force of inertia 中文意思是什麼

force of inertia 解釋
慣性力, 慣性抵抗
  • force : n 1 力,勢。2 體力,氣力,精力,魄力。3 暴力,壓力;兵力,武力。4 〈pl 〉 部隊,軍隊,兵力。5 勢...
  • of : OF =Old French 古法語。
  • inertia : n. 1. 【物理學】慣性,惰性,慣量。2. 不活動,不活潑,遲鈍,惰性。3. 【醫學】無力。adj. -less 無慣性的,無慣量的。
  1. So this base isolation technique has profound prospects. unfortunately there exist definite difficulties in the calculation because of the nonlinear of the base friction force. now, both the equivalent damping method and the numerical calculatin of the vibration response of the base - isolated buildings are frequently used in the calculation of the seismic response of the base - isolated building. however both of them have certain drawbacks. in this paper, the response of the building with base - isolation system is derived by the method of fourier expansion for the friction force and the earthquake response. at the same time, the sliding vibration character of inertia of a single mass structure and the sliding vibration response of a muti - mass structure are discussed. the stable condition of the sliding base isolation system of a structure is given. in the end, two circes of base fixation and base sliding are analyzed by adopting ansys

    本文利用對摩擦力和地震響應進行付氏級數展開的方法導出了基底具有摩擦隔震系統的地震反應。同時,文中從研究單質點結構的滑動振動慣性力入手,進而對多質點結構體系滑動振動反應進行探討,分別給出了結構滑動隔震的自身穩定條件。最後,本文利用ansys對基礎固定和基礎滑移隔震兩種工況進行了動力模擬模擬分析,進一步證實了基礎滑移隔規律。
  2. This article takes the lagrange equation as the principle, establishes mathematics modeling to the inertia brake vibration when it brakes, then simulates it with matlab. this paper educed the relation equations between, which are the inertia brake ' s friction coefficient of the brake ring and the friction disk, the mean radius, the braking force, rotation inertia of the driving top and the spline shaft, spiral climbing angle of the brake ' s concave - convex helicoid, the mean effort radius of the concave - convex helicoid, elasticity coefficient of the spring, quality of the driving top and the spline shaft, rotations inertia of the brake ' s rotation part besides the driving top and the spline shaft, suppresses sleeve. provides the theory basis for the inertia brake structure optimization

    本文以拉格朗日方程為理論基礎,對慣性制動器在制動時的振動進行數學建模,然後用matlab對其進行模擬,得出了慣性制動器在制動時振動角頻率分別與制動環和摩擦片之間的摩擦系數、制動力的平均半徑、主動頂和花鍵軸的轉動慣量、慣性制動器的凹凸螺旋面的螺旋升角、凹凸螺旋面平均作用力的半徑、彈簧的彈性系數、主動頂和花鍵軸的質量、慣性制動器除主動頂和花鍵軸外其他部分的轉動慣量和、頂壓套的質量等慣性制動器各零部件的物理參數之間的關系,為慣性制動器的結構優化提供了理論依據。
  3. The issue of inertia force in engineering hydraulics and hydrodynamics

    工科水力學和流體力學中慣性力的問題
  4. The newton the first laws finger object is had the character keeping original motion state, the inertia theorem is also called : under the circumstances of not accepting an outside force or being accepted an outside force by zero, the object always keeps uniform motion or motionless

    牛頓第一定律指物體具有保持原來運動狀態的性質,也被稱為慣性定理:在不受外力或所受外力為零的狀態下,物體總保持勻速運動或靜止。
  5. 2. dynamics analysis : by setting up jacon matrix differential coefficient sport is passed to descartes space. it makes terminal executing manipulator produce differential coefficient of acceleration and force in every different coordinates can be got. then the effective inertia, coincident inertia and gravity load of two manipulators are calculated by lagrange method. so generalized joint torque of each joint is got, and along with equivalent driving torque, actual driving torque of each joint can be worked out. 3

    動力學分析:建立雅可比矩陣將關節空間的各關節的微分運動傳遞到笛卡爾空間,使末端執行器位姿產生微分運動,以用於求加速度及力在不同坐標系間的線性變換,再用拉格朗日法計算兩機械手的有效慣量、偶合慣量、重力載荷,從而計算得到各關節的廣義關節力矩,並與等效驅動力矩共同算得各關節的驅動力矩。
  6. On understanding of inertia force

    對慣性力的認識
  7. The bridge not only resists the static loads but also the moving loads and the actions of vibrational inertia force of vehicle and bridge

    這時,橋梁結構不僅承受靜力的作用,還要承受移動荷載以及橋梁和車輛的振動慣性力的作用。
  8. After thoroughly studying the mem process, the frequency range of inertia force, which is caused by the scanning movement of extrusion head, has been found

    本文在深入分析mem工藝過程之後,找出噴頭掃描運動產生的慣性力的頻率范圍。
  9. By comparing with the present mechanism designed for the elimination of inertia force, this kind of mechanism is smaller in volume, lighter in weight and possessing good result in eliminating vibration

    與現有的為消除慣性力而設計的機構相比,這種機構的體積小、質量輕,消振效果較好。
  10. The platform can analog rolling and swaying motion of ships. the moment of inertia, damping and restoring force can be adjusted

    該試驗臺架能夠模擬船舶的橫搖運動和橫蕩運動,試驗臺架的轉動慣量、阻尼力矩和恢復力矩可調。
  11. The moment of inertia, damp and comeback can be adjusted. two electro - hydraulic servo systems analog rolling moment and swaying force of wave respectively. the two systems both use electro - hydraulic servo valves, in which the analog rolling moment system adopts gear - rack swing hydraulic - pressure oil vat with torque sensor, while the analog swaying force system employs double shanks hydraulic - pressure oil vat with two pressure sensors and a placement sensor

    兩套電液伺服系統均使用流量電液伺服閥(採用外供油方式) ,其中模擬橫搖力矩的伺服系統採用齒輪齒條擺動液壓油缸,配有扭矩傳感器,模擬橫蕩力的伺服系統採用雙出桿液壓油缸,配有兩個壓力傳感器和一個位移傳感器。
  12. Reagarding the inertia force of rotor as the force acting on the shaft, the effect of thermal expansion upon the natural transversal vibration frequencies of rotor system is studied by a new nonlinear asymptotic method

    摘要把轉子的慣性力看成作用在軸上的外力,採用新的非線性漸近法研究熱膨脹對轉子系統固有橫振頻率的影響。
  13. After plenty of practices, it is discovered that the main factor that lowers the part precision and accelerates the aging of parts is the vibration caused by the inertia force of extrusion head in high speed scanning movement

    作者通過大量的mem工藝實踐發現,噴頭做高速掃描運動時產生的慣性力對機架的沖擊及相應引起的劇烈振動是降低造型精度、加速設備老化的主要因素。
  14. Secondly, it was impossible, because to paralyse the force of inertia with which napoleons army was rebounding back along its track, incomparably greater forces were needed than those the russians had at their command

    第二,之所以不可能還因為,拿破崙軍隊不要命的狂逃有一股巨大的慣性力,要阻擋住,使其癱瘓,這就必須要有比現有的俄軍數量多得多的軍隊。
  15. In the dynamic equation both the viscoelasticity properties of belt, the run resistance, the inertia force of take - up, the belt ' s elastic modulus influented by the deflection of belt and the initial stress have been considered

    所建立模型的動力學方程不僅考慮了輸送帶的粘彈性力學性質、運行阻力、張緊裝置的慣性力和輸送帶撓度變化下的彈性模量,同時也考慮了輸送帶初始張力的影響。
  16. In order to decreasing hydraulic impact, the principle is analyzed to eliminate or increase hydraulic impact by means of changing eccentric lump structure to cut down the inertia force of starting, changing the pressure of pilot electromagnetic relief valve and changing the parameters of accumulator

    為了減小液壓沖擊,本文分析了用改變偏心塊結構減小起振慣性力的方式、用改變先導式電磁溢流閥溢流壓力方式和改變蓄能器參數方式消除或減小液壓沖擊的原理。
  17. This article has studied the definite integral used in the physics application from power, force, moment of inertia, orthocenter of plane figure and calculation of inertia moment, mainly utilizing the research method from particulars to generals

    本文從功、力、轉動慣量、平面圖形的形心和慣性矩的計算這幾個方面研究了定積分在物理學中的應用,主要運用了從特殊推廣到一般的研究方法。
  18. The software package have some functions as follows : calculating the shrapnel ' s diagnostic parameters such as the mass and the pole moment of inertia, the inner and outer ballistic characteristic, the aerodynamic force and power, and so on

    該榴彈cad軟體具有以下一些功能模塊:計算彈丸質量、極轉動慣量等構造特徵數,計算內、外彈道特性,計算氣動力,威力等。
  19. This article guarded against explosions the heater to skid the block comprehensive support the structure to carry on the analysis ; found the question which this support structural design exists and has made the corresponding improvement design ; caused to synthesize the support the structure while to satisfy the intensity and rigidity reduced the whole weight ; tends to the optimized design in the material use ; through to synthesizes the support the finite element model to exert the different force of inertia ; obtains under the different load to synthesize the support stress variation rule, thus determine bearing capacity of comprehensive support

    摘要本文對防爆加熱器撬塊綜合支架的結構進行了分析,找到該支架結構設計上存在的問題並作了相應的改進設計,使得綜合支架的結構在滿足強度和剛度的同時減輕了整體的重量,在材料的利用上趨于優化的設計;通過對綜合支架的有限元模型施加不同的慣性力,得出不同載荷下綜合支架應力變化規律,從而確定出綜合支架所能承受的最大慣性力。
  20. After comparing the inherent frequency with the frequency of inertia force, the basic source of violent vibration of mem systems was found and corresponding criterion of anti - vibration structure design was formulated

    通過比較系統的固有頻率與噴頭掃描的慣性激振力頻率,找出mem工藝設備劇烈振動的根本原因並得到相應的抗振設計準則。
分享友人