驅體 的英文怎麼說

中文拼音 [qūtǐ]
驅體 英文
carcass
  • 驅 : 動詞1. （趕） drive （a horse, car, etc. ） 2. （快跑） run quickly 3. （趕走） expel; disperse
  • 體 : 體構詞成分。
  1. The results show that the composition of these precursors are identified to be limn2l ( ac ) 2 ( or ltmn2c10h11o11 ), in which l represents citric acid radical and ac is acetic acid radical. the sintering temperature and sintering time have remarkable effects on the microstructures of limn2o4 samples

    結果表明通過低熱固相反應法可在全固相條件下得到鋰離子與錳離子達到分子級混合水平的前驅體，其組成基本上與分子式limn _ 2c _ （ 10 ） h _ （ 11 ） o _ （ 11 ）相吻合。
  2. The material was sintered at 1050 for three hours to get the porous artificial bone, that its apparent porosity was54 %, its volume density was 1. 28 g / cm3, and its bending strength was 13. 25mpa. the results showed that the sintering temperature was reduced by adding bioglass

    本研究採用含生物玻璃前驅體粉末原料，添加檸檬酸造孔劑，模壓成型，在1050燒結保溫3小時，獲得了顯氣孔率為54 、體積密度為1 . 28s cm ~ 3 、抗彎強度為13 . 25mpa的多孔hap人工骨材料。
  3. Lifepo4 was sintered by solid - state method, we found that the capacity of the sample which was synthesized by codeposition method exhibited high specific capacity ( 142 mah ? g - 1 ) and good cycling performance

    採用高溫固相法制備了lifepo4 ，發現共沉澱制備的前驅體燒結出的材料容量達到142mah ? g - 1 ，循環性能也很好。
  4. Mas precursor powders were uniaxially pressed at 100 mpa employing a lubricated steel cylindrical mold. after sintering at 1450 for 2 hours, single - phase cordierite ceramic is prepared, and its relative density is 95. 1 %

    Mas先驅體粉末在100mpa的軸向壓力下成型后，經1450無壓燒結2小時，得到單相堇青石陶瓷，其緻密度達95 . 1 。
  5. Mas precursor powders are prepared using aluminium sulfate, colloidal silica, and magnesium nitrate as raw materials via sol - gel methods, dsc - tg and xrd show that the mas precursor powders transform to cordierite completely at 1300

    以硫酸鋁、硝酸鎂和硅溶膠為原料，採用溶膠-凝膠法，制得mas先驅體粉末， xrd表明，該粉末經1300的熱處理后，完全轉變為堇青石。
  6. The difference of reactive mechanisminduced the difference of their structure. v _ 2o _ 5 product prepared by melting - cooling showed more notable undefined structure. after heat - treating under300, particle size becomes smaller, and aggregate to globate grain, showesbetter electrochemical performance at low charge - discharge rate

    熔融淬冷法合成的樣品其無定型結構更明顯，前驅體經過300熱處理后，材料的粒徑變細，團聚成球狀的顆粒，球狀特徵更顯著，在低倍率下具有較好的電化學性能。
  7. The pertinent research work has been carried out as follows : the transparent nano - tio2 films on soda - lime glass substrates were obtained by sol - gel process. the precursor of nano - tio2 film was ti ( oc4h9 ) 4 and the menstruum was c2h5oh. the preparation conditions which were effecting the nano - tio2 quality were researched

    本文主要就納米tio _ 2薄膜的制備、探索用ecr氮等離子納米tio _ 2的摻雜改性等開展了如下的工作：本文採用溶膠?凝膠法，以鈦酸丁醋做前驅體、無水乙醇做溶劑，水解制備溶膠，然後通過提拉法制備納米tio _ 2薄膜。
  8. The iron doped tio2 thin films showed almost no photocatalytic activity for the photodegradation of no in the gaseous phase when the calcination temperature was lower than 400 c. this was due to the fact that the phase structure of the film was amorphous. at 400 c, the film appeared obviously photoactive du

    對于用液相沉積法所制備的tio :薄膜，薄膜中的si （或fe ）含量和薄膜的厚度可通過調節前驅體濃度、溶液的ph值、基片的沉積溫度和沉積時間，薄膜的熱處理溫度和時間進行有效地控制。
  9. Polyvinylidene chloride ( pvdc ) is a thermal unstable polymer and can be used as a prefabricate of new kind of functional material

    摘要聚偏二氯乙烯是一種熱不穩定性的高分子材料，可作為制備含碳材料的前驅體。
  10. Progress in study of carbon aerogels and precursory organic aerogels

    炭氣凝膠及其有機氣凝膠前驅體的研究進展
  11. In this paper, the al3 + - doped zno thin films were prepared on na - ca - si glass substrate ( microscope slides ) by sol - gel process from 2 - methoxyethanol solution prepared by zinc acetate as premonitor, monoethanolamine as stabilizator and aluminum chloride reaction. homogenous, transparent, polycrystalline zno thin film was formed finally by diping coating conducted for film - plate on substrate, drying, pre - heat - treatment, anealing

    所用的溶膠是以乙二醇甲醚為溶劑，醋酸鋅為前驅體，乙醇胺為穩定劑反應制得，用浸漬提拉法在基體上鍍膜，經烘烤、預燒、退火，最後形成均勻、透明的多晶zno薄膜。
  12. Using thioacetamide as sulfur source, cus submicrometer hollow spheres consisting of nanoparticles were fabricated by thioglycolic acid assisted hydrothermal process. furthermore, in this experiment, sulfur source played important role on the morphology and phase of products

    以硫酸鉛和硫化鈉為先驅體，在200v下反應24小時，是制備pbs納米棒的最佳條件；當用其它可溶性鉛鹽取代硫酸鉛為鉛源時，產物都為pbs納米顆粒。
  13. Yig and ce : yig precursors were prepared via coprecipitation. by means of improving homogeneity and decreasing synthesis temperature, harmful yfeo3 phase was restrained, the oxidation of ce3 + was under control, and pure phase yig and ce : yig ( x = 0. 2 ) were obtained

    採用共沉澱法合成yig及ce ： yig前驅體，通過提高組分均勻性、降低煅燒溫度等手段，有效地抑制了yfeo _ 3雜相的生成和ce ~ （ 3 + ）離子的氧化，合成了單相yig和ce ： yig 。
  14. Ajs20, the precursor contained 20wt % alunina sol seeding, was calcined at around 1000 to get free - aggregation nano - sized a - alaos powders with a median particle size of 70nm. and, calcining ajs2, the precursor contained 2wt % alumina sol seeding, at hoo ' c, we get a - alaos nano - sized powders with a particle size of loonm and good dispersion by tem. this paper also gives the proper mechanisms of these factors " influences on the transformation to alpha phase

    研究結果顯示，含有20wt膠體籽晶的前驅體ajs20在1000左右煅燒就可獲得平均粒徑為70nm 、無團聚的納米- al _ 2o _ 3粉體；而含有2wt膠體籽晶的前驅體ajs2在1100即可獲得粒徑在100nm左右、幾乎單顆粒分散、有少量「樹枝狀」微結構的納米- al _ 2o _ 3粉體。
  15. A series of near roundness cds nanoparticles with a particle diameter of 3 ~ 6nm have been prepared by controlling the concentration and proportion of reactants and adopting sodium hexametaphosphate as stabilizing agent. the studies demonstrate that these particles present obvious quantum size effect and an appropriate excess of cd2 + ion and hexametaphosphoric acid group polysnion are helpful to the dispersion and flame capability ' s improvement of particles. another series of near roundness monodisperse au nanoparticles with a diameter of 12. 3nm was prepared via sodium citric acid deoxidizing auric chloride acid

    利用六偏磷酸鈉作為穩定劑，通過控制反應物的濃度及比例，制備了粒徑為3 6nm 、呈近似球形的cds納米顆粒，光譜測試結果表明，顆粒具有明顯的量子尺寸效應，適當過量的cd ~ （ 2 + ）離子以及六偏磷酸根聚陰離子有助於顆粒的分散並提高其發光性能；採用檸檬酸鈉還原氯金酸，制備了接近球形、平均粒徑約為12 . 3nm的單分散體系au納米顆粒；採用wessling的前驅聚合物法獲得導電聚合物ppv前驅體。
  16. The precursor of freeze - drying is amorphous with residual water and ammonia, having a smooth surface. the morphology is flaky, club - shaped and a little hexagonal

    冷凍乾燥前驅體呈非晶態，有殘留的結晶水和氨，表面光滑，形貌主要為片狀和條柱狀，有少量六邊形態。
  17. Under better experiment conditions, the finally production fe has about 100nm diameter, oxygen content 2. 0 %, uniform, almost sphere. the results in this paper have shown that super fine powder of fe can be prepared by this route. this make the scientific bases for reusing of feso _ 4. 7h _ 2o and

    經檢測，在較佳前驅體制備條件和較佳還原、鈍化條件下，本工藝的最終產物- fe粒度在100nm左右，均勻，近球形，氧含量2 . 0 %左右。
  18. The xps measurements confirmed the presentation of poms and doda ( ddda ) in the multibilayers. the photoluminescent spectrum exhibit characteristic photo luminescence of the eu3 + ion, basically similar to those found for the polyoxometalate solids

    X射線光電子能譜結果表明pom在膜中的存在，並且表明前驅體膜中的氯離子已經完全被多陰離子交換掉，這與前面的結論相一致。
  19. Through this article work, the perfect rutile has been got with flame fusion method in developed domestic sjz sintering machine for the first time in china. based on it, the study of the electrical property of irradiationed rutile by high dose neutron has been also made. the achievements are concluded in the following : ( 1 ) through the development of technology of tio

    對粉體的制備工藝本論文也做了詳盡的描述和研究，對粉體前驅體ats的晶相、合成和焙燒過程進行了xrd 、 sem 、 tg等全面的分析，對粉體的晶相結構、形貌以及性能的表徵都做了研究。
  20. Gold colloids with different particle sizes were synthesized using hydrogen tetrachloroaurate as the precursor and " na3 - citrate / nabh4 as the reducing agents. two - dimensional arrangements of gold particles and layered composites of gold with polymer pdda were prepared

    以氯金酸為前驅體，以na _ 3 - citrate 、 nabh _ 4為還原劑制備了不同粒徑的金納米粒子，組裝了金納米粒子的單層或亞單層膜及其與聚合物pdda的多層復合膜。
分享友人
分享到 Line

分享到臉書