高超聲速風洞 的英文怎麼說

中文拼音 [gāochāoshēngsùfēngdòng]
高超聲速風洞 英文
hypersonic wind tu el
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 超 : Ⅰ動詞1 （越過; 高出） exceed; surpass; overtake 2 （在某個范圍以外; 不受限制） transcend; go beyo...
  • 速 : Ⅰ形容詞（迅速; 快） fast; rapid; quick; speedy Ⅱ名詞1 （速度） speed; velocity 2 （姓氏） a surna...
  • 風 : Ⅰ名詞1 （空氣流動） wind 2 （風氣; 風俗） practice; atmosphere; custom 3 （景象） scene; view 4 ...
  • 洞 : Ⅰ名詞（物體上穿通的或凹入較深的部分; 窟窿; 洞穴） hole; cavity Ⅱ形容詞（深遠; 透徹） profound; thorough; clear
  • 高超 : excellent; exquisite; superb
  • 風洞 : [航空] wind tunnel; air tunnel; whirl tube; wind tunnel plant; flume
  1. Hypersonic propulsion test facility is important for the scramjet ground tests

    摘要高超聲速推進風洞是進行超燃沖壓發動機模型地面模擬的重要試驗設備。
  2. The tests were conducted in the hypersonic low density wind tunnel at nominal test conditions of mach 16, stagnation temperature 923k, stagnation pressure 1. 40mpa and 7. 30mpa. heat - transfer data were obtained on a hemisphere model, a sharp cone and a big blunt cone respectively by means of infrared thermal mapping techniques, that of a 0. 5mm thickness blunt cone by virtues of thermocouples. furth ermore, heat - transfer on all those models was calculated with the theoretical method

    最後在名義m _ = 16 、 t _ 0 = 923k 、 p _ 0 = 1 . 40mpa及7 . 30mpa的高超聲速低密度風洞中，利用紅外熱圖技術獲得了半球圓柱、尖錐、大鈍頭三個模型表面熱流分佈，利用薄壁法技術得到了一壁厚為0 . 5mm的鈍錐模型表面的熱流分佈，並通過工程理論方法計算了模型表面的氣動熱，把理論計算結果與上述試驗結果比較，幾者符合得較好。
  3. A hypersonic pulse tunnel is designed in this paper, which has multiple running modes based on gun tunnel and shock tube theory

    本文設計了一座具有多種運行方式的高超聲速大型脈沖風洞，該風洞可以採用炮風洞和激波管兩種運行方式。
  4. The code calibration is completed by comparing the numerical results with data from two experiments, one of which is test of a 2 - d hypersonic inlet with internal compression and the other a sidewall compression inlet. good agreement of numerical and experimental results proves the possibility and credibility of the numerical method

    利用國外文獻公布的二維進氣道實驗結果和本課題組側壓式進氣道炮風洞實驗獲得的實驗數據對本文的計算方法進行了校驗，證明了本文所採用的方法應用於高超聲速進氣道計算的可行性和可靠性。
  5. The design and computation of the hypersonic nozzle have scientific and practical value to solve these problems

    而高超聲速風洞噴管的設計和計算則對解決這一類問題具有重要的科學意義和實用價值。
  6. This paper presents the development and preliminary application works of an automatic strain gauge balance static calibration system in ecs for 1m hypersonic wind tunnel of cardc

    本文論述了cardc超高速空氣動力研究所1m高超聲速風洞配套的新型全自動六分量應變天平地軸系（ ecs ）校準系統的研製和初步應用研究工作。
  7. According to the study work of this paper, an automatic six - component strain gauge balance calibration system development scheme was put forwards : the system calibrates the balances in the ecs, and translates the loads to the bcs of the balances with measuring the balance ’ s position changes during the calibration

    本文根據1m高超聲速風洞氣動力試驗的總體要求，提出了採用天平校準載荷地軸系全自動加載、並通過天平空間位移測量將校準載荷換算到天平體軸系（ bcs ）的六分量天平校準系統總體研製方案，並確定了詳細的技術指標。
  8. In chapter 4, the aeroelastic model of the whole test rig is first established by using jones ’ s approximation of theodorsen ’ s unsteady aerodynamics load. then, the numerical simulations and wind tunnel experiments for the sub - optimal flutter suppression of the airfoil model are presented

    數值模擬和風洞實驗研究表明，以超聲電機為控制面作動器可以有效地抑制翼段模型的顫振，顫振臨界速度提高了13 . 4 % ，數值模擬和風洞實驗結果基本吻合。
分享友人
分享到 Line

分享到臉書