back extraction method 中文意思是什麼
back extraction method
解釋
反相萃權- back : n 1 背，背部；背脊；背面，反面；背後，後部，後面，裏面。2 （指）甲；（刀）背；（手）背；（書）背...
- extraction : n. 1. 抽出，拔出。2. 【化學】提取（法）；萃取（法）；回收物，提出物；精煉。3. 精選，摘要。4. 血統，家世，出身。5. 【數學】開方，求根。
- method : n 1 方法，方式；順序。2 （思想、言談上的）條理，規律，秩序。3 【生物學】分類法。4 〈M 〉【戲劇】...
-
Back extraction by hno3 - hf and back extraction by concentrated hnch after lower the concentration of organic phase are studied, the method of back extration by hnorhf can not be used to icp - ms, because some zirconium is hydrolysis when hf is removed by heat. however, the method of back extraction by concentrated nitric acid after lower the concentration of organic phase can be used to icp - ms, the recovery is 93. 2 %, rsd % is 5. 24 %, the decontamination factor of uranium is 3. 2xl04, the detection limit of zirconium is 0. 04ng / ml. the method of tta extracting trace zirconium in uranium is firstly used to icp - ms, the result is satisfied, it can be used to determine zirconium in uranic production quickly and veraciously
本文通過研究hno _ 3 - hf反萃和稀釋有機相後用濃hno _ 3反萃這兩種分離方法，認為hno _ 3 - hf反萃由於在加熱去除hf時酸度不易控制，導致鋯的部分水解，因而此方法不宜用於icp - ms中，然而稀釋有機相後用濃hno _ 3反萃法用於icp - ms測量中，全程回收率為93 . 2 ，相對標準偏差為5 . 24 ，鈾的一次去污因子為3 . 2 10 ~ 4 ，鋯的測定下限為0 . 04ng / ml ，本文首次將tta萃取分離鈾中鋯用於icp - ms測量中，結果令人滿意，此方法適用於快速、準確測量鈾產品中微量鋯。 -
In the paper, based on the existing literature research foundation an analog circuit catastrophic fault location approach by using feedforward networks with back ? propagation learning is realized. by this approach, the simulation require ments before test are reduced because fewer training samples are needed, and the fault location process is fast. this method is very efficient in location of single hard fault wit component tolerances. the measureme nt space feature and the general characterization concept of single and double soft fault in linear circuits are presented. according to this concept, a linear circuits soft fault location approach using subhidden layer bpnn is established with element tolerance, and it is shown that this approach is successful in fault location. a double fault feature extraction.,
本文在現有文獻理論研究的基礎上實現了採用bp演算法前向多層神經網路對直流測試下模擬電路硬故障的診斷方法。其特點是採用少量典型特徵樣本作為bp網路的訓練樣本，獲得訓練樣本的代價小，減少了測前工作量，同時診斷速度快，在考慮元件容差時仍有好的診斷效果。文中介紹了線性電路單一軟故障和雙軟故障所具有的電壓增量空間特性和統一特徵概念。
分享友人