frictional sliding 中文意思是什麼

frictional sliding 解釋
摩擦滑動
  • frictional : n. 摩擦的,由摩擦而生的。adv. -ly
  • sliding : adj. 滑動的;易變的,不穩定的。n. 滑動。
  1. The cataclastic rocks appeared in the fault zone include structural lenticles, fault breccias, protocataclasite and cataclasite. the microscopical cataclastic deformation mechanisms involved are microcracking, frictional sliding and pressure - solution, but there might have had ductile deformation relating to dislocation sliding in feldspar and quartz of the plutons

    斷裂帶內碎裂巖系列構造巖主要是碎裂化巖石(包括構造透鏡體和構造角礫巖) 、初碎裂巖和碎裂巖,顯微變形機制主要有破裂作用、摩擦滑動和壓溶作用。
  2. For sliding contact, the coefficient of kinetic friction uk is defined as the ratio of the frictional force to the normal force.

    滑動接觸時,動摩擦系數Uk的定義是摩擦力與法向力的比率。
  3. For sliding contact, the coefficient of kinetic friction uk is defined as the ratio of the frictional force to the normal force

    滑動接觸時,動摩擦系數uk的定義是摩擦力與法向力的比率。
  4. With observing the topography of different time period by afm, the formation mechanism of five stages of ots molecular film was concluded. 4. tribological characteristics of ots self - assembled molecular film were studied by lfm. the effects of sliding velocity and load on frictional force were analyzed

    在研究過程中,通過原子力顯微鏡( afm )觀察不同成膜時間及不同溶劑組成條件下的ots自組裝分子膜的形貌,由此來判斷反應進程,總結出ots自組裝分子膜生長模式的五個階段。
  5. Comments on anti sliding calculation of multi rope frictional hoist

    淺談多繩摩擦提升機配置恆力矩液壓站緊急制動提升系統防滑驗算
  6. The fem results indicated that as to the rough surfaces in sliding contact, the value of the contact pressure was very high which coursed a high value of the heat flow rate, meanwhile the sliding time was not enough for the frictional heat to transfer, thus the highest value of the body temperature occurred just on the sliding surfaces, which possessed a sharp thermal gradient in direction perpendicular to the sliding surface. so the great thermal stress was caused just by the sharp gradient and the thermal elastic distortion with which the contact pressure changed occurred simultaneously, thus this change of the contact pressure would affect the temperature distribution in return

    對于相對滑動的粗糙表面,因實際接觸面積小而導致接觸壓力很大,這樣使得熱流密度會很大,同時由於滑動時間很短,熱來不及傳導,最高溫度發生在摩擦表面,在垂直於摩擦面的方向有很大的溫度梯度,使得熱應力很大,且最大應力發生在表面,同時產生熱彈性變形,這種變形使得接觸區域內的壓力分佈發生變化,這種變化又反過來影響了接觸區域的溫度分佈。
  7. On the basis of utilizing geometric conversion and modification principle of spur and helical gears, the mathematical model for geometric parameters and modification of overlapping coefficients of gear was established, and the calculation method of sliding frictional coefficients under elasto - hydrodynamic lubrication state was introduced, thus let the calculation method of meshing efficiency of gears be more coinciding with the practical application

    在運用直、斜齒輪幾何換算和變位原理的基礎上,建立齒輪的幾何參數和重迭系數修正的數學模型,介紹了彈流潤清狀態滑動摩擦因數的計算方法,從而使齒輪嚙合效率計算方法與實際應用更吻合。
  8. It is found that cyclic loading at high differential stress level will lead to the decrease of felicity ratio, and the value max can be decreased by some crack systems in specimen. there is still a lot of ae during unloading at high differential stress level, which implies that the deformation is dominated by fracturing at low differential stress level, and the deformation by frictional sliding increases greatly at high differential stress level

    關于應力方式對巖石破裂的影響,發現較高差應力水平下的多次循環加卸載會使felicity比減小;某些構造能使巖石產生felicity效應的應力門檻值_ ( max )降低;由高差應力水平下卸載時仍有大量聲發射產生推測:在低差應力水平下,破裂以裂紋尖端的突然擴展為主;在高差應力水平下,沿已有的裂紋面的滑動破裂大量增加。
  9. The effect of the variation of temperature and contact pressure of the sliding contact surfaces with frictional heating on each other, particularly the relationship of the applied pressure and the contact pressure and the effect of the separate variation of some parameters on the simulation results were taken account into in the course of numerical simulation

    在數值計算過程中,著重考慮了溫度變化與接觸區域壓力變化的耦合問題,接觸壓力與外加壓力的關系,以及分別改變一些參數對結果的影響。
  10. Testing study on frictional characteristic of large - scale and high - speed landslide during sliding

    大型高速滑坡滑動過程中摩擦特性的試驗研究
  11. Based on g - w contact model, two rough surfaces in contact were simplified to a smooth one and a rough one which has regular rectangular asperities, and a three - dimensional transient thermal and stress coupled fem model was established using thermal - structure sequential coupling. the course of the sliding with friction was simulated using the nonlinear multiphysics field fem, meanwhile considering thermal - elastic problems of the two bodies, to calculate and analyze the temperature, contact pressure and stress of the sliding contact surfaces with frictional heating

    基於g - w接觸模型,將兩個粗糙表面簡化為一個有規則排列的長方體微凸體的粗糙表面與一光滑表面,利用熱結構順序耦合建立三維瞬態有限元計算模型,考慮兩個物體摩擦接觸的熱彈性問題,採用非線性有限元多物理場來實現,對粗糙表面接觸模型的瞬時摩擦溫度場、壓力場和應力場進行了計算分析。
  12. Testing methods for sliding frictional melting of woven and knitted fabrics

    機織品和針織品滑動摩擦熔化抗性的測試方法
分享友人