ignition equipment 中文意思是什麼

ignition equipment 解釋
點火設備
  • ignition : n. 1. 點火，著火，燃燒；【化學】灼熱。2. 【機械工程】發火裝置。
  • equipment : n. 1. 〈常 pl. 〉設備，裝備，配件，配備物品。2. （一個企業除房地產以外的）固定資產。3. （工作必需的）知識，技能，修養。4. （火車）車輛；（汽車等）運輸配備。
  1. Standard for safety for explosion - proof and dust - ignition - proof electrical equipment for use in hazardous classified locations

    危險場所用防爆和防燃塵電氣設備的安全標準
  2. Non - electrical equipment for use in potentially explosive atmospheres - part 6 : protection by control of ignition source ' b '

    潛在爆炸性環境中使用的非電氣設備.第6部分:著火源控制" b "型防護設備
  3. Absorb spill with dry sand, then place into a chemical waste container. remove allsources of ignition. use a spark - proof and explosion proof tool and equipment

    用干沙吸收，然後放入化學肥料容器，遠離火源，使用防電火花和防爆工具。
  4. Road vehicles. diagnostic systems. equipment for ignition systems testing

    道路車輛.報警系統.點火系統檢驗設備
  5. The technology process : the waste, through operation stand, to be rationed into the standing majorcombustion room, being ignited by the ignition - burningmachine, upon the principal of burningthree t, fully burned in the major combustion room （ 800 - 1000 ). the remaining waste gas afterburning via flue goes into secondary combustion room for further high temperature oxidizingcombustion. the gas flow after the secondary combustion goes into the highly effective cyclonedust remover, removing the bigger granule of dust, flowing into rapid - cooling spay and washing equipment to absorb acid gas

    廢棄物經操作臺連續定量投入立式爐本全燃燒室，由點火文空燃燒機自動點火，根據三t原則在爐本體燃燒室（ 800 - 1000 ）以充分燃燒，焚燒后產生的殘余廢氣經煙道進入二次燃燒室再經高溫（ 1100 - 1200 ）氧化焚燒，經二次焚燒后的氣體進入高效旋風除塵器，除去顆粒較大的粉塵后，進入急冷塔噴淋洗滌裝置吸收酸性氣體。
  6. Non - electrical equipment for use in potentially explosive atmospheres - part 6 : protection by control of ignition source " b " ; german version en 13463 - 6 : 2005

    潛在爆炸性環境中使用的非電氣設備.第6部分:著火源控
  7. Because it is very expensive to import motorcycle magneto on - line test system, and china ' s equipment quality and technology level ca n ' t meet the request of modern production quality control and administration, it is practically important to develop an advanced on - line test equipment of motorcycle magneto ignition system on modern measure and control technology with a low cost and a suitable national condition

    摩托車磁電機在線檢測設備進口價格昂貴，而目前國內設備質量和技術水平又不能充分滿足日益增長的產品質量控制和管理要求，因此應用現代測控技術研究開發功能先進而成本較低、適合我國國情的摩托車磁電機點火系統在線檢測設備具有重要的現實意義。
  8. As a result of the international advanced technology and detection means so that the test - bed habitat leading domestic level, can be quickly and easily, and visual on the domestic and import cars ignition system, the charge of the starting circuit, speakers circuit, lighting system, signal lines, electronic ignition components such as testing, inspection and adjustment, can also check the work of a car engine, engine fault diagnosis of the reason that test bed is the experimental large automobile repair shop, the second category repair shop and car essential for the use of the transport sector detection equipment, by all parts of the country auto repair trade management departments welcomed

    由於採用了國際上先進的技術和檢測手段，使本實驗臺居國內領先水平，可以快速方便，直觀的對國產、進口車的點火系、充電系起動電路、喇叭電路、燈光系、信號線路、電子點火組件等進行試驗、檢查和調整，還可以檢查汽車發動機的工作情況，診斷發動機故障的原因，所以本實驗臺是汽車大修廠、二類修理廠和汽車使用運輸部門必不可少的檢測儀器，深受全國各地汽車修理行業管理部門的歡迎。
  9. The two - dimensional axisymmetric subsonic - transonic - supersonic flow in an experimental arcjet thruster is simulated numerically using flux vector splitting method. the profiles of density, velocity, temperature, pressure and mach number can be obtained by the computation. the computation grid and some computed results are given here. the test equipment such as power supply system, ignition system, propellant supply system, arcjet thruster, thrust measuring device and vacuum system are introduced briefly. some working phenomena of the arcjet are observed and discussed. three different kinds of instability appeared in the process of the experiments. except some important parameters are measured, it is found that the operating stability of argon is better than that of nitrogen

    對一實驗電弧加熱式發動機二維軸對稱亞跨超音速流動進行了數值模擬，所採用的方法是矢通量分裂演算法.通過計算可以得出密度、速度、溫度、壓力和馬赫數的分佈.給出了計算所使用的網格和一些計算結果.簡要介紹了實驗所使用的設備，如電源系統、點火系統、推進劑供給系統、電弧加熱式發動機、推力測量裝置和真空系統.對所觀察到的一些工作現象進行了討論.有三種不同的不穩定性出現于實驗過程.除了所測量的一些重要參數，通過實驗發現氬比氮工作更穩定
  10. In the control system of engine, the control of electronic control ignition equipment to the engine ignition consists of the following 3 parts : advanced ignition angle, conduction time and detonation. the control principle, control ways, control methods and control circuits are introduced in this paper

    面對競爭激烈的汽車市場，如何在競爭中脫穎而出，不僅要靠品牌與實力，更重要的還在於管理創新.採用項目化管理技術對汽車製造系統集成管理進行創新，會使汽車製造系統的集成管理更趨科學
  11. Non - electrical equipment for potentially explosive atmospheres - protection by control of ignition source " b

    潛在爆炸性環境中使用的非電氣設備.火源控制" b "型防護設備
  12. The equipment placed in the hazardous area contains only intrinsically safe circuits. a circuit is intrinsically safe if no sparks of thermal effects occur under establishedtest conditions ( including the normal operating and certain fault conditions ), which could lead to the ignition of a given explosive atmosphere

    設備內部的電路在規定的條件下，正常工作或規定的故障狀態下產生的電火花和熱效應均不能點燃爆炸性混合物。
  13. The test equipment such as power supply system, ignition system, propellant supply system, arcjet thruster, thrust measuring device and vacuum system are introduced briefly

    簡要介紹了實驗所使用的設備，如電源系統、點火系統、推進劑供給系統、電弧加熱式發動機、推力測量裝置和真空系統。
分享友人
分享到 Line

分享到臉書