高溫分散劑 的英文怎麼說

中文拼音 [gāowēnfēnsǎnjì]
高溫分散劑 英文
high temperature di ersant
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 散 : 散動詞1. （由聚集而分離） break up; disperse 2. （散布） distribute; disseminate; give out 3. （排除） dispel; let out
  • 劑 : Ⅰ名詞1 （藥劑; 制劑） a pharmaceutical or other chemical preparation 2 （某些有化學作用的物品） a...
  • 高溫 : high temperature; elevated temperature; hyperthermia; megatemperature; inferno
  1. Taking the andalusite from south africa and alumina fiber as raw materials, adding aluminum sulphate as binder, fabrication and properties of alumina fiber reinforced andalusite composite was studied through wet dispersion, mould pressing and sintering processes

    以紅柱石和氧化鋁纖維為原料，用硫酸鋁作為結合劑，經過分散、混合、半干法成型、高溫燒成工藝，對氧化鋁纖維增強紅柱石基復合材料的制備及性能進行了研究。
  2. Separately, tma can be used as the cross linking agent to make the polyester resin and epoxy resin for the making of thermoset powder coatings, binding agent, and intermedium of dyestuff, medicine, and resin. moreover, tma can be used to make polyester imido coatings which care special insulated paints for motors

    另外，偏酐還可以作熱固性粉末塗料聚脂樹脂和環氧樹脂的交聯劑，可用於分散性氨基甲酸乙脂聚脂中，使其在環境溫度為70時，性質穩定，並具有高光澤度快乾耐磨等多種特性。
  3. Sige simox : oxygen ions with high dose were implanted into sige grown directly on silicon substrate for the first time, and sige - oi novel structure was formed successfully with additional high temperature annealing ; it has been confirmed that oxygen implantation with 45kev, 3 1017cm - 2 and annealing at 12500c in ar + 5 % o2 for 5 hours, are fit for the formation of sige - oi structure ; ge loss during the high temperature annealing has been observed, which is originated from ge volatility and ge diffusion ; it has been proposed to use nanoporous layer induced by h + / he + implantation to surppress ge diffusion and to use surface oxidation to overcome the upper limit of sige simox. sige smart - cut : hydrogen ions were implanted into sige material and followed by high temperature process ( 4000c to 7000c ) ; blistering study was done and suggested the possibility of sige layer transfer by smart - cut technology ; it is concluded that the bubble formation is easier in sige than in si, and the strain in sige / si and the difference of binding energy in sige and in si could possibly contribute to this effect. behavior of sige / si implanted with hydrogen : gave a detailed study on sige implanted by beamline or phi hydrogen implantation ; it has been found that great strain is introduced into sige by hydrogen implantation and this strain could be alleviated by high temperature annealing ; both for conditional beamline implantation and piii hydrogen implantation, 600 is appropriate for the post - implantation treatment

    Sige - simox工藝方面：首次採用硅（ 100 ）襯底上直接外延的100nm厚sige的樣品中注入高劑量的o離子，通過退火處理成功制備了sige - oi新結構，即sige - simox工藝，證實了以45kev注入3 10 ~ （ 17 ） 7cm ~ （ - 2 ）劑量的氧離子，隨后在氧化層的保護下經1250 ， ar + 5 o _ 2氣氛的高溫退火（ 5小時）過程，可以制備出sige - oi新型材料；實驗中觀察到退火過程中的ge損失現象，分析了其原因是ge揮發（ ge通過表面氧化層以geo揮發性物質的形式進入退火氣氛）和ge擴散（ ge穿過離子注入形成的氧化埋層而進入si襯底中） ，其中ge擴散是主要原因；根據實驗結果及實驗中出現的問題，對下一步工作提出兩個改進的方案：一是通過在si襯底中注入適量h ~ + / he ~ +形成納米孔層來阻斷ge擴散通路，二是可以通過控製表面氧化來調節安止額士淤丈撈要表面sige層中的ge組分，從而部分解決sige
  4. The polymer of p - tert - butylstyrene ( tbs ) has a relative high glass transition temperature and is soluble in aliphatic solvent. it has a comprising prospect of application in many areas including the development of novel materials, theoretical research, dispersion polymerization, unpolluted paints, oil additives, and so on

    對叔丁基苯乙烯聚合物具有較高的玻璃化溫度，並且能溶於脂肪烴中，使其在新型材料的開發、理論研究、分散聚合、環保油漆和油品添加劑等領域有廣闊的應用前景。
  5. The result of experiment showed that the reaction between ti and c is a thermodynamic course, when 2 wt % mg is added to melt, it can restrain the formation of fragility phase al3ti, and gained al matrix composite which contained tic reinforced particles only. because mg reacts with the forms a micro - high temperature field around the oxide around the graphite particles and the oxygen gas which is brought by the immersion bell, and the reaction gives out a lot of heat energy, thus forms many high micro - fields in melt, which prompt the reaction between the al and ti

    加入適量的mg （ 2wt ）可以抑制tic al復合材料中的脆性相al _ 3ti的產生，生成僅含tic的鋁基復合材料；由於活化劑鎂在體系中與石墨顆粒周圍的氧化物、以及外來的氧反應放熱，在熔體中形成微高溫區，促進al - ti反應，同時， al - ti反應也是放熱反應，因此體系中的內能急劇增大，促使al _ 3ti分解以及ti朝c顆粒擴散，縮短反應的孕育時間。
  6. Additional annealing experiments in nitrogen atmosphere revealed that the heavily damaged region with hydrogen - induced defects appears to be the adsorption center for the outside oxygen to diffuse into the silicon during the high - temperature annealing process, and consequently, broaden the thickness of the box layer. this important finding may provide a possible solution to reduce the cost of the conventional simox - soi wafers while maintaining a desirable box thickness

    獨特設計的氮氣氛退火及分步退火實驗證明了原注入樣品的缺陷層中氫及氫致缺陷的存在使得在退火過程中加速外界氣氛中的氧擴散進來，並成為強捕獲中心使擴散進來的氧滯留于缺陷層從而促使氧缺陷層中的氧沉澱生長，加速了高溫退火中的內部熱氧化過程，從而形成了比傳統相同劑量simoxsoi厚得多的氧化埋層。
  7. Dr low - grade hot regeneration absorbing type desiccator, comprehensive varyimg voltage absorb and become the warm advantage that absorb, absorb under the high steam partial pressure of the normal atmospheric temperature ( work ) ; in high temperature, low steam partial pressure is it analyze to lay ( regeneration ), namely moisture that absorbent absorbed in the course of absorbing, rely on high - quality getting angry between thermal diffusion and low partial pressure two mechanism common to act on and can drive out completely in the course of regeneration

    Dr微熱再生吸附式乾燥機，綜合變壓吸附和變溫吸附之優點，在常溫高蒸汽分壓下吸附（工作） ；在較高溫度，低蒸汽分壓下解析（再生） ，即吸附劑在吸附過程中吸附的水分，在再生過程中依靠高品質再生氣（乾燥空氣加熱）的熱擴散和低分壓兩種機理的共同作用而得以徹底清除。
  8. Surface active agents - method of testing of the migration action of levelling agents for disperse dyes on dyeing polyester textiles under high - temperature condition

    表面活性劑高溫條件下分散染料染聚酯織物用的勻染劑及移染性測試法
  9. Surface active agents - method of testing of the restraining effect of levelling agents for disperse dyes on dyeing polyester textiles under high temperature conditions

    表面活性劑高溫條件下分散染料染聚酯織物用的勻染劑的抑染作用測試法
  10. The hardness and corrosion resistance were evaluated by, the anticorrosion mechanism was also discussed by xps as well. the composited content of particles in coating was high when 0. 5 % super - 3900 was added into al2o3 suspention before plating the composited content increased with the increase of al2o3 concentration in plating solution and the time of stirring before plating and increased as a peak curve with plating temperature, cathodic current density and ph value

    超分散劑super - 3900加入量為0 . 5 % ，對al2o3懸浮液分散后加入時，獲得的鍍層復合al2o3含量高，並隨著鍍液中al2o3含量、鍍前攪拌時間增加而增加，鍍層中al2o3含量隨著施鍍溫度、陰極電流密度、 ph值的增加呈先增加后減少的變化。
分享友人
分享到 Line

分享到臉書