deformation curve 中文意思是什麼
deformation curve
解釋
變形曲線- deformation : 變形,走樣
- curve : n 1 曲線；彎曲；彎曲物。2 曲線規 （＝French curve）；【機械工程】曲線板；【棒球】曲線球；【統計學...
-
Then, by using the great fem programme and the drucker - prager model, the thesis establishes the pile - soil model of super - long piles, analyzes the mechanism of bearing and deformation of super - long piles under vertical loading systemically, studies the characteristics of q - s curve, bottom resistance, pile shaft resistance and critical length of super - long piles in detail, acquires some practical guidance conclusion. secondly, with a practical engineering, the author expatiates the bearing characters of super - long piles farther. the thesis points that super - long piles are frictional piles under the condition of working loading
然後應用大型有限元程序，採用土的drucker - prazer模型，建立了超長樁分析計算的樁土模型，系統分析了超長樁在豎向荷載作用下的承載機理和變形特性，研究了超長樁的荷載?沉降特性，端阻、側阻的發揮性狀以及超長樁的有效樁長，得出了具有實際指導意義的結論。 -
Based on tests of nine 1 / 2 - scaled model slabs under vertical loads, the paper analyzed load - deformation curve and proposed limit value of height - width ratio under axial loads. 2. based on aseismic tests, the paper put forward a model of concrete frame, silica brick and a combination of the two, proposed that the silica brick works as a 45 compression bar, analyzed the factors which may influence bearing capacity of the slab and advised a formula including the numbers of bays and of storeys of the frame
通過對墻板模型的抗震性能試驗研究，建立了由鋼筋混凝土框格、砌塊以及兩者協同作用三個部分組成的承載力極限狀態下的理論簡化計算模型；提出了墻板中填充塊等效斜壓桿寬度按45度計算的統一量化標準；分析了影響墻板承載力的主要影響因素，給出了表達墻板框格層數和跨數不同的斜截面承載力實用設計計算公式。 -
It makes decision on stability state of countryrock according to in - situ surveying datum, and grey prediction model is formed using the deformation curve of country rock. this model can predict latter displacement of country rock. deeper analysis is also been counducted on countermeasure and mechanism of softrock tunnel, and gradation analysis method is applied to select the optimum bracing plan
再結合現場實測資料對地下洞室圍巖的穩定狀態進行判別，利用圍巖變形曲線建立灰色預測模型，採用該模型對圍巖位移的後期變形進行預測。對軟巖隧道的支護對策、支護作用機理進行了較深入的分析研究，並利用層次分析法選擇最優的支護方案。 -
The first stage is primary slip then followed by secondary slip ; the last stage is due to dislocation passing the slips. the cyclic stress strain ( css ) curve exhibits a stronger hardening occurred in cyclic plastic deformation than that in tensile test
建立了拉伸和應變疲勞的有限元模型，使用基於晶體滑移模型的數值方法，對晶體內部滑移系的啟動以及滑移繫上的分解切應變、切應力這些無法試驗觀測的變量進行計算，分析它們對晶體塑性變形的不同影響。 -
Based on the creep experimental curve, the creep deformation law of silty soft clay of the first marine layer and its constitutive relationship among stress - strain - time is studied in this paper
本文在蠕變試驗曲線的基礎上，研究了天津市第一海相層淤泥質粉質粘土的蠕變變形規律，得出應力、應變、時間三者之間的本構關系。 -
By low - cycle and reverse horizontal loading test, their properties including strength property, deformation property and energy property are studied. we study the loading characteristic values ; the property of hysteretic curve and skeleton - frame curves ; the ductility property and stiffness degradation. lastly, based the data got from the test, this paper analyses and value the seismic behavior of every members
在試驗基礎上，研究了軸心受壓構件的承載力計算和穩定問題；研究了低周反復水平加載條件下，彎剪構件和整體空心墻板的強度、變形、能量特性；軸壓構件的荷載特徵值；彎剪構件和整體空心墻板的滯回曲線、骨架曲線、延性等參數；從強度、變形和能耗等方面判別和鑒定各構件的抗震性能，對各個構件給出了試驗的結論、評價。 -
Works on the bending roll system of four - roll rolling mill, the workroll shape variation caused by the force of bending roll and the contact stress between rolls was researched with the fem software ansys, the maximum deformation of the work roll was calculated, and the curve of the gap adopting the least - squares method was fitted, which set the base of the further calculation of load - gap shape
摘要以四輥軋機的彎輥系統為研究對象，利用有限元分析軟體ansys研究彎輥力和輥間接觸應力引起工作輥形狀的變化，計算工作輥彎曲的最大變形量，並用最小二乘法對輥縫曲線進行擬合，為進一步計算有載輥縫形狀提供可靠的理論依據。 -
In order to establish the nonlinear elastic model of qi loess, the hump curve was used to stimulate both the softening stress - strain curve and the volume deformation curve
對軟化型應力應變曲線提出用駝峰曲線模擬，對體變曲線也提出用能反映剪脹的駝峰曲線模擬，建立了q1黃土的非線性彈性k 、 g模型。 -
Based on test result of load - deformation hysteresis curve under cyclic load, fatigue damage variable is defined from energy angle, the change rule of fatigue damage is pointed out
通過對循環加載下裂隙試樣滯回特性和滯回能試驗結果的分析，從能量的角度定義了損傷變量，並指出了疲勞損傷的發展規律。 -
In order to solve this problem, we present a new method in this paper through using the bezier curve as the axial deformation control curve to generate variety trunks and branches
在生成樹的過程中，利用bezier曲線作為頂點控制曲線，採用軸變形方法生成形態各異、效果逼真的樹乾和分枝。 -
Finally, two examples show that, the availability and practicability of the new model is verified. the analysis of calculation result of berthiervill test embackment shows different part of compression curve have different influence upon the course of consolidation, and correct coefficient and viscous effect have great significance on deformation forecast. associated with the wenzhou airport runway engineering, the reason of increasing of pore - water pressuer in under - lying soft layer and post - construction settlement are given
最後，通過兩個工程實例的分析來說明本文模型的有效性和實用性:一是對berthiervill填土試驗場的軟基實測數據和理論成果進行對比分析，闡明考慮結構性擾動和粘滯性效應對分析天然粘土固結壓縮性的重要性;二是對溫州機場袋裝砂井超載預壓工程進行數值模擬，指出停荷預壓期間下臥層孔壓增加和工后沉降大的原因。 -
Using this program, we can estimate ds and draw deformation curve conveniently. moreover, we can estimate the tendency of the curve evolution
應用該程序可方便地預估動穩定度值，獲得車轍試驗變形曲線，進而估計車轍變形發展趨勢。 -
By prolonging the deformation curve, we can estimate the tendency of deformation
通過對車轍試驗變形曲線的拓展，預估車轍試驗變形的發展趨勢。 -
On the basis of the paper, we write a program to estimate ds and draw deformation curve
在本文的基礎上，編制了車轍試驗動穩定度預估和繪制車轍試驗變形曲線的程序。 -
The specimen of the test was stimulated by viscoelastic model and the wheel load was stimulated by special function, which are brought into viscoelastic equation. after solving the equation, we can work out the theoretical answer. thus we can figure out the ds and the deformation curve
本文應用粘彈性理論研究車轍試驗，應用粘彈性模型模擬車轍試驗的試件，擬合車轍試驗的輪載，帶入粘彈性本構方程，獲得理論解，從而獲得車轍試驗的變形曲線和動穩定度值。 -
Through iteration for all incremental steps the ultimate load can finally be found. using the present method the ascending segment of the load - deformation curve can be obtained. considering of the effect of stability and material strength
在理論推導的基礎上，採用visual - fortran語言將該演算法編成程序，給出了具體演算法步驟和程序框圖流程。 -
In the paper, by using bp ( back propagation ) method of ann, we can get the relationship between grading, asphalt - aggregate ratio, bulk density, percentage of voids, test temperature and ds. at the same time, we can get the relationship between grading, asphalt - aggregate ratio, bulk density, percentage of voids, test temperature and viscoelastic parameter. at last, we can estimate the ds and draw the deformation curve
本文應用bp人工神經元網路，建立瀝青混合料的礦料通過百分率、瀝青用量、毛體積密度、空隙率、試驗溫度與瀝青混合料粘彈性參數的關系，或建立瀝青混合料的礦料通過百分率、瀝青用量、毛體積密度、空隙率、試驗溫度與車轍試驗動穩定度值的關系，從而預估車轍試驗的動穩定度值和繪制車轍試驗變形曲線。 -
Study on hyporbolic shear deformation curve of the discontinuous plane in rock mass
巖體不連續面雙曲線剪切位移曲線的研究 -
On basis of experimental analysis, several conclusions can be indicated that : roughness of cement face or structural plane can be described well quantitatively with fractal dimension in paper. roughness increases inner friction angle and cohesive force, and transfers characteristics of shear deformation curve and mechanics and form of shear failure
試驗研究及分析表明，文中方法確定的分維數可以用來較好的定量描述結構面或膠結接觸面的粗糙程度；粗糙度的存在，提高了膠結面的內摩擦角及凝聚力，改變了膠結面剪切變形曲線特徵及剪切破壞機理和形式。 -
The progress of this method can be divided into two steps. one is found the relations of the moment, compression force and the curvature on the base of the balance of the internal force. the other step is to found the relation of the flexibility, corner and the curvature through the elemental deformation curve
該方法的計算過程可分為兩大步驟：第一步根據截面內力平衡條件建立彎矩、壓力和曲率之間的關系；第二步根據構件的變形曲線建立撓度、轉角和曲率之間的關系。
分享友人