in-situ permeability 中文意思是什麼

in-situ permeability 解釋
現場滲透度
  • in : adv 1 朝里，向內，在內。 A coat with a furry side in有皮裡子的外衣。 Come in please 請進來。 The ...
  • situ : 西楚
  • permeability : n. 1. 透過性，可透性，滲透性；滲蝕度；【航空】（氣球氣體的）透出量。2. 【物理學】磁導率，磁導系數（＝magnetic permeability）。
  1. Based on laboratory and in - situ tests, the influence of initial void on the rutting - resistance, moisture damage - resistance, strength and permeability of asphalt mixt is studied, and the appropriate ranges of air void of asphalt mixtures are analyzed and suggested

    摘要在室內試驗和現場測試的基礎上，分析初始空隙率大小對瀝青混合料抗車轍能力、水穩定性、強度和滲透性能的影響，探討瀝青混合料空隙率的界限值。
  2. Using the rock resistivity meter with simulating in - situ conditions, the relations between rock resistivity and temperature were observed from 6 sandstone samples with different porosity and permeability, while samples were brine water - saturated and subjected to certain confining pressure. it is found that the resistivities of water - saturated rock samples decrease in the form of power expression with the temperature increase. although the resistivity of brine water decreases with temperature in the same rule, it can not entirely account for the decreasing of rock resistivity. the cementation factor

    利用模擬地層條件巖芯電阻率測量儀，對6塊孔隙度滲透率各不相同的砂巖巖芯，在一定圍壓條件下，巖芯完全飽和鹽水時，考察了巖芯電阻率隨溫度的變化。發現飽和鹽水巖芯的電阻率隨溫度升高，以冪函數形式下降。雖然巖芯中飽和鹽水的電阻率同樣隨溫度以冪函數形式下降，但巖芯電阻率的下降不能完全用巖芯飽和鹽水的下降表徵。
  3. Abstract : combined with fundamental characteristics of in - situ leaching mining, this paper presents primary factors influencing the reation rates, such as lixivant concentration, oxidizer, porosity, permeability, seepage volocity, structure of ore, minerals of competition, etc. the factors which influence the reaction rates of in - situ leaching have been discussed

    文摘:結合原地浸出工藝的特點，總結提出了影響原地浸出反應速率的主要因素，並就溶浸劑濃度、氧化劑、孔隙度、滲透系數、滲透速度，礦石的結構、構造及礦物的嵌布特徵，競爭礦物等對原地浸出反應的影響進行了分析與討論。
  4. Standard test method for determining transmissivity and storage coefficient of low - permeability rocks by in situ measurements using the constant head injection test

    用恆定水頭噴射試驗現場測定低滲透性巖石的透過比和釋水系數的標準試驗方法
  5. Based on a thorough investigation of the engineering geological condition for the reservoir region of the huizhou pumped storage power station, the in - situ trial pit water injection test, boring water injection test, and water pressure test were performed to study the permeability of rock and soil mass

    摘要在對惠州抽水蓄能電站庫區工程地質條件進行詳細調查的基礎上，採用現場試坑注水和鉆孔注水、壓水試驗等方法了解巖土體的透水性。
  6. The surface of natural fracture ( crack ) is parallel to the orientation of maximum principal stress. the principle orientation of anisotropic permeability reservoirs agrees with the orientation of the maximum principle stress. many engineering problems ( e. g. bore - hole stability, casing deformation failure during drilling, reasonable arrangement of wells, the optimum design of hydraulic fracture and so on ) are influenced by the in - situ stress orientation

    天然裂縫面和裂隙面與最大主應力方向平行；在各向異性低滲透率油田中主滲透率方向與最大水平主應力方向趨向一致：在鉆井過程中井壁穩定性，套管變形和損壞，油田開發井網合理布置、水力壓裂優化設計等都與地應力方向有關。
  7. The hydraulic fracturing technology has been developed into a reliable and practical method to determine the in - situ stress slate of underground caverns, self - bearing capability of wall rock of high - pressure cavern and the high - pressure hydraulic permeability of rock mass, which has been widely used in the disposal of nuclear waste, the long and deeply - buried communication tunnels and the high - pressure caverns of hydraulic power plant

    摘要水壓致裂技術現已發展成為確定地下洞室二維原地應力狀態、高壓洞室圍巖的自身承載能力以及巖體高壓透水性的可靠實用方法，並已經在核廢料處置、長大深埋交通隧道以及水電站高壓力洞室工程中得到廣泛應用。
  8. The indoors experimental results show the influence of soil density, moisture, permeability and restrain on the frozen - heave forces. from year ' s observation in - situ, the field data supports the relationship of foundation area, embedded depth and superimposed load with normal frozen - heave force

    通過野外現場的試驗的觀測，初步掌握了基礎法向凍脹力與基礎面積、基礎埋深、附加荷載等因素之間的關系以及平板基礎所受凍脹上抬力各組成部分之間的相互影響規律。
  9. Polydispersed a - fe nanoparticles have been obtained by using bi - amine terminated polyurethane flexible macromolecule as a surfactant, and on the basis of them, the epoxy - iron nanocomposite particles have been synthesized by in situ polymerization compositing technology. the real parts of both the permittivity and the permeability of the nanocomposite decrease firstly and then increse with increasing dose of surfactant. the composite particles have ideal comprehensive properties at the dosage of the sufactactant of 0. 5 g, and its frequency dispersion exceeds that of traditional micrometer carbonyl iron powders

    以雙端氨基柔性大分子為表面活性劑制備了多分散的- fe粒子，並在此基礎上以原位聚合復合法制備了環氧樹脂-鐵納米復合粒子，發現隨表面活性劑用量增加，復合粒子介電常數實部和磁導率先降低后增加，在表面活性劑用量為0 . 5g時復合粒子有較好的綜合性能，頻散特性優于傳統微米羰基鐵吸收劑。
  10. Standard test method for determining transmissivity and storativity of low permeability rocks by in situ measurements using pressure pulse technique

    用壓力脈沖技術現場測量低滲透性巖石的透射率和釋水系數的標準試驗方法
  11. In situ permeability

    現場滲透度
  12. In - situ permeability

    現場滲透度
  13. Theories for in - situ testing of pore pressure and permeability by ifco bat system and its applications

    系統測試地基孔壓及原位滲透系數
分享友人
分享到 Line

分享到臉書