattering light ’ intensity model, and the number calculation of the intensity distribute ; 3. the study on the laser radar cross section of one - dimensional fractal rough surface target ; and the number calculation of the scattering intensity of two - dimensional fractal the rough surface target ; 4. through shadowing effect, we analysis light scattering characteristic of fractal rough surface

    本論文利用分形理論得到一維?二維分形隨機粗糙表面模型，研究光在一維?二維分形粗糙表面的光散射特性，主要從以下四個方面分析: 1 .自仿射分形隨機粗糙表面模型探討，採用分形理論得到一維?二維分形隨機粗糙表面模型; 2 .分形粗糙表面散射光場的計算和粗糙表面散射光強角分佈的模型建立和數值計算; 3 .一維分形粗糙表面目標的激光雷達後向散射截面lrcs研究和二維分形粗糙表面目標散射強度數值計算; 4 .引入遮蔽效應分析分形粗糙表面光散射特性。
  19. Modulus of midship section

    舯剖面模數
  20. Second, the imaging model built here has taken into account the tilt modulation, the hydrodynamic modulation, and current modulations of radar cross section. consequently, it has realized the imaging simulation of four kinds of wakes with the same imaging model. third, the orbital velocity of ocean wave was considered as the basic dynamic factor, and the imaging model calculates the influence on raw data by the wave m ovement according to the orbital velocity

    該模型的主要特點是： （ 1 ）它採用了三尺度復合表面模型的思想來計算海面的電磁散射，考慮了中等尺度波對紋波的進一步調製作用，彌補了傳統雙尺度模型的不足； （ 1 ）它考慮了海浪的傾斜調製作用、流體動力調製作用和流場對雷達截面的調製作用，實現了用統一的模擬模型對四種艦船尾跡特徵進行成像模擬； （ 3 ）它把海面長波的軌道速度作為基本的動態成分，並依此來考慮海面運動對sar回波信號的影響。
分享友人
分享到 Line

分享到臉書