風機葉片 的英文怎麼說

中文拼音 [fēngpiān]
風機葉片 英文
fan blade
  • : Ⅰ名詞1 (空氣流動) wind 2 (風氣; 風俗) practice; atmosphere; custom 3 (景象) scene; view 4 ...
  • : machineengine
  • : 片構詞成分。
  1. Application research on the anti - wear coatings of axial - flow id fan blades for coal - fired boiler

    燃煤鍋爐軸流式引風機葉片耐磨塗層的應用研究
  2. Nonlinear stress analysis on blade of tunnel fan

    隧道通風機葉片非線性應力場分析
  3. This paper made three contrast experiments on changing fan ' s inlet, analyzed the preventing erosion theory of each experiment and the improvement degree of the erosion of fan ' s impeller and vanes

    論文對改造進氣箱減磨的方法進行了三個對比實驗,分析了不同方法所採用的防磨損理以及對磨損的改善程度。
  4. The paper researches the blade ' s destruction way, then, finding the protection ways of the blade, at last realize it using software and the hardware. at the present, the prototypical doesn ’ t make out. the article only builds a foundation for the further analysis

    文中通過對風機葉片的破壞方式的分析研究,最終確定的保護方式,並用軟體和硬體實現,為進一步製造出樣和上試驗作好準備。
  5. Rotor blades for off grid wind turbine generator system

    離網型力發電組.
  6. A motor that is be directly coupled to a fan - blade or blower - wheel load is to be operated at the applicable test voltage and under no - fan, no - load conditions with the shaft running free

    直接耦合到一個或鼓輪負荷的馬達,將在適用的試驗電壓下做無扇,無負荷,軸空轉狀態的運行。
  7. For solving the problem of insufficient temperature drop, adopts some improvement measures including relocating filling materials, adjusting the rotational speed rate of the fans, increasing the fan blade quantity and using wider fan blades

    摘要針對冷卻塔降溫效果較差問題,採取了重新碼放填料、調整轉速比、增加風機葉片數量、加寬直徑等改進措施。
  8. Port engines ingested some foreign matter during take - off roll, fan blades severely damaged, we abandoned taxing back to terminal

    起飛滑跑中左發進氣口吸入異物, (渦輪)損壞,中斷起飛,滑到候室。
  9. Rotor blades of wind turbine

    力發電
  10. For the dual register burner, while cat being applied, it simulates the influences of the flow field in the burner by changing the velocities of primary flow and inner / outer secondary flows, and by changing the opening percents of inner / outer vanes. eventually, the appropriate values for velocities and opening percents of vanes are recommended, to provide engineering problems with theoretical orientations

    針對雙調旋流燃燒器,本文運用計算輔助試驗( cat )方法對一次速度,內、外二次開度及內、外二次速度對燃燒器內流場的影響進行了數值試驗,得出了雙調旋流燃燒器推薦使用的二次開度和速度值范圍,為工程應用提供了理論依據。
  11. Nonlinear study on the blade crack of axial fan

    軸流風機葉片裂紋的非線性研究
  12. According to european standard of wind turbine authentication, fatigue loads are selected by this dissertation as the main subject. so, a system of fatigue loads is designed. as the most important components, loads and life prediction of blades and tower of wind turbine are measured

    結合國外力發電組檢測認證的項目內容,本文選取了主要參數中的疲勞載荷構建了力發電組的疲勞載荷測試系統,重點是對力發電和塔架做了疲勞載荷分析和壽命預測。
  13. Each rotor core is visually inspected for complete filling of the die - cast end rings and fan blades

    每個轉子芯都經過人工檢查是否完整配置壓鑄軸承擋圈和風機葉片
  14. The enterprise mianyang langdi plastic product co., ltd. integrated with us drives out fan blade also among other things

    公司專業從事吸進、定影以及吸入、吸附和通風機葉片業務。
  15. E april 23rd, ' 57. cape caught in a jet turbine

    57年4月23號,披被吸進發動
  16. The company ninghai dapeng mould plastic co., ltd. offers among other fan blade

    的業績不僅在於廣泛的服務,還包括通風機葉片業務。
  17. The mathematics model and development of mix blades flow fan

    扭曲變截面風機葉片的形成分析及展開
  18. Analyst and treatment of blade crack with finite element method

    基於有限元法的風機葉片裂紋分析及處理
  19. Firstly, discus the blade destruction mechanism, in order to learn about the reason of the blade being destroyed, and then designing the protecting plan

    首先對風機葉片破壞理進行了探討,明確破壞的原因,確定保護方案。
  20. The paper mainly divides into five parts, first about the anemometer blade ' s domestic and foreign present situations, then narrated the blade ' s air operated structure and the expiration forms, in this foundation, proposed the blade protection technical plan, finally separately realized two aspects concrete narrations protection module design from the hardware design and the procedure

    文章主要分為五個部分,首先講了風機葉片的國內外現狀,接著講了的氣動結構及失效形式,在此基礎上,提出了保護的技術方案,最後分別從硬體設計和程序實現兩方面具體的敘述了保護模塊的設計。
分享友人