boost power mode 中文意思是什麼

boost power mode 解釋
增強功率模式
  • boost : vt 1 〈美口〉（由下或由后）推，升，提。2 〈美俚〉吹捧（候選人等）；支援；增加，提高；促進；煽起（...
  • power : n 1 力，力量；能力；體力，精力；（生理）機能；〈常 pl 〉才能。2 勢力，權力，權限；威力；政權；權...
  • mode : n 1 法，樣，方法，方式。2 模，型；樣式，體裁，款式；習慣。3 風尚；〈the mode〉流行，時髦。4 【語...
  1. Chaos in three typical topology power electronic converters with a close loop controller is studied. the discrete iterative model is established and analyzed for the chaos in close loop boost converter working in discontinuous conduct mode. the tracking control method is used to control chaos of this converter, simulation results show its effectiveness

    研究了三種典型拓撲結構的電力電子變換器閉環工作時的混沌現象，針對工作在電流斷續模式（ dcm ）下的boost變換器中的混沌現象，分析了其數學模型，並採用軌跡跟蹤控制方法進行了控制，模擬結果表明了該方法的有效性。
  2. The result shows that, when the full - bridge power converter is joined with boost / buck dc chopper in parallel, it can serve a dc voltage of over 340v and a power of 800w, meanwhile, as output voltage of the fuel cells changes due to loadings, the sliding - mode controller can cause more rapid responses and robustness to the dc bus voltage source

    實驗結果顯示，本論文之全橋式功率轉換器與升壓/降壓直流截波器並聯供電時，輸出電壓可達340v以上，輸出功率約為800w ，同時，當燃料電池之輸出電壓因負載而改變時，本論文所提出之滑動模式控制器能使直流鏈電壓具有較快速的響應及強健性。
  3. With promulgation and obliging actualization of iec 1000 - 3 - 2 etc. international standards, power factor correction ( pfc ) technique become a hotspot of research in power electronics field. based on average current mode, the paper introduce the design and implementation of a fully digital controlled single - phase boost power factor corrector with fast response. the control - loop circuit is realized using digital control and the corrector can tend to unity power factor, lower current harmonics and high transfer efficiency

    本文在平均電流模式控制的有源功率因數校正技術的基礎上，設計了一種控制電路基於數字信號處理器（ dsp ） 、主電路採用boost變換器拓撲結構的全數字單相功率因數校正器，用數字電路代替傳統的模擬電路來實現對整個迴路的控制，最終使得校正器具有輸入功率因數接近於1 、低電流諧波以及高轉換效率的特性。
  4. The techniques with two different methods are classified as : the mode of pulse width modulated, and the difference of control signal. the advantages and disadvantages of each method is analyzed and compared, and where each method is more adapted to is pointed out. a type of switching power supply management ic based on current mode control method is designed which is a pwm boost converter

    本文全面分析、描述了dc - dc開關電源變換器的控制方法，並依據脈寬調制的方法何採用控制信號的選取對控制方法進行了分類，詳細闡述了各種控制方法的基本原理，分析比較了他們各自的優缺點，指出了每種控制方法所使用的場合。
  5. Through analyzing comparing and evaluating to original research material got continually from 2000 to 2005, this paper analyze and evaluate all kinds of active contract, lease, auction, jsc, wua and unreformed management mode from engineering status of irrigation area, investment and farmer income, developing course of innovation and any other aspects, then screens out lateral canal ' s management mode, which accords with reality of guanzhong irrigation district, so that to boost up farmer ' s power of participation and know the inside story of irrigation management, makes farmer to benefit from it, makes management, movement and protection of irrigation system in irrigation area to achieve higher level

    摘要對2000 ~ 2005年連續6年所獲原始調查資料進行分析、比較、評價，從灌區工程狀況、農戶投資與收益、改革發展進程等方面，對灌區現行的承包、租賃、拍賣、股份制、農民用水者協會及未改制等各種管理模式進行分析評價，篩選出符合關中灌區實際的斗渠管理模式農民用水者協會，增強受益農民對灌溉管理的參與權和知情權，使農民從中受益，使灌區灌溉系統的管理、運行、管護達到較高水平。
  6. The switch power will operate at ccm condition when circuit is set to pwm mode. when pfm mode is selected for the operation mode, the switch power will still operate at pwm condition with the high load, the system will cancel the pwm mode and enter the pfm mode only when the load is drop to a certain threshold to boost the operation efficiency at light load, make the ic has high efficiency within wide load range

    選擇pwm模式，開關電源將工作在ccm模式下;選擇pfm模式，在負載較高的情況下，開關電源仍然工作于pwm模式，只有當負載降低到一定程度時，開關電源才退出pwm模式，而按照pfm工作模式操作，跨過一部分時鐘周期，降低頻率相關功耗，以提高輕負載時低效率的問題，使得開關電源在很寬的負載范圍內都具有高效率。
  7. These studies in the thesis have been done as follows : it is proved that if the three - phase single - switch boost type power - factor - correction can work in continuous - current - mode, its power factor can not reach unity. therefore, it is not qualified for high power and high requirement application. according to the ac side equivalent circuit of the three - phase three - switch boost type power - factor - correction, the equations to realize unity power factor have been deduced and realized by integrate - reset - control circuit

    本論文把積分復位控製成功應用於三相功率因數校正技術中，作了以下幾方面的研究： 1 .從理論上證明了三相單開關boost型pfc即使工作在ccm ，其功率因數也不能達到1 ，在大功率和對功率因數校正能力要求較高的場合，三相單開關boost型pfc達不到要求， 2 .根據三相三開關boost型功率因數校正交流側的等效電路，推導出實現單位功率因數所需的控制方程，並用積分復位控制電路進行實現，在理論研究的基礎上進行了模擬研究。
分享友人
分享到 Line

分享到臉書