bearing strain 中文意思是什麼
bearing strain
解釋
承壓變形-
Many computational analysis of soil constitutive models appear to be irrational because of taking no account of or not thoughtfully considering the anisotropic deformation when they face the direct or indirect simulation of principal stress and principal strain relationship of load bearing unit
諸多土體本構模型都會直接或間接面臨對受荷單元主應力主應變關系的模擬，但由於不考慮或考慮各向異性變形特性不周，對各向異性變形問題的計算分析就會出現不合理。 -
Through studying the working mechanism of the composing, the paper referred the bearing ' s analyzing model and designing flow. through shearing test of high damping rubber, the paper analyzes the influence of shearing shape, shearing strain range and inspiriting frequence on the characteristic parameters ( dynamic shear elastic module, dissipation engineering module, wasted gene ). according to the rule of equivalent energy, the paper gets the hysteretic curve of hdr ' s equivalent bilinear model and parameters ' calculating formula
本論文通過對這種分離式減震支座各組成部分工作機理的研究，提出了該分離式減震支座整體的計算分析方法和設計流程；通過高阻尼橡膠剪切試驗，分析了高阻尼橡膠剪切面形狀、剪應變幅值、激勵頻率和試件高度對特徵參數（動態剪切彈性模量、耗能模量、損耗因子）的影響。 -
In this paper, a numerical simulation is conducted, which is based on the test data of the model experiment of sloping ground with the help of the marc program. when the bearing capacity characters of level ground and the foundations adjacent to or above slopes are analyzed, the effect is considered, which includes deformation moduli, density, poisson ratio, angle of internal friction, stress - strain relationship, slope angle, relative distance from the edge of slopes and relative depth of footings
本文利用斜坡地基模型試驗的試驗數據，用marc軟體進行了斜坡地基模型試驗的數值模擬，分析了平地地基、臨坡地基和斜坡地基的承載力特性，研究了變形模量、容重、泊松比、內摩擦角、應力應變特性、斜坡坡度、基礎的相對坡頂距及其相對埋深等因素對斜坡地基承載力性能的影響。 -
Measured results from in - site loading tests in tannin harbor and from in - door model tests were compared with predictions from the limit equilibrium methods. a method of estimating the bearing capacity for inhomogeneous medium was suggested to meet every case ; 4. according to the results from model tests, the elastoplastic fem were performed to study the procession of the change of the stress and strain in inhomogeneous medium and to simulate the procession of the forming of the failure surface during loading, and the failure mechanism was studied ; 5
4 、結合模型試驗結果，確定出了符合非均質介質規律的彈塑性模式，在此基礎上分別運用二維、三維彈塑性有限元程序，模擬出了外荷載作用過程中非均質介質內部應力、變形以及破壞面的發展過程，分析得出了非均質介質地基的破壞機理； 5 、在港口工程地基設計當中，已經引入了可靠度理論計算分析基礎穩定性。 -
Using high - strain dynamic tentative piling technique ， one can obtain the pile endpoint resistance at each hit in the process of hammering, which is the bearing capacity of the pile endpoint soil against the pile
運用高應變動力試樁法，可以獲得樁在打入過程中的每一錘擊下的樁端阻力，即樁端土對樁的端承力。 -
On the basis of in - site test of piles in two great bridges in one expressway project, this paper investigates the application of this technique applying to cast - in - situ pile in gravel, studies the bearing properties of grouted piles, examines the practicality of high - strain test use in grouted piles and analyses the grouted piles with vesic theory
根據現場樁基動、靜載試驗，對卵石層中樁端壓力灌漿樁的承載特性進行了分析；探討了基樁高應變case法在灌漿樁中的適用性；並應用vesic球形空穴擴張理論對灌漿結果進行了分析。 -
Tow speciments of prestressed fabricated beam - column subassembly were tested under reversed cyclic loading. experimental studies were carried out to investigate the strain distribution, failure mechanism and load - bearing capacity on the beam - column connections, as well as ductility, hysteresis curves energy dissipation, displacement restoring capacity of full pc speciments
本文通過兩榀預壓裝配式樑柱組合體在低周反復荷載下的試驗，了解了預壓裝配式框架梁端截面應變分佈、破壞機理和極限承載能力；探討了全預應力配筋截面延性特徵、滯回性能、耗能能力和變形恢復能力。 -
In this paper we study the transverse stiffeners of the thinned - web beam bearing several concentrated longitudinal strain actions. thinking of using post - buckling strength of web plate, we study some facts about tran sverse stiffeners including strain ability, condition of breaking, calculation of strength and stabilization of the stiffener bearing regional load action
本文對受多個集中荷載作用的薄腹板梁的橫向加勁肋進行了研究，分析了利用腹板屈曲后強度時，橫向加勁肋的受力狀態、破壞機理，以及加勁肋局部承壓的強度計算公式和穩定計算方法。 -
Abstract : the results of hi - lo strain - gauge test on 9 dead - load testing piles are analyzed. the bearing strength of single piles is evaluated preliminarily by using high strain and low strain process and conditions for correlating dynamic and dead loads and technical factors affecting the test accuracy are discussed
文摘:通過對一組靜載試驗樁高低應變動測結果的分析，對高應變法、低應變法檢測單樁承載力的可靠性作出了初步評價，並對動靜對比成立的條件及影響其測試準確性的一些技術因素進行了探討。 -
Based on strain distribution acquired in experiment, the internal force evaluation model is set up, then, the structural behavior of slw are investigated in detail. combined with the nonlinear fem results, the structure behaviors are expressed in the concepts of " principal limb " ( pl ) and " load effect bearing ratio " ( lebr ), and the function for lebr determining is put forward, which may be used in the practical section design
本文進行了國內首例短肢墻結構體系低周反復試驗；基於試驗實測的墻肢應變分佈，擬合了墻肢截面的應變分佈規律，並進行了短肢墻結構內力大小及其分佈規律的分析，建立了墻肢荷載效應負載率的數學模型，為實際工程的截面設計創造了條件。 -
In the paper, active control to rotor vibration with sma is studied : 1 ) the material performance of sma, especially the coupled relation of strain, stress and temperature, is studied in nonlinear coupled thermoelasticity theory and the linear result is modified ; 2 ) the nonlinear dynamic behavior of rotor system with sma bearing is studied in the nonlinear theory and the dynamic stability theory and the deference of the soft / hard nonlinear system is pointed out
1 ）運用非線性熱彈性耦合理論研究記憶合金材料的力學性能，特別是應力、應變和溫度三者之間的耦合關系，改進了原有的線性結果。 2 ）運用非線性理論和運動穩定性理論研究帶有記憶合金支承的轉子系統在非定常狀態的非線性動力學行為，指出了軟、硬非線性系統的區別。 -
The parameters are measured respectively during the experimental process, such as bearing capacity, deformation, strain and so on. it concludes that when the other conditions is equal, the limit bearing capacity of the concrete filled steel tube long column subjected to axial compress is reduced along with the long diameter ratio increased
從試驗結果可以看出：鋼管混凝土軸心受壓長柱的穩定承載力，在其他條件相同時隨長細比的增大而逐漸降低；試件在最大承載力狀態下，鋼管表面的平均縱向應變已超過鋼管的屈服應變值，破壞呈現為非彈性失穩破壞。 -
Through comparing and analyzing of bearing capacity, development of crack and strain of reinforced, the results show that the load - deflection plots f or specimens from the finite element analysis agree well with the experimental data, and choosing the rightful stress - strain relationship, utilizing ansys program, the test process can be well simulated. at the same time, making used of the program, the traditional shear wall is analyzed. it shows that comparing with the traditional shear wall, the hollow shear wall ' s cracking load drop 16 %, yield load and failure load drop 13 %, stiffness drop 13 % ~ 22 %
其次在試驗的基礎上，將試驗手段、有限元數值模擬方法和理論分析結合起來，利用有限元程序ansys對其中的兩片墻板進行非線性有限元分析，並對前後的承載性能，裂縫發展、鋼筋應變進行了比較和分析，結果表明有限元節點模型分析的荷載-位移曲線和試驗測得數據符合良好，選用合理的材料本構模型，利用ansys可以較好的模擬試驗過程；同時利用有限元模型對比分析了普通剪力墻和空心剪力墻，空心剪力墻與普通剪力墻對比，其開裂荷載下降16 ，屈服荷載、極限荷載下降13 ，剛度下降13 22 ，開裂至屈服、屈服至極限荷載階段的剛度衰減規律與普通剪力墻基本一致，空心剪力墻的後期剛度比較穩定。 -
The application of high - strain dynamic tentative piling technique to determining limited bearing capacity of pile endpoint soil is a good method in the field of dynamic depth detection
應用高應變動力試樁法確定樁端土的極限承載力是動力觸探領域中的一種好方法。 -
Abstract : the application of high - strain dynamic tentative piling technique to determining limited bearing capacity of pile endpoint soil is a good method in the field of dynamic depth detection
文摘:應用高應變動力試樁法確定樁端土的極限承載力是動力觸探領域中的一種好方法。 -
The paper made up a flexural experiment with six pieces of composite slab. during the every step of load exerted, the paper recorded the strain of cold - form steel deck and concrete, deflection, crack, slide, ultimate bearing capacity. by changing the thickness of cold - form deck, thickness and strength of concrete, amount of steel stud and other parameters, the paper discussed the behavior of loaded composite - slab
本文進行6塊組合板的抗彎性能試驗，測試各級荷載下壓型鋼板及砼應變、組合板撓度、裂縫、板端滑移、組合板抗彎極限承載力；通過壓型鋼板厚度、砼板厚度、砼強度等級、栓釘數量等幾個參數的變化，探討組合板在荷載作用下的內力、變形情況。 -
By conducting the degree of influence of slip strain on average strain of a member section, some parameters of corrected even section were accurately calculated, which made the corrected even section more reasonable. and then a calculating model of bearing capacity for eccentric loading columns was proposed by using limit balance equations
通過推導滑移應變對構件截面平均應變的影響，準確確定出修正平截面中的一些參數，使修正平截面更趨合理性，再利用極限平衡方程，建立了src偏壓柱受壓承載力計算模型。 -
As the main method of measurement in the tests, some strain measuring points are arranged on the reinforced steel bars of the anchor bearing body. the changes of strain with different loading levels at their locations have been measured, through which range of influence and distribution of strain with loading in grout can be investigated, and corresponding distributions of axial force and bond stress are calculated according to hooke ' s law. making use of nonlinear curve fitting, distribution equation of bond stress of the fixed unit anchor length is achieved
試驗測試手段通過在錨索承載體上布設應變測點，觀測錨索在不同的荷載級別下的應變變化情況，對不同荷載級別下，單元錨索注漿體內應變的影響范圍及分佈規律展開分析，依據虎克定律計算出了其軸力與粘結應力的分佈；並對測試結果進行了擬合，得出了錨固段粘結應力分佈的擬合方程。 -
If backpack / duffle bags etc., the load bearing straps must be flag stitched in place to ensure that they do not break under strain
諸如背包，行李袋等，承重帶必須加縫，以確保在受力情況下不會斷裂 -
During the low strain dynamic test of the foundation pile, the adoption of the velocity sensor to the direct measurement of the relative displacement of the pile head is helpful to reducing the improper dependence upon the measured intrinsic frequency valuesof the pile soil system in calculating vertical bearing capacity of the single pile, and is hence conducive to raising the accuracy of the calculated vertical bearing capacity of the single pile
基樁低應變動測中，採用速度傳感器直接測出樁頭的相對位移，在推算單樁豎向承載力時，有助於降低對樁土體系固有頻率測定值的過分依賴，從而有利於提高單樁豎向承載力推算值的準確程度。
分享友人