coated film 中文意思是什麼
-
After digestion at 52℃, for 10 minutes, the emulsion samples are coated at a coverage of 432mg silver per square foot on a cellulose acetate film support.
在52成熟10分鐘后，乳劑樣品塗在每平方英尺432毫克銀的醋酸纖維片基上。 -
The mixture is coated on film base giving silver, coupler and gelatin spreads of 150, 40 and 425 mg/ dry weight respectively.
混合液塗在片基上，其銀，成色劑和明膠塗布的干重量，每平方英尺分別為150，40和425毫克。 -
The mirrors here are coated with a multilayered dielectric film having a reflectance of over 99%.
這兒的反射鏡上鍍了一層多層介質膜，因而反射比超過99%。 -
< uk > the mixture is coated on film base giving silver, coupler and gelatin spreads of 150, 40 and 425 mg / dry weight respectively. < / uk >
< uk >混合液塗在片基上，其銀，成色劑和明膠塗布的干重量，每平方英尺分別為150 ， 40和425毫克。 < / uk > -
Imperfect transmission is the glass or film upon which the emulsion is coated.
塗乳膠的玻璃片或軟片不完全透明。 -
Immediately after an emulsion is coated onto its film or glass base it begins to age.
乳膠塗到軟片或玻璃板上之後老化過程即開始。 -
When an oxidizing plasma is run in a system coated with fluorocarbon film, a substantial quantity of f atoms is released in the plasma.
當氧氣等離子體在覆蓋有氟碳薄膜的系統中起輝時，就會有相當數量的F原子在等離子體中釋放。 -
When only allows the total internal reflection beams focus on the small aperture, which is formed at the center of metal film coated on the bottom of solid immersion lens, the optical fields propagated from the aperture of different dimension is first simulated
根據衍射超分辨原理首次模擬出了底面鍍有金屬膜、中心留有通光微孔的固體浸沒透鏡的出射光場分佈。 -
Copper has been deposited on surface of the al mmcs as interlayer by magnetron sputtering, tlp bonding of al mmcs with these interlays, the joints shear strength of tlp bonding using deposited film was as much as the joint shear strength of tlp bonding using cu foil. removing the oxidation on the surface before deposition, copper was coated by magnetron sputtering as tlp bonding interlayer
待連接表面通過磁控濺射法沉積銅膜作為中間層進行瞬間液相連接，得到的接頭強度與銅箔中間層進行瞬間液相連接得到的接頭強度相當，而使用磁控濺射法去除待連接表面氧化膜后沉積銅膜作為中間層進行瞬間液相連接的接頭強度提高7 . 6左右。 -
Influence of doped cerium on degradation efficiency of oleic acid photocatalyzed by tio2 film coated on glass surface
2薄膜上油酸光催化降解的影響 -
Among various fabrication techniques of thin film, the sol - gel process has gained much interest for the preparation of pzt thin film, due to ihe advantages of good homogeneity, easy control of composition, low in - ill i reaving temperature, easy formation of large area thin films pb ( zrxti : - k ) 0 :, ( pzt ) films were prepared on the ito coated glass plates and low resistor silicon wafer in sol - gel dip - coating process associated wi di heat treatment : at different temperatures and characterized by x - ray diffraction ( xrd ) and transmission electron microscopy ( tem ). lt is shown that the pzt ferroelectric thin films with ( 110 ) preferred orientation and well - crystallized perovskite structure can be obtained after annealing at 680 ? for 30 minutes on ito substrate and at 800 " c for lornin on silicon substrate
Pzt的制備方法有很多，其中溶膠?凝膠（ sol - gel ）方法可以和集成電路（ ic ）光刻工藝相互兼容，處理溫度低，有大面積塗敷性能，能精確地控制組分，無需復雜的真空設備，成本低廉，所以對于集成鐵電薄膜電容的應用這種方法有很廣闊的前景。本文利用sol - gel技術在摻錫的in _ 2o _ 3透明導電薄膜（ ito ）襯底和低阻硅襯底上成功地制備了pzt鐵電薄膜。運用了x射線衍射， sawyer - tower電路和lcr電橋分別對薄膜的晶化溫度，結構和電學性能進行了測試。 -
Because of the restriction of the performances of the infrared materials, we decide that the hollow waveguide should have the structure of single layer dielectric coated metallic film according to the general analysis of process controllability and transmission capability. the dielectric we choose is silver iodide, made from silver and iodine, and the optimum thickness is about 0. 77um
因材料性能的限制，通過傳輸性能以及工藝可控性綜合分析，確定製備的空芯光纖為單層電介質塗覆金屬膜結構，電介質膜定為碘化銀，理論厚度為0 . 77 m左右，由銀膜直接碘化得到。 -
Preparation of film - coated bear bile tablet
熊膽薄膜包衣片的研製 -
The light guiding unit on the surface is composed of sub - micron gratings whose transmission wavelengths are red, green and blue in order. the light source are red 、 green 、 blue led or semiconductor laser array. to enhance the light utilization, the surfaces of light guide plate except the incident and transmitted surfaces are coated with metallic film
本文設計的亞微米光柵型導光板為矩形狀的，導光板上表面的導光單元是由三套出射光主波長分別是紅光632 . 8nm ，綠光521nm ，藍光441 . 6nm的亞微米光柵組成，光源採用的是紅、綠、藍三色發光二級管或者半導體激光器陣列，為了提高光能利用率，除入光面和出光面外，導光板其餘面都鍍上金屬膜。 -
Effect of carbon source concentration on mechanical properties of hfcvd diamond thin film coated tools
碳源濃度對金剛石薄膜塗層刀具性能的影響 -
There was no difference in other biologic characteristic of mscs between the two separation method, such as cell anchorage ratio and clone formation ratio. ( 2 ) plga film presented uniformity frame with no protuberance and fissure under scanning electron microscopy ( sem ). big aperture with smooth wall and average 400 m i n size running - through each other was observed in porous plga substrate, around the big aperture there were many round micropores about 5 m size. all of the structure were equal and uniform, which satisfied the further research work. ( 3 ) mscs adhesion at earlier time was promoted by biotiegenrafter 3h, cell number was ( 1. 5 0. 18 ) 105 in the plga film coated with biotiegen group, which was significantly higher than that in plga film group ( p < 0. 01 ) and higher than that in coverslip group ( p < 0. 05 ), which cell number was ( 1. 04 0. 21 ) 105. after 6h and 12h biotiegen could not promote cell adhesion, and cell proliferation and alkaline phosphatase ( alp ) activity were not promoted dramatically during 9 days. ( 4 ) cell adhesion was promoted by fibronectin or collagen type i
G ） i型膠原、纖維粘連蛋白促進細胞增殖，細胞接種后3 、 6 、 gd三個檢測時間點，實驗組細胞均明顯高於對照組。與1型膠原相比，纖維粘連蛋白刺激作用更強。 ） i型膠原、纖維粘連蛋白尚能誘導mscs細胞向成骨細胞分化，不僅表達成骨細胞標志物ocn 、 alp 、 opnmrna ，而且堿性磷酸酶活性明顯增高，堿性磷酸酶及鈣結節7第四軍醫大學博士學位論文一染色均強陽性， i型膠原組mscs細胞堿性磷酸酶活性較fn組更高，有顯著性差異；同時，兔疫組化染色表明，經纖維粘連蛋白作用的mscs1型膠原表達陽性。 -
Suitable polycrystalline znsxse1 - x film with zinc sulfide cubic structure and ( 111 ) preferred orientation that provided a good matching with the requirements of lclv were deposited on ito coated glass by mbe method. room temperature photo - responsivity measurements performed on these thin films show that
相比于用zns和se為生長源制備的znsxsel x薄膜，採用zns和znse化合物為源材料的實驗方法制備出的薄膜性能更優良，其晶粒尺寸普遍增大，柱狀晶形更完整。 -
Study of adhesion of cvd diamond film coated tool
金剛石塗層刀具切削性能的試驗研究 -
Adhesive coated polyester film for flexible printed circuits
撓性印製電路用塗膠聚酯薄膜 -
Adhesive coated polyimide film for flexible printed circuits
撓性印製電路用塗膠聚酰亞胺薄膜
分享友人