high-tensile alloy 中文意思是什麼

high-tensile alloy 解釋
高強合金
  • high : adj 1 高的〈指物，形容人的身高用 tall〉；高處的；高地的。2 高級的，高等的，高位的，重要的。3 高尚...
  • tensile : adj 張力[拉力]的；抗張的；能伸長的。 tensile force 【物理學】張力。 tensile strain 【物理學】張應...
  • alloy : n 1 合金。2 （合金中的）劣等金屬。3 （金銀的）成色，成份。4 〈比喻〉攙雜品。vt 1 合鑄，熔合（金屬...
  1. And due to the heat expansile coefficient of the stainless steel rather high, the connecting force between the stainless steel pipe and the pipe coupling in the room temperature is much less than that between the titanium alloy pipe and the pipe coupling. the results accord with the tensile experiments well. finally, the dependence of dimensions of the coupling on the strength of the connector system is analyzed

    模型計算還表明，被接管材料和管接頭材料之間的熱膨脹系數的差異會造成管接頭系統的室溫強度低於高溫強度；由於不銹鋼的熱膨脹系數較大，使得室溫下1不銹鋼管與n立tinb形狀記憶合金管接頭間的抱緊力遠小於鈦合金管與nitinb形狀記憶合金管接頭間的抱緊力，成功地解釋了拉脫實驗中的結果。
  2. Specification for hot rolled and hot rolled and processed high tensile alloy steel bars for the prestressing of concrete

    混凝土預加應力用熱軋和熱軋並處理的高抗拉強度的合金鋼筋規范
  3. High tensile strength carbon steel castings and low alloy steel castings for structural purposes

    結構用高抗拉強度碳素鋼及低合金鋼鑄件
  4. Low - alloy high - tensile structural steel

    低合金高強度結構鋼
  5. Quite notable { 11 22 } twins with the appearance of strip piercing through lamellar colony were found in the tensile microstructure of ct20a alloy by tem analyzing, while no deformation twinning was found in the microstructure of alloy with high oeq

    Ct20a合金低氧當量拉伸試樣的tem組織中有相當數量的{ 11幾}型孿晶存在，孿晶在形貌上表現為穿過幾個片的細條。高氧當量試樣中沒有觀察到變形孿晶的存在。
  6. The relationship of true stress and true strain for the mid - strength weldable 1420 aluminum - lithium alloy has been investigated in this thesis by high temperature compression testing and high temperature tensile testing on different hot deformation conditions. the interdependence of flow stress, strain rate, strain and deformation temperature for the alloy at high temperature has been studied

    本文通過高溫壓縮和高溫拉伸試驗，研究了中強可焊1420鋁鋰合金熱變形時不同變形條件下的應力-應變關系、變形條件對合金流變應力的影響；運用多元回歸分析方法，採用c語言編程確定了合金的本構關系方程；引入z參數，求解了部分材料常數，並用於材料的組織性能研究中。
  7. 2. the room temperature tensile strength of alloy made by mlsd relate to the extrusion temperature and the extrusion reduction ratio, with high temperature and reduction ratio, the tensile strength becomes low

    二、多層噴射沉積過共晶a1 - si合金的室溫強度與擠壓溫度和擠壓比有關，擠壓溫度越高，合金的強度會降低。
  8. Results show that the high aluminum zinc base alloy za27 alloyed by si has an overall higher hardness and tensile strength ; mn can improve alloy ' s hardness and at the same time reduce the elongation. when the content of mn is 1. 5wt. %, the hardness of the alloy is the highest but the elongation lowest

    試驗結果表明，加si的高鋁鋅基合金za27總體上硬度、抗拉強度均較高； mn的加入有助於za27合金硬度的提高，加1 . 5 mn時合金硬度最高；試驗條件下， mn的加入量超過0 . 8時，其延伸率下降，在1 . 5時達到最低值。
  9. High strength : the company utilizes quality raw materials and multi - element copper alloy to produce electrodes. advanced chemical composition and optimized tensile strength

    強度高:本公司生產電極絲選用優質原材料和微量多元素銅合金.採用先進的設備和連續生產工藝， 24小時爐前跟蹤化驗，從而保證化學成份的穩定和最佳的抗拉強度
分享友人
分享到 Line

分享到臉書