density temperature 中文意思是什麼

density temperature 解釋
密度溫度
  • density : n. 1. 稠密；濃厚。2. 【物理學】濃度；密度；比重。3. 愚鈍，昏庸。
  • temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
  1. Environmental-temperature variations contribute to uneven air pressures due to density variations of the air in the bellows.

    環境溫度的變化將引起波紋管內空氣密度的變化，造成氣體壓力不穩定。
  2. Results show that : ( 1 ) for each particle size of andalusite, variation tendency of the properties of the material is generally the same : the maximum of bulk density, compressive strength and rupture strength appears in the range of 5 % - 10 % content of fiber, these properties of the material remarkably decrease as the fiber content exceed 10 % ; while at the same fiber content, the properties of the material increase with the increase of firing temperature

    結果表明： （ 1 ）對于不同粒度的原料，性能變化規律大致相同：在同一燒成溫度下，體積密度、常溫耐壓強度、常溫抗折強度在5 10之間出現峰值，加入量超過10之後材料的性能明顯下降；在相同的纖維含量下，隨著燒成溫度的提高，試樣的各項性能均有所上升。
  3. The high power density asynchronism mater produces loss in movement, which causes the internal temperature of mater rising very high

    摘要高功率密度異步電動機在運行中產生損耗，引起電動機溫升很高。
  4. Amore 2001 has successfully investigated the gakkel ridge and arctic ocean in vicinity of its geological and geophysical nature, as well as the nature of sea ice and biology in this area. the preliminary onboard petrology and bathymetry results show that the mantle beneath the gakkel ridge with low temperature has only encountered very low degree partial melting during the spreading and there is no any direct relationship between the crust nature and the spreading rate along the gakkel ridge in any simple petrologic way. mantle temperature and fracture zone density also play a major role on the crust nature, besides spreading rate

    對所取得資料的初步研究表明gakkel洋中脊之下的地幔僅經受了較低程度的部分熔融，具有較低的溫度。 gakkel洋中脊處的地殼性質和巖漿活動與擴張速率之間不存在任何直接的巖石學相關性，擴張而導致的巖石圈頂部的冷卻並不是決定洋脊處地殼性質的最重要因素。地幔溫度和斷裂帶的存在與否及其密度對地殼性質具有重要的影響意義。
  5. The material was sintered at 1050 for three hours to get the porous artificial bone, that its apparent porosity was54 %, its volume density was 1. 28 g / cm3, and its bending strength was 13. 25mpa. the results showed that the sintering temperature was reduced by adding bioglass

    本研究採用含生物玻璃前驅體粉末原料，添加檸檬酸造孔劑，模壓成型，在1050燒結保溫3小時，獲得了顯氣孔率為54 、體積密度為1 . 28s cm ~ 3 、抗彎強度為13 . 25mpa的多孔hap人工骨材料。
  6. At a definite temperature a mesoscopic circuit isnt in a determinate quantum state instead of in the mixed state ( or statistical state ). using the density matrix of the canonical ensemble, we have deduced the formulate of the quantum fluctuations of both charge and current in a non - dissipative mesoscopic coupled circuit. and the dependences of the quantum fluctuation of the circuit on its temperature have obtained

    在有限溫度下，介觀電路系統實際上並不處在一個確定的量子狀態，而是處在混合態.根據正則系綜的密度矩陣導出耦合互感電路中電荷和電流的量子漲落，得到了量子漲落與溫度的依賴關系
  7. Since a carbon nucleus is six times more positively charged than a hydrogen nucleus, the cno cycle can only operate at the higher temperature and density provided by the more massive stars

    但因碳原子核帶的電荷是氫原子核的六倍碳氮氧循環需要只有質量大星體所能提供的較高溫度和壓力才能維持。
  8. The effects of main process factors such as feeding mode, reaction ph values, and ratio of ammonia and nickel ion, reaction time, agitation, reaction temperature and aging et al on the crystallization course and physical properties of nickel hydroxide were studied in detail. at last, we acquired the optimal preparation parameters, the spherical nickel hydroxide with high tap density and crystalloid degree, perfect flow ability were prepared

    在研究加料方式，氨水的加入量，反應時間、體系ph值、反應溫度、攪拌、陳化等主要工藝條件對ni （ oh ） _ 2結晶過程和物理性能影響的基礎上，確定了較優的工藝參數，制備出了堆積密度和結晶緻密程度較高、流動性較好的球形ni （ oh ） _ 2 。
  9. This dissert aims at developing the high - speed temperature - measuring instrument for the application of high energy density heating

    本課題針對高能量密度加熱過程中高速測溫的需要進行專用測溫儀的研製。
  10. The method of obtaining high concentration of na2feo4 solution by quick electrolysis mainly contains four aspects : adoption of either a diaphragm or an ionic membrane electrolytic cell in which a thin anodic cell lying between the two cathodes, ( 2 ) using an iron anode that has larger specific surface area, ( 3 ) keeping suitable concentration of naoh in the anodic cell, adoption of lower current density and higher electrolyzing speed. the practical technique parameters follow a s below : the naoh solution of 14 - 16mol / l, the temperature of 303 - 308k, the surface anodic current density of 300a / m2, the unit electrolyzing speed of efficiency larger than 6. 0a / l

    快速電解獲取高濃度na _ 2feo _ 4溶液的方法，主要包括四個方面：採用兩陰極室夾一厚度較小的陽極室的隔膜（或離子膜）電解槽；使用比表面積較大的鐵網陽極；保持陽極室中有適宜濃度的濃naoh溶液；採用較低的電流密度和較高的電解速度。具體工藝參數是： 14 16mol / lnaoh溶液、溫度303 308k 、表觀陽極電流密度300a m ~ 2 、有效單位電解速度6 . 0a / l 。
  11. In many lakes in summer that is a warm low - density layer ( epilimnion ) lying above a colder denser layer ( the hypolimnion ), the zone of rapid temperature change between the two layers being celled the thermocline

    夏季，多數湖中溫暖的低密度水層（湖面溫水層）在寒冷的較高密度水層（湖底凈水層）之上，中間夾有溫度改變較快的水層（變溫層） 。
  12. High density low temperature liquids settle to the bottom and remain in the tank for longer periods of time, thereby negating the advantages of equalization.

    密度高，溫度低的廢水沉在底部並在池中停留較長時間，這樣就失去了均衡的效益。
  13. When the alumina fiber accounted for 10 %, the density of the composites was chiefly high and the fiber evulsion effect was reinforced ; when the alumina fiber accounted for 30 %, the fiber evulsion effect, fracture and bridge - connection effect were mainly strengthened, when the fiber proportion was 50 %, at the temperature of 1500 c, the bending strength reached 26. 11 mpa while the compressive strength was 79. 30 mpa

    氧化鋁纖維含量為10和30的試樣增強機理不同，含量為10時，復合材料以基質密實度高、纖維拔出效應增強為主；氧化鋁纖維含量為30時，復合材料以纖維拔出、斷裂、橋聯效應增強為主。當纖維含量為50時，在1500下燒成，其抗折強度達到26 . 11mpa ，耐壓強度達到79 . 30mpa ，該復合材料可用作輕質保溫材料。
  14. 6 the zn3n2 is prepared on focus glass substrate at low temperature. and for the first time, a p - zno with a carrier density of 1017 ? cm - 3 is obtained by thermal zn3n2 in an oxygen ambient

    5 、用等離子體增強的化學汽相沉積的方法制備了zn3n2薄膜，首次通過熱氧化zn3n2的方法，制備出了受主型載流子濃度為1017cm - 3的p - zno薄膜。
  15. With a careful theoretical analysis various physical parameters such as the gas density, temperature, and pressure, and the ultraviolet and ionizing radiation fluxes can be derived.

    通過仔細的理論分析，可以推導出如氣體密度、溫度和壓力等各種物理參量，以及紫外輻射和電離輻射的流量。
  16. Our patented technology enables automatic density / temperature scanning and eliminates long - term drift allowing you to change the temperature and continue measurement without time delay

    我們的專利技術能自動掃描密度/溫度和消除長期漂移，允許在改變溫度后繼續測量，無須延長時間。
  17. Through using the data of numerical simulation by mm5 model, and introducing density temperature, cape ' s calculation accroding to the reversible saturated moist adiabatic process which correspond with the actual atmosphere course more was emphatically discussed. thirdly, based on this, the dcape is introduced farther. dcape has close relationship with convective downdraft and convective storms developme nt. fourthly, the using of hourly model - generated soundings is introduced in this paper

    本文通過對2003年7月4日南京站的大暴雨過程的mm5數值模擬，引入密度溫度t _ ，重點討論了根據大氣可逆飽和濕絕熱過程進行cape的過程。第三步，在cape模式資料實現的基礎上，進一步討論新近提出的與對流風暴發展密切相關的下沉對流有效位能。
  18. True density - temperature correction coefficient

    溫度修正系數
  19. The technological process of trivalent chromium plating and the way of preparing the cheap chromium material were explored. the contribution of the technological parameter, such as current density, temperature, ph values and time to the trivalent chromium plating, was studied. the technological condition, which is suitable to be industrialized, was determined

    通過模擬生產試驗，研究了三價鉻工藝流程，探討了電流密度、溫度、 ph值、電鍍時間等工藝條件對三價鉻成膜性能的影響規律，並確定了適合於工業化生產的工藝條件。
  20. Density temperature coefficient

    密度溫度系數
分享友人
分享到 Line

分享到臉書