burnout temperature 中文意思是什麼
-
The results show that more green density causes more densification but less linear shrinkage and higher burnout temperature causes more densification but less densification rate
發現生坯密度越大，排蠟后絕緣子線收縮越小，緻密化程度大大提高；隨排蠟溫度升高，絕緣子緻密化程度增大，緻密化速率減小。 -
Using this system, research on nox emission and burnout characters of the test facility are carried out. the results of influence on nox emission and carbon in fly ash by coal type, coal particle diameter, furnace temperature and excess air are reached through tests. then micronized coal reburning tests are processed, which show a remarkable effect results on nox reduction and burnout rate
通過大量的試驗，得出了煤種、煤粉細度、爐膛溫度和過量空氣系數等因素對nox排放和煤粉燃燼率的影響趨勢；並在此基礎上研究了超細粉再燃對脫氮效果和燃燼性能的作用，試驗結果表明超細煤粉再燃對降低nox排放和飛灰含碳量具有明顯的效果。 -
This paper presents the experimental results of ignition and combustion of semi - coke particles. in the experiment, the ignition temperature, ignition delay, particle burnout time and temperature career during combustion of semi - coke particles with different sizes are measured. the experimental data of the ignition and combustion process are discussed and analyzed. the comparison between the experimental and the theoretical results are also carried out
實驗研究了半焦粒子著火與燃燒過程，測定了幾種尺寸的半焦粒子在不同環境溫度下的著火溫度、著火滯燃期、燃盡時間和燃燒過程中的粒子溫度等與燃燒過程相關的參數變化，對影響半焦粒子燃燒的因素進行分析討論，並將實驗結果與理論計算結果進行了對比分析，兩者在一定范圍內有較好的一致。 -
To insure more densification but deformation of glass beads, the green density should be increased, and the burnout temperature of binder should be below the toplimit of transformation temperature
為保證絕緣子獲得較高緻密度而不變形，應盡量提高生坯密度，溫度同時排蠟應低於該種玻璃的轉變溫度上限。 -
A few layers of temperature measuring nets was fixed in the furnace in the test - bed. the distribution of the concentration of diffenent temperature air was gotten through measuring the distribution of the temperature in the furnace. finally, the mixture situation in reburning area and burnout area were gotten totally
即主氣流和燃盡風採用室溫氣流，再燃天然氣採用高溫空氣模擬，在爐內布置多層測溫網路，通過測量爐內溫度場的方法獲得爐內再燃風、燃盡風及主氣流的混合濃度場，從而定量反映出爐內再燃區及燃盡區的混合情況。
分享友人