circuit length 中文意思是什麼
circuit length
解釋
電路長度-
In the sub block circuit design, the contents that the author had introduced include : the principle of band gap voltage reference and the design technique in low power supply ; the analysis of spike pulse noise rejection, frequency divider and dead time in oscillator and control circuit ; the selection of the width and length ratio of four switches and 2x / 1x mode change point in driver and mode selection circuits
在子電路設計中，作者比較深入分析的內容有:基準電路的原理及低電源電壓下基準電路的設計;振蕩器和控制電路中尖峰脈沖噪聲抑制、兩分頻電路及死區時間設定;驅動及模式選擇電路中開關管的寬長比的選擇及模式轉換點的設計。 -
Through developing a 2 - dimensions heat transfer model of buried pipe - in - pipe heat exchanger and simulating the process by computer, the author figures out inter - relations of factors which influence characteristics of buried pipe - in - pipe heat exchanger, such as pipe diameter, pipe length, ratio of pipe diameters, flow rate, inlet water temperature, patterns of water inlet and outlet, and material features made of pipe, and proposes some optimizing indexes of buried pipe - in - pipe heat exchanger. the author studies the " heat - - short circuit " phenomenon as well and gives < wp = 5 > some important results
本文通過建立地下套管式埋管換熱器傳熱過程的二維傳熱模型，並藉助計算機對分析結果進行解析，弄清了影響埋管換熱器性能的管徑、管長、管徑比、通過流量、進水溫度、進出水方式以及管材等參數的作用，並提出了相應的優化指標，對研究界懸而未決的「熱短路」問題也進行了細致分析，得出了有關結論。 -
On the basis of time interval calculate formula which has been deduced, this paper offers the recommended length of digital signal orbital circuit in the condition of the minimal of the time interval
本文在推導出列車安全間隔時間計算公式的基礎上，提出了基於最小列車安全間隔時間的數字軌道電路長度的推薦值。 -
It also calculates theoretically the minimal time interval between two trains in quasi - moving - block signaling system and recommends approximate values for the length of coded digit track circuit. the rapid development of urban rail transit demands a deep understanding on the features of track circuit
在此基礎上，針對當前應用廣泛的基於數字軌道電路的準移動閉塞atc系統進行了重點分析，詳細討論了數字軌道電路的原理、準移動閉塞系統的列控方式等內容，並對準移動閉塞下的最小列車追蹤間隔時間進行了理論計算和分析，給出了數字軌道電路長度的推薦值。 -
The temperature of the f - p cavity is accurately controlled by a set of thermoelectric cooler ( tec ) modules attached on the body of the cavity and the electronic feed - back circuit. we found that the long - term unidirectional frequency shift of the output laser resulting from the slow increase of the cavity length under the effect of the temperature integration on the cavity body is essentially eliminated
因此，往往有多臺f ? p腔出現在同一個實驗裝置中本文利用珀耳帖元件，對穩頻系統中作為頻率參考標準的fabry ? perot干涉儀進行精密控溫，並利用f - p腔的透射特性，對自製的全固化單頻nd ： yvo _ 4激光器穩頻。 -
Mainly applying to thermal insulation of single long legnth pipe, the longest use length with one power suppply circuit from hundreds meters to thousands meters
主要適用於長距離和超長距離單一管線的伴熱保溫，一個電源點最大使用長度為幾百米到數千米。 -
Since the analysis of the inverter and its control system is very complex, the frequency analysis, time domain analysis and control system is made in capacitance operated conditions limited to pressure of time and paper length. the research content can be summed up as follows : ( 1 ) a new equivalent circuit of dbd circuit ( dielectric barrier discharge ) that consider the consume of transformer, the on - off switching loses and so on is presented based on the ozonier powered by sine current source. as compared with the former equivalent, the new equivalent circuit can be depicted the actual ozone circuit accurately
本文主要針對容性狀態下的臭氧發生器電源進行相關研究，研究內容包括以下幾部分: （ 1 ）在正弦電流源供電的dbd型發生器的基波等效電路基礎上，提出了一種考慮電路雜散損耗（變壓器勵磁損耗、開關管開關和導通損耗以及其他元件的熱損耗）的改進型基波等效電路，並採用該等效電路得出了適用的臭氧發生器電源設計方法，實驗驗證了該基波等效電路具有工程設計精度高的優點。 -
Socket function mainly realizes setting up and initializing service unit socket, initializing service unit and service unit serial and so on. bind funcion primarily binds local address and port for the socket. listen function is to evaluate the max length of server ’ s listening queue. connect function and accept function set aside rate ahead, infrom user ’ s request of establishing virtual circuit to suna, cooperate with suna to establish the connection between client and server, return the result. we make use of three handshake with data protocol and virtual circuit mode, in this way, when we translate data, we can look up communication course according to virtual circuit number, at the same time, there aren ’ t source ip address and port, end ip address and port in the head of data package, the speed of translating data advances in a certain extent. send function and recv function is to send data collaborating with suna, and copy data from the receiving queue of socket to user ’ s buffer. close function cooperate
Socket （ ）函數實現創建、初始化服務元套接字，初始化服務元及服務元序列等。 bind （ ）函數為套接字綁定本地地址和埠號。 connect （ ）和accept （ ）函數主要是根據用戶要求預留帶寬，將用戶的建立虛電路請求轉達給服務元網路體系，協作服務元網路體系採用捎帶數據的三次握手協議建立虛電路，並告訴用戶處理結果，一方面，捎帶數據的三次握手協議在一定程度上可提高數據傳輸速度;另一方面，採用虛電路方式，使得數據通信可直接根據虛電路號查找相應的通信進程，而且數據包的包頭中省去了源ip地址、埠號和目的ip地址、埠號，提高了數據傳輸速率。 -
In practical application, due to the parameter accuracy of two point temperature correction is limited by readout circuit noise 、 dynamic range 、 analogue to digital converter word length and calculating noise, the performance of focal plane array detector is not the performance it should be
目前實用性較好的兩點溫度定標法的校準系數精度受讀出噪聲、信號動態范圍、模數轉換字長和運算噪聲的限制，很難使焦平面探測器的空間殘留噪聲達到應有的精度。 -
At first, buck - boost circuit is detailed analyzed and derived strictly in the theory, and on the base, the current of the inductance and the output voltage are analyzed elaborately. when the input voltage is the ac voltage with the nomal frequency, the two variable quantity are analyzed and some conclusions are concluded by means of equal length separation methods and introducing function methods and derivative - equation methods. and this is the basis of the next proceeding
首先，對buck - boost電路進行了嚴謹地理論推導，先對buck - boost電路在輸入為直流電壓時的工作情況進行了分析；在此基礎上，對輸入為工頻交流電壓時的電感電流、輸出電壓作了詳細分析，利用等間距離散化方法、引入函數法、微分方程法分別對變量進行了推導和總結，為下一步工作奠定了理論基礎。 -
Besides circuit principle design of the system and function circuit of all portions are illuminated in length, too
完成系統的電路原理設計，並對各部分功能電路進行了詳細的說明。 -
Some methods for overcoming these disadvantages are investigated as follows : first, using shield and magnetic circuit to shorten the sensor length and enhance the signal magnitude ; second, improving the data acquisition system to intensify the capability of fine defect detection ; at last, adopting digital signal processing technology such as homomorphic filter, wavelet transform and error correction to ensure detecting reliability
本文結合有限元模擬和實驗方法，研究了改進遠場渦流技術性能的幾種方法，即：採用電磁屏蔽、磁路進行傳感器優化設計以縮短探頭長度、增大信號強度；改進信號調理電路以提高細微缺陷檢出能力；利用同態濾波、小波變換以及誤差修正等數字信號處理技術確保檢測結果的可靠性。 -
The basic structure and characteristics of pci bus, and especially, the method of implementation of pci bus interface circuit, are discussed at length in the paper
論文中討論了pci總線的基本結構和特點，對pci總線介面電路的實現方法進行了詳細的論述。 -
When digit signal orbital circuit is adopted in the equipment, which is used to transmit train - to - wayside information and location train position, the length of digital signal orbital circuit should be the minimal measure unit of distance interval between trains
摘要採用數字軌道電路作?車地信息傳輸設備及列車定位設備時，列車之間的安全間隔距離必須以數字軌道電路的長度作?最小計量單位。 -
The research results will lay the foundations for the design and manufacture of the multi - dimensional acousto - electropic - optic device. the thickness of plating layers and the length, width, thickness of piezoelectric transducer are determined, according to transporting line theory of mason ' s equivalent circuit
本文還利用傳輸線的瑪森等效電路理論確定各晶體在其工作模式下各鍍層的厚度及換能器的長度、寬度、厚度；研究結果為多維聲電光器件的設計與製作打下了良好基礎。
分享友人