預測差誤 的英文怎麼說

中文拼音 [chā]
預測差誤 英文
forecasting errors
  • : Ⅰ副詞(預先; 事先) in advance; beforehand Ⅱ動詞(參與) take part in
  • : 動詞1. (測量) survey; fathom; measure 2. (測度; 推測) conjecture; infer
  • : 差Ⅰ名詞1 (不相同; 不相合) difference; dissimilarity 2 (差錯) mistake 3 [數學] (差數) differ...
  • : Ⅰ名詞(錯誤) mistake; error Ⅱ動詞1 (弄錯) mistake; misunderstand 2 (耽誤) miss 3 (使受損害...
  • 預測 : calculate; forecast; prognosis; divine; forecasting; foreshadowing; predetermination
  1. 5. the osl dating of 37 samples of loess in weihe river basin by sar and multiple aliquot methods, indicates that sar protocol appears to be applicable to loess and appropriately correcting for sensitivity changes within the regenerated curves, however, there are major difference between the irsl and post - ir osl de determinations that suggest that sensitivity changes relating to either ( or both ) natural signals may not be correctly monitored

    同時,用單片再生劑量法小干3ha的黃土細顆粒樣品, slsl 、 irsl和post irosl的年代在范圍內基本相同,接近估年代;對於3ha ? 10ha的黃土細顆粒樣品,一般post osl的年代更接近值;對于大於10ha的樣品,一般irsl的年代普遍太小,多數blsl年代也偏小,而p 。
  2. The model of the itr between a1n and cu is built by using the acoustic mismatch model, amm and diffuse mismatch model, dmm. because there is a limit of roughness and temperature in amm and dmm, the data of the theory model that is directly built by amm and dmm is far from the experimental data. accordingly, with dmm and traditionary methods, the mathematics model is posed by contrast and analyses of the experiment data

    由於聲失配理論和散聲失配理論對溫度和粗糙度有很嚴格的要求,所以直接建模所得的理論數據與實驗數據有很大的距,本文採用聲失配理論與傳統研究方法相結合,通過與實驗數據的分析擬合,提出了修正的數學模型,有了大幅度的提高。
  3. The pressure drop of the compound tray can be regarded as consisting of dry plate pressure drop, clear liquid resistance, liquid surface tension resistance, and packing pressure drop. the model that has established can fairly predict the pressure drop of the compound tray, the value calculated by the model compared with that detected by experiment is less than 20 %

    復合塔板的壓降可認為由干板壓降、清液層阻力、填料層壓降和克服液體表面張力的壓降四部分組成,所建立的壓降計算模型,能較好地復合塔板的壓降,計算值與實驗值在20以內,可用於工程設計。
  4. The s - l - e experiment data for the eight binary condensed systems of fatty alcohol / fatty acid were treated by using the improved equation, and the equation was examined with experimental data. at the same time, we used ideal model to predict the tenary s - l - e of n - octadecane / lauric acid / stearic acid system, and we got an accurate result of the simple eutectic temperature. the relative error is 0. 51 % comparing with the experimental result, so we will offer a method of prediction for quickly obtaining multicomponent system phase change materials this article calculated the pcms quantities and energy saving effect in theory, designed the experimental apparatus to measure the energy saving effect, and analyzed the temperature equalization action of the pcms by comparing experiment

    利用這種方法,建立了適合醇-羧酸等系列二元體系的單參數margules方程,本文對醇-羧酸系列等8個二元凝聚體系的單參數margules方程的參數進行回歸,並利用整個實驗數據對模型進行了檢驗,另外,本文利用理想狀態模型對一個三元體系18烷-月桂酸-硬酯酸相圖進行,通過與實驗數據進行比較,的低共熔溫度與實驗定溫度較為吻合,其相對為0 . 51 ,這將為快速獲取多元體系的相變材料提供方法。
  5. For rotor steel ( 30crlmolv steel ), the tests of low - cycle fatigue property are done under different temperatures. the fatigue life under different temperatures is researched to make up for the defects of the testing for foreign similar materials. when pull - stretch data is attempted to evaluate low - cycle fatigue data, the result shows that four - point associated method in middle - low life zone is done well under room temperature, but there are large errors of four - point associated method and general - slope method under other temperatures

    在本文中,通過與國外同類材料的性能進行比較,國產材料與國外材料共有的材料特徵基本相同;對轉子鋼( 30crlmolv鋼)進行了不同溫度下的低周疲勞性能實驗,研究其在不同溫度下疲勞壽命,以彌補國外對同類鋼材試的不足;採用拉伸數據低周疲勞壽命時發現,室溫條件下用四點關聯法在中低壽命區較好,在高溫條件下四點關聯法和通用斜率法都有較大,需要進行改進。
  6. ( 2 ) the liman problem is normally adopted to check the liability of numerical method. the calculation error was within 9 % by comparison with the theoretic solutions of liman problem in the following case, the dimensionless calculation length was 2 with high pressure zone 0. 8, and the dimensionless state parameters were p1 = 2, p2 = 1, p1 = p2 = 1, u1 = u2 = 0. experiment results in literature [ 8 ] were used to check the adaptability of the numerical model developed here for unconfined gas cloud explosions and the calculation error was within 13 %

    ( 2 )數值方法的可靠性通常用黎曼問題的解析解檢驗,本文以無量綱計算區長度為2 ,高壓區長度為0 . 8 ,狀態參數為p _ 1 = 2 , p _ 2 = 1 , _ 1 = _ 2 = 1 , u _ 1 = u _ 2 = 0條件下的黎曼問題解析解對所編制的爆炸場計算程序進行了考核,結果表明該程序的計算在9以內;為考核本文計算模型開敞空間氣雲爆炸的適用性,以文獻[ 8 ]的實驗數據進行了校核,計算在13以內。
  7. Experimental results show that the pls model gains higher prediction accuracy with the mean prediction error 0. 2 octane number. 3

    實驗結果表明pls模型在精度上優于mlr模型,其平均0 . 2個辛烷值單位,完全可以滿足實際應用的需要。
  8. Then, mre reaches 3. 21 % for workday and 5. 96 % for holiday. a unique next 24 hours hourly cooling load prediction ann model is established

    對工作日負荷,其平均是3 . 21 ;對假日負荷,其平均是5 . 96 。
  9. Based on the back - analysis data of some excavation stage, through the non - linear finite element program nef, we can predict the tendency of next excavation stage. the relative error between calculation and measurement is controlled in 25 %, demonstrate the estimate prediction is successful

    根據反演的某一階段的土體參數值,通過非線性有限元程序nfp ,后一階段的邊坡變形情況,實例中理論計算值與實值的相對控制在25 %以內,說明是成功的。
  10. Based on the error theory of point measurement are the identifying of the error range set, sketch of the error ellipse, analysis on displacement of the monitoring sites and error detection, providing a fundamental theory infrastructure for dynamic assessment of surface displacement and gray prediction

    根據點位量的理論,確定定值域范圍,繪出橢圓;對各監點進行位移與判別分析,為地表位移動態分析和灰色提供理論基礎。
  11. Linear predictive coding ; lpc prediction error ; cepstrum ; dynamic time warping

    線性編碼lpc lpcpe線性倒譜動態時軸彎曲或動態時間規正dtw
  12. Backward prediction error filter

    反向濾波器
  13. The terminal states of the vehicle at the taem ( terminal area energy management ) interface box were predicted through the integration of the equation of motion, and to correct the state errors which the angle of attack and the bank angle were corrected in real time

    通過對運動方程積分飛行器在能量管理段界面處的終端狀態,實時調整迎角和傾側角方案,以使終端狀態滿足要求。
  14. In collaboration with the department of physicis and material science of the city university of hong kong and the electronic and engineering department of the chinese university, the faculty of medicine has conducted research on different aspects of computer - aided navigation such as brain shift prediction with finite element model, three - dimensional ultrasound based correction for brain shift, accuracy verification, robotic system, surface identification and matching

    通過與香港城市大學物理及材料科學系及香港中文大學電子工程學系的協作,我們正發展電腦輔助的神經導航技術的多方面研究,例如,採用有限元模型腦偏移;除去腦偏移的的立體超聲檢查技術;手術準確性的證實;腦表面區域的定位。
  15. Therefore, a model of three sectors, respectively referring to domestic sector, manufacturing export sector and primary product export sector, has been established here to measure the technology spillover effects of export on domestic sector. finally, based on a broader framework, this dissertation went on to investigate the relationship between openness and china ' s economic growth, while the result shows that though there exists a notable dispute about how to measure the degree of china ' s openness, the index of trade dependence still maintains the better one to reflect china ' s economic openness. in the meanwhile, impulse response function ( irf ) method and forecasting errors variance decomposition ( fevd ) method, both of which are based on the vector auto - regression ( var ) system, are used here to investigate the dynamic relationship between openness and china ' s economic growth

    與傳統理論不同,新增長理論和新貿易理論都強調技術進步的作用,因此本文構建了一個三部門的技術外溢效應模型(國內部門、工業製成品出口部門以及初級產品出口部門) ,考察了工業製成品出口和初級產品出口對國內非出口部門不同的技術外溢效應;第四,從更加廣闊的視野就貿易開放度與中國經濟增長問題進行研究,有關貿易開放度如何度量一直是存在較大爭議的問題,本文首先對該類研究文獻進行了較為詳盡的述評,然後運用生產函數方法對所選取的5個貿易開放度度量指標進行了檢驗,結果發現盡管一些已有研究認為外貿依存度無法真實度量一國經濟開放水平,但是本文研究結果表明外貿依存度仍是度量我國貿易開放度的較好指標,進一步採用基於var系統的脈沖響應函數法以及方法分解法對貿易開放促進經濟增長的作用進行了動態刻畫。
  16. What these errors of shooting elements are composed of and what bring about these errors are specified. with these errors, how to set a correlative error model and to dope out new errors with the model are also presented

    在分析了射擊諸元的構成和來源之後,對進行了建模和,為軟體實現射擊校正提供了理論依據。
  17. It utilized the quantity theory and the regression analytical method, took example for modifying and simulating corn growth model, which is one of original model of crops yield of heilongjiang province. according to yield predict and error analysis for model, it verified the model had applicable value

    利用數量化理論和回歸分析方法,以原黑龍江省大區域作物產量模型之一?玉米生長模型為例,進行了玉米產量模型的修正和擬合,通過對該模型的產量分析,證明該模型具有實際應用價值。
  18. Lyapunov exponent depict the discrete extent of chaotic dynamic system. there propose an estimation of one step prediction error based on lyapunov exponent, the estimation express the reliability of prediction numerically. at the same time, in order to improve the predictive precision it drew out an error complement methods creatively to correct one step prediction

    Lyapunov指數定量刻畫混沌離散動力系統的平均發散程度,基於lyapunov指數作出了一步估計,以此來定量反映的可靠性;根據奇異吸引子流形的性質,創造性的提出殘補充法,對值作出修正以降低,提高精確性。
  19. Prediction and error analysis of post - construction settlement for soft soil embankment using the r. usher gray model

    基於灰色模型的軟土路基沉降分析
  20. Quantitative analysis is the second module in the stock price forecast system ( the first module is solving the problem of what kind of stock should be chosen. ). the stock price forecast model has been built by utilizing mathematic methods and cad. in this model the error is also be controlled within the specific limits

    定量分析在定性分析的基礎上(即解決了買什麼樣的股票問題后) ,利用數學建模、計算機輔助設計對股票價位進行,並將控制在一定范圍內,從而對先前定性分析得到的結論作進一步驗證。
分享友人